Harbor Freight Tools Saw 41146 User Manual

ITEM 41146 8” BolT CuTTEr  
ADJuSTMENT INSTruCTIoNS  
1. The jaws are properly adjusted if when held in a closed position,  
there is a parallel gap between the cutting edges.  
2. To adjust the gap, back off the jaw adjustment screw lock nut.  
Back off the screw until its head rests on the stopper on the  
opposite handle. Back off the screw 1/6th of a turn at a time and  
hold tool to the light, observing result of gap setting.  
3. To verify the gap, place a sheet of paper between the jaws and  
fully close the handles. The jaws should hold the paper in place.  
Hold the screw in place and tighten the lock nut. Do NoT oVEr  
TIGHTEN the nut.  
WArNING  
To prevent serious injury:  
1.Wear ANSI-approved safety goggles during use.  
2.Never use on live electrical circuits.  
3.Keep fingers clear of sharp blades.  
4.Keep out of children’s reach.  
Distributed exclusively by Harbor Freight Tools®.  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Visit our website at: http://www.harborfreight.com  
read this material before using this product.  
Failure to do so can result in serious injury.  
SAVE THESE INSTruCTIoNS.  
Copyright© 2009 by Harbor Freight Tools®. All rights reserved. No portion of  
this manual or any artwork contained herein may be reproduced in any shape  
or form without the express written consent of Harbor Freight Tools.  
For technical questions or replacement parts, please call 1-800-444-3353.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Graco Heat Pump 310643u User Manual
Greenheck Fan Ventilation Hood UL 762 User Manual
Haier Freezer DW 40L626 User Manual
Haier Washer HWM90 98 User Manual
Hamilton Beach Water System SA HB 40 DB CERT User Manual
Harbor Freight Tools Utility Trailer 90154 User Manual
Honeywell Fan HF910 User Manual
Honeywell Marine Instruments YP7999A1000 User Manual
Hotpoint Refrigerator CTX18GACAA User Manual
HP Hewlett Packard Power Supply H5M59A User Manual