SMALL SIT OR STAND WALKER
WITH HAND BRAKE
92987
ASSEMBLY & OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions and replacement parts please call 1-800-444-3353.
Download from Www.Somanuals.com. All Manuals Search And Download.
11. Do not allow children to play with, stand upon or climb on the Walker.
12. Always check hardware and assembled parts after assembling. All connections should be
tight and hardware tightened.
SPECIAL WARNINGS FOR THIS PRODUCT
1. Before use, make certain your Walker is fully opened, the seat is down completely, and
the folding bar beneath the seat is in the locked position.
2. Check that both handles are at equal heights. If one is lower than the other, adjust
accordingly. Apply gentle pressure to the Handles to test the stability of the Walker before use.
3. Test brakes thoroughly before use. The brake bar on the wheels will prevent the wheels from
rolling when the brake is set in the locked position. If the wheels turn while the brakes are
locked, have the brakes adjusted by an authorized technician. Under no circumstances should
you use this product if the brakes do not lock properly.
4. Always put brakes in the locked position before sitting on the seat. Do not sit on the seat
unless you are on even, level ground.
5. Check tires periodically and replace when worn.
6. This product is not a cart or a wheel chair. Do not use it to push or carry people or objects
(except for objects in the basket). Do not load more than 25 Lbs. in the basket.
7. Do not exceed the maximum load capacity of 250 Lbs.
Warning:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking your Walker, check to make sure that all of the parts listed on page 5 are included.
If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.
Assembly
Your Walker will require minor assembly before use. It is important that you read the entire manual
to become familiar with the product BEFORE you use the Walker. Before using the Walker, check to
make sure that the product is intact, undamaged and working properly.
Handles
If not already in place, set one Collar (21) securely onto each side of the Front Frame (20). Insert
the Handle (10) down into the Front Frame (20). Loosen the Knob (22) and insert the Handle (10)
down through the Collar (21) on each side of the Handle (10)-see Figure 1. Repeat these assembly
steps for the other Handle (10).
Attaching the Back rest Bar (6)
1.
Insert both ends of the Backrest Bar (6) with Foam Tubing (7) down into the fitting located at
the front of the Front Frame (20)-see Figure 2. To do so you must pull out the Pin located on
the front of the fitting. While pulling up on the Pin, insert the Bolt (8) located on the Backrest
Bar (6) down into the fitting. Release the Pin-see Figure 2.
SKU 92987
For technical questions please call 1-800-444-3353.
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
2.
Pull up on the Backrest Bar (6) to make certain that it is securely locked into place.
Attaching the Basket (9)
Hang the Basket (9) from the bar located direclty beneath the Plastic Seat (1) and rest the fitted
bottom of the Basket (9) onto the bar at the bottom of the Walker.
Once the Walker is completely assembled, test it to make certain that it folds and unfolds
properly, that the wheels roll, and that the brakes work. Make certain that it is stable and that
all hardware is securely tightened.
Operation
1.
To slow down or stop temporarily, squeeze the Handgrip (3) and the Brake Loop (2) together
firmly.
Figure 2
Figure 1
Handle (10)
Knob (22)
Bolt (8)
Collar (21)
Front Frame (20)
Pin
2.
To lock the 6” Wheels (18) in place, with your foot push down on the Brake Lock (12) over
each rear 6” Wheel (18). Make certain that the Brake Lock (12) is securely in place and that
the 6” Wheels (18) are securely locked.
3.
4.
To unlock the 6” Wheels (18), release the tab on each Brake Lock (12) with your foot.
The Rollator Walker is easily collapsible when you want to take it in the car, on an airplane, or
for other storage purposes. Simply remove the Basket (9) and pull up on the grip opening
on the Plastic Seat (1).
To unfold the Rollator Walker, place all of the 6”Wheels (18) on the ground and push down on
the Plastic Seat (1) until the Walker fully opens. Make certain that the Walker is stable before
using it.
Warning :
This Walker should only be used by a person who needs some assistance while
walking. Responsible adult supervision is required if the user is unstable and
especially when the user is getting in and out of the seat.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF
ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 92987
For technical questions please call 1-800-444-3353.
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
Part # Description
Quantity Part # Description
Quantity
1
2
3
4
5
6
7
8
Plastic Seat
Brake Loop
Hand Grip (right/left) 1
Control Plate
Brake Cable
Backrest Bar
FoamTubing
Bolt
Basket
Handle
Back Frame
Brake Lock
1
2
13
14
15
16
17
18
19
20
21
22
Wheel Fork Bearing Cap
2
2
2
4
2
4
8
2
2
1
Cross Bar
L-Shape Joint
Bearing
Wheel Fork
6”Wheel
Nut Cap
Front Frame
Collar
Knob
2
2
1
1
2
1
1
2
2
9
10
11
12
PARTS DIAGRAM
22
21
20
SKU 92987
For technical questions please call 1-800-444-3353.
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
|