Harbor Freight Tools Home Safety Product 03358 User Manual

SPOTLIGHT  
1,000,000 CANDLE POWER  
03358  
ASSEMBLY & OPERATING INSTRUCTIONS  
®
3491 Mission Oaks Blvd. / Camarillo, CA 93011  
Copyright 2002 by Harbor FreightTools®. All rights reserved. No portion of this  
manual or any artwork contained herein may be reproduced in any shape or form  
without the express written consent of Harbor FreightTools.  
ForTechnical questions and replacement parts, please call 1-800-444-3353.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Your Spotlight comes completely assembled.  
When unpacking your Spotlight, check to make sure that all the parts are included. If any parts are missing or  
broken, please call HARBOR FREIGHTTOOLS at 1-800-444-3353.  
Operation  
To assist you with operating your Spotlight, please refer to Figure 1 and Figure 2 on page 4 and to the Parts List  
and Assembly Diagram located on page 5.  
Charging  
Your Spotlight Battery (#9) is rechargeable. It can be charged by either using the Power Adapter (#17) or the  
Car Adapter (#16).  
To recharge your Battery (#9) using the AC/DC Adapter (#17):  
Step 1) Insert the cord end of the Power Adapter (#17) into the outlet on the back of the Spotlight.  
Plug the Power Adapter (#17) into an electrical outlet.  
Step 2) The red light on the side of the Housing (#1) will light, indicating that the unit is properly plugged in.  
For the initial charge of the Spotlight, leave the Power Adapter (#17) plugged in for between 12 and 14 hours  
until the Spotlight is fully charged. The red light will shut off automatically when the battery is fully charged.  
Subsequent charges of the Battery will take approximately 8 to 10 hours.  
Important: Always unplug the Power Adapter (#17) from the Spotlight after the Spotlight is charged. The  
Spotlight will not function properly if the Power Adapter is plugged into the Spotlight.  
Note: After each use of the Spotlight, always fully recharge the battery.  
Note: This unit is equipped with an automatic shutoff. If the Battery’s power is running low, the  
unit will automatically stop operating to protect the battery. Charge the battery immediately.  
To recharge your Battery (#9) using the Car Adapter (#16)  
Step 1) Insert the cord end of the Car Adapter (#16) into the outlet on the back of the Spotlight. Plug  
the plug end of the Car Adapter (#16) into your car’s lighter.  
For the initial charge, the Spotlight must be charged for between 9 and 12 hours. The red light will shut off  
automatically when the battery is fully charged. Subsequent charges of the Battery will take approximately 5 to  
8 hours.  
Note:When charging the Spotlight, only place the Spotlight on a non-flammable surface.  
Important: Always unplug the Car Adapter (#16) from the Spotlight after the Spotlight is charged. The  
Spotlight will not function properly if the Car Adapter is plugged into the Spotlight.  
Tripod Adapter  
Step 1) Your Spotlight can be mounted onto a tripod or workstand (neither is included). At the bottom  
of theTrigger Grip Handle there is aTripod Adapter (#13). Thread the tripod or workstand into thisTripod Adapter.  
On/Off with LockingTrigger Hold  
Your Spotlight is equipped with a Trigger Hold to allow you to have the Spotlight on while leaving your hands  
free for work.  
Step 1) To turn on your Spotlight, press down on the Trigger (#11). To lock on the Spotlight for an extended  
amount of time, activate the Locking Trigger Hold (#10). Push in on the Locking Trigger Hold button while the  
Trigger is depressed. The Spotlight will stay on until the Locking Trigger Hold button on the other side of the  
handle is pushed in.  
If there is any question about a condition being safe or unsafe, do not operate the tool.  
Replacing Battery: When the Battery (#9) is dead, it can be easily replaced. To replace battery, slide off  
Battery Cover (#15) and pull out Battery. Remove red and black wire connections from the old battery. Attach  
these two wire connections to the new replacement battery.  
NOTE: Make sure red battery wire connects to red battery terminal and black battery wire connects to black  
battery terminal.  
Carefully slide the new Battery into Housing (#1), making sure that the wires are not damaged. Slide Battery  
Cover (#15) back into place.  
#03358  
Page 3  
REV 06/03 REV 06/04  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Red Charging Light  
Cushion Grip  
(#14)  
Figure 2  
Hanging Strap  
(#12)  
LockingTrigger  
Hold (#10)  
Trigger (#11)  
Tripod Adapter  
(#14)  
Battery (#9)  
Figure 1  
Battery Cover  
(#15)  
Warning - Battery Disposal  
The Spotlight is powered by a battery which will have a long life span. When the battery is no longer  
functioning, it should be removed from the Spotlight and properly recycled. Many states require  
recycling. Contact your local solid waste authority for information on recycling.  
Before disposing of the battery, wrap exposed terminals with heavy tape to prevent a shorting condition,  
which could cause fire and/or injury.  
NEVER EXPOSETHE BATTERYTO HIGH HEAT OR FIRE; BATTERY MAY EXPLODE UNDERTHESE  
CONDITIONS.  
PLEASE READTHE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDEDTHE PARTS DIAGRAM INTHIS MANUAL  
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY  
REPRESENTATION OR WARRANTY OF ANY KINDTOTHE BUYERTHAT HE OR SHE IS QUALIFIEDTO  
MAKE ANY REPAIRSTOTHE PRODUCT ORTHAT HE OR SHE IS QUALIFIEDTO REPLACE ANY PARTS  
OFTHE PRODUCT. IN FACT,THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATESTHAT  
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED  
TECHNICIANS AND NOT BY THE BUYER.THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING  
OUT OF HIS OR HER REPAIRSTOTHE ORIGINAL PRODUCT OR REPLACEMENT PARTSTHERETO, OR  
ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTSTHERETO.  
#03358  
Page 4  
Download from Www.Somanuals.com. All Manuals Search And Download.  
REPLACINGTHE BULB  
Step 1:  
Take away the pin on  
the back of the reflector.  
Step 2:  
Take out the old bulb with  
cord.  
Step 3:  
Pull out the old bulb from the  
cord connection. Replace  
with the new bulb and  
cord connection and  
reassemble by reversing  
the steps shown above.  
#03358  
REV 04/03  
Page 5  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Note: Some parts are listed and shown for illustration purposes only and are not available  
individually as replacement parts.  
Parts Diagram  
Parts List  
CUSHION GRIP  
#03358  
REV 04/03  
Page 6  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Graco Microscope Magnifier 333282B User Manual
Grizzly Drill G1008 User Manual
HANNspree Flat Panel Television HANNSzzebra User Manual
Harbor Freight Tools Scale 96823 User Manual
Harman Kardon Blu ray Player BDP 1 User Manual
Hayter Mowers Lawn Mower Ranger 53 Pro User Manual
Husqvarna Motorcycle SM 610S User Manual
IBM Network Card 16 4 Token Ring User Manual
Impex Home Gym IGS 705 User Manual
Impex Home Gym TSA 5682 User Manual