Harbor Freight Tools Greenhouse Kit 97439 User Manual

6’ x 6’ Greenhouse  
97439  
set up and Maintenance instructions  
®
distributed exclusively by harbor Freight tools .  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
Visit our website at: http://www.harborfreight.com  
read this material before using this product.  
Failure to do so can result in serious injury.  
saVe this Manual.  
©
®
Copyright 2007 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork  
contained herein may be reproduced in any shape or form without the express written consent of  
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing  
improvements, actual product may differ slightly from the product described herein. Tools required for  
assembly and service may not be included.  
For technical questions or replacement parts, please call 1-800-444-3353.  
Manual reVised 08h  
Download from Www.Somanuals.com. All Manuals Search And Download.  
snow or other debris can cause parts  
of this greenhouse to buckle sud-  
denly. Do not allow snow or debris  
to accumulate on top of the green-  
house. NEVER enter a greenhouse  
with accumulated debris on top.  
unpackinG  
When unpacking, check to make sure  
that the item is intact and undamaged. If  
any parts are missing or broken, please  
call Harbor Freight Tools at the number  
shown on the cover of this manual as soon  
as possible.  
4. Assemble the Greenhouse in a  
smooth, level area that is sheltered  
from the wind.  
5. High winds can tear the Greenhouse  
loose from the Spikes and could  
result in property damage or personal  
injury. In case of severe weather or  
high winds, take the Greenhouse  
apart or move it under cover.  
6. This product is not a toy. Do not al-  
low children to play with or near this  
item.  
7. Use for intended purpose(s) only.  
8. Inspect before use; do not use if parts  
loose or damaged.  
9. Maintain product labels and name-  
plates. These carry important safety  
information. If unreadable or miss-  
ing, contact Harbor Freight Tools for a  
replacement.  
10. The warnings, precautions, and in-  
structions discussed in this instruction  
manual cannot cover all possible con-  
ditions and situations that may occur.  
It must be understood by the operator  
that common sense and caution are  
factors which cannot be built into this  
product, but must be supplied by the  
operator.  
saVe these  
instructions.  
SKU 97439  
For technical questions, please call 1-800-444-3353.  
Page 3  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Figure for pole assembly (steps 4-6)  
asseMblY instructions  
read the entire iMportant  
saFetY inForMation section  
at the beginning of this manual  
including all text under  
subheadings therein before set  
up or use of this product.  
note: For additional information regarding  
the parts listed in the following pages,  
refer to the Assembly Diagram near  
the end of this manual.  
4. Fit the covered Rafter Slats into the  
grooves in the Rafter Poles (G) and  
slide into place, with the holes on the  
Rafter Poles facing toward you (see  
insets above).  
note: The Greenhouse is heavy and  
unwieldy when fully assembled. It  
should be assembled near the area  
where it will be anchored. The area  
should be firm, level, and provide  
shelter from the wind.  
5. Fit the covered Side Slats into the  
grooves in the Side Poles (H) and  
slide into place, with the holes on the  
Side Poles facing toward you.  
Figure for slat assembly (steps 1-3)  
6. Fit the covered Bottom Slat into the  
groove in the Bottom Pole (F) and  
slide into place, with the holes on the  
Bottom Pole facing toward you.  
Figure for connector ass’y (steps 7-8)  
1. Slide two Rafter Slats (O) into the  
sleeves on the top of the Front Panel  
(K).  
2. Slide two Side Slats (P) into the  
sleeves on the sides of the Front  
Panel.  
3. Slide Bottom Slat (Q) into the sleeve  
on the bottom of the Front Panel.  
7. Secure the Rafter Poles together at  
the peak of the roof using Connector  
A. Make sure the unconnected point  
on the Connector faces towards you.  
SKU 97439  
For technical questions, please call 1-800-444-3353.  
Page 4  
Download from Www.Somanuals.com. All Manuals Search And Download.  
8. Secure both top corners using a  
Connector B on the left side and a  
Connector C on the right side, again  
make sure the unconnected point on  
the Connectors face towards you.  
Figure for bar installation (steps 13-14)  
9. Secure the bottom left-hand corner  
of the Panel with Connector D. Use  
the Hex Wrench (T) to fasten a Hex  
Screw (S) into the hole on the bottom  
of the Bottom Pole.  
10. Secure the bottom right-hand corner  
of the Panel with Connector E. Use  
the Hex Wrench (T) to fasten a Hex  
Screw (S) into the hole on the bottom  
of the Bottom Pole.  
11. Repeat the above steps to assemble  
the Rear Panel (L).  
13. Insert Rafter Bars (I) into the Sleeves  
at the top of the Body Panel (M).  
Figure for panel assembly (step 12)  
14. Insert Side Bars (J) into the Sleeves  
at the sides of the Body Panel (M).  
12. Line up the Connectors on the Front  
and Rear Panels and connect to the  
Body Panel (M). The uppermost pole  
in the Body Panel should be turned  
with the connection downward. All  
other poles should be turned with the  
connection upward, as shown.  
SKU 97439  
For technical questions, please call 1-800-444-3353.  
Page 5  
Download from Www.Somanuals.com. All Manuals Search And Download.  
to the ground. Use the two remaining  
Stakes to secure the door flap.  
Figure for bar connection (steps 15-19)  
Maintenance and  
serVicinG  
1. Periodically, inspect the general con-  
dition of the product. Check for loose  
screws cracked or broken parts, and  
any other condition that may affect  
its safe operation. If any defects are  
found have them repaired or the parts  
replaced immediately.  
2. Clean external surfaces of the prod-  
uct with clean, moist cloth.  
15. Find the holes in the Bars (I, J) and  
line them up with the holes in the  
Poles (G, H).  
16. Secure the Bars (I, J) to the Poles  
(G, H) using four Screws (R) per Bar.  
The Screws will be threaded directly  
through the cloth surrounding the  
Bars.  
17. Choose an area for the Greenhouse  
that is flat, level and free of debris. If  
possible place the Greenhouse in an  
area that is sheltered from the wind.  
High winds can tear the Greenhouse  
loose from the Stakes (N) and could  
result in property damage or personal  
injury. In case of severe weather,  
take the Greenhouse apart.  
18. Examine the area where the Green-  
house is to be placed. Make sure  
there are no utility lines beneath the  
surface that might be damaged by  
the Stakes.  
19. Hammer the Stakes (N) into each  
corner of the Greenhouse to secure it  
SKU 97439  
For technical questions, please call 1-800-444-3353.  
Page 6  
Download from Www.Somanuals.com. All Manuals Search And Download.  
please read the FolloWinG careFullY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy  
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR  
DISTRIBUTOR MAKES ANy REPRESENTATION OR WARRANTy OF ANy KIND TO THE BUyER THAT  
HE OR SHE IS QUALIFIED TO MAKE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS  
QUALIFIED TO REPLACE ANy PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/  
OR DISTRIBUTOR ExPRESSLy STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD  
BE UNDERTAKEN By CERTIFIED AND LICENSED TECHNICIANS, AND NOT By THE BUyER. THE  
BUyER ASSUMES ALL RISK AND LIABILITy ARISING OUT OF HIS OR HER REPAIRS TO THE  
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER  
INSTALLATION OF REPLACEMENT PARTS THERETO.  
parts list  
part  
A
description  
Connector A  
Qty  
2
part  
K
description  
Front Panel  
Qty  
1
B
Connector B  
Connector C  
Connector D  
Connector E  
Bottom Pole  
Rafter Pole  
Side Pole  
2
L
Rear Panel  
Body Panel  
Stake  
1
C
D
E
2
M
N
1
2
6
2
O
P
Rafter Slat  
Side Slat  
4
F
2
4
G
H
I
4
Q
R
Bottom Slat  
Screw  
2
4
32  
4
Rafter Bar  
4
S
Hex Screw  
Hex Wrench  
J
Side Bar  
4
T
1
SKU 97439  
For technical questions, please call 1-800-444-3353.  
Page 7  
Download from Www.Somanuals.com. All Manuals Search And Download.  
asseMblY diaGraM  
M
l
record products serial number here:  
note: If product has no serial number, record month and year of purchase instead.  
note: Some parts are listed and shown for illustration purposes only, and are not avail-  
able individually as replacement parts.  
SKU 97439  
For technical questions, please call 1-800-444-3353.  
Page 8  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Grace Radio GDI IR3000 User Manual
Graco Heat Pump 3A2578B User Manual
Greenheck Fan Ventilation Hood SEFSD 211 User Manual
Harman Boiler VF3000 User Manual
Hearth and Home Technologies Indoor Fireplace SL 350TRS D User Manual
Honeywell Thermostat CT87K User Manual
Hoshizaki Ice Maker C 100BAE AD User Manual
HP Hewlett Packard Network Card D7522A User Manual
HP Hewlett Packard Personal Computer C2H70UARABA User Manual
HP Hewlett Packard Server BL2X220C User Manual