Continuous Ink Supply System
for
HP1200
Installation Instruction
For AT Prefilled Version
With Auto Reset Chips
ThisVersionoftheContinuousInkFlowSystemcomeswithPrefilled
Cartridges and Auto Reset Chips. You just need to fill the
Reservoir bottles and print! The whole operation is very easy.
It’s really an effective tool to save your money.
Download from Www.Somanuals.com. All Manuals Search And Download.
Open the cover for the cartridges
Remove out the original cartridges Place the cartridges of our
CISS correctly
Slightly press every cartridges to check all the cartridges are in the correct position. And
Please be care about the tubes which out through the box .Then stick the Support Arm on the
Position which show in the third picture.
Clip the tube clamp
Finished
(3)The third step: Checking the printing head
Enter in the Printer Services Item
If there show breaks, please clean your printing head. It is possible that the wispy air have
entered into the printing head. If it is still show little breaks specially show in one color, it is
no need to repeatedly continue to clean. Just keep the printer silent for about one hour, it
may disappear. If after testing, it still abnormal, please kindly to contact with local dealer.
Download from Www.Somanuals.com. All Manuals Search And Download.
4、Reset:
If the indicator light flashing when printing, it show that you need to reset the chip to refull
the ink. Then please power offer your printer for about 1 minute, then
turn on. It will be reset to full ink.
5.Refill Ink:
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the
above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out
the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill
ink according to the color in short supply. Then put the rubber back. (Please keep the printer
and the reservoir at the same horizontal line during the process of refilling ink.)
6、Attention for maintenance:
Take out the CISS including the inner cartridges and other components. Then
remove support arm from printer, and place the original cartridges in. Please
inquire local dealer before sending to maintenance.
7.Notice:
1. Please don’t take out cartridge at random after installing the CIS system.
Keep the reservoir bottles on the same level with the printer.
2. Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out
of ink and draw air into the cartridge.
3. Don’t place the Reservoir Bottles higher or lower much than the printer.
4. To be used in a dry place between 15 and 35 degree. Avoid exposure to direct
sunlight.
5. Don’t put the continuous ink supply systems reversed or leaning during the
shipment. Please make sure all the ink filling holes and Ventilation holes are
closed tightly during the transportation. Otherwise, the ink shall leak out.
6. Don’t sway the cartridge frequently. It may cause ink leakage.
Download from Www.Somanuals.com. All Manuals Search And Download.
7. Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the
bottom of cartridge.
8.Warning:
1. Not drinkable; keep it out reach of children.
2. Avoid exposure to direct sunshine and don’t keep it in high or freezing
temperature.
3. Avoid collision and fallen down.
Download from Www.Somanuals.com. All Manuals Search And Download.
|