MODEL H0593
7" ANGLE POLISHER
INSTRUCTION SHEET
EyE INJURy HAzARD!
Always wear safety glasses
when using this tool to
prevent serious personal
INJURy HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
EXPLOSION HAzARD!
Never exceed 120 PSI.
Figure 1. Model H0593.
Introduction
Quick
Connector
Quick
Connector
Lubricator
Regulator
This versatile 7" Angle Polisher is a mate to our
H0592 7" Angle Sander. Requires 90 PSI and
consumes 12 CFM. The spindle thread is 5⁄8" x 11
UNC and no load speed is 2,500 RPM. Weighs 5
lbs. Air inlet size is 1⁄4" NPT.
Your
Tool
Air
Compressor
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Inventory
Figure 2. Installing your tool.
A. Air Polisher................................................. 1
B. Pin-Type Spanner Wrench......................... 1
C. Flat Wrench 19mm..................................... 1
D. 7” Sanding Pad .......................................... 1
E. Lock Nut ..................................................... 1
F. Handle........................................................ 1
Operation
Tool requires 90 PSI to operate correctly.
Figure 3. Lubricating directly into air fitting.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in Figure 3.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPyRIgHT © FEbRUARy, 2006 by gRIzzLy INdUSTRIAL, INC. REvISEd SEPTEMbER, 2009 (bL)
WARNING: NO PORTION OF THIS MANUAL MAy BE REPRODUCED IN ANy SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzzLy INDUSTRIAL, INC.
#TR7990 PRINTEd IN TAIWAN
Download from Www.Somanuals.com. All Manuals Search And Download.
|