Grizzly Paint Sprayer G5357 User Manual

MODEL G5357  
ENGINE CLEANING GUN  
INSTRUCTION SHEET  
Gun Body  
Nozzle  
EYE/EAR INJURY HAZARD!  
Wear safety glasses and  
hearing protection when  
using this tool!  
Increase Fluid  
INJURY HAZARD!  
Always disconnect tool from  
air to prevent unexpected  
operation during service!  
Decrease Fluid  
Fluid  
Container  
DO NOT EXCEED 90 PSI!  
Personal injury could  
occur.  
Figure 1. Model G5357.  
EXPLOSION HAZARD!  
Do not spray flammable  
fluids near and open flame  
or ignition source.  
5. Hold the gun so the nozzle is 6–10" from the  
surface and squeeze the trigger.  
6. Adjust the nozzle, as shown in Figure 1, to  
adjust the fluid amount. Lock the adjustment  
by tightening the rear section of the nozzle  
towards the front.  
LUNG HAZARD!  
Always wear a respirator  
when using this tool and  
use in a well ventilated  
area.  
7. When you are done, fill the fluid container  
with water and squeeze the trigger until the  
cleaning gun sprays clean water.  
Specifications  
Air Inlet Size .............................................14" NPT  
Air Consumption........................................ 4 CFM  
Operating Air Pressure........................ 30–90 PSI  
Wand Length.....................................................8"  
Weight (empty)...........................................1.1 lbs  
Air Supply  
The engine cleaning gun MUST be regularly lubri-  
cated with 3-4 drops of air tool oil directly into the  
air fitting before each use. For best results, we  
recommend using an in line filter, lubricator, and  
regulator, as shown in Figure 2.  
Operation  
1. Make sure the engine is cool to the touch and  
disconnect and insulate the positive battery  
cable.  
Quick  
Connector  
Quick  
Connector  
Lubricator  
Regulator  
2. Fill the fluid container with an approved engine  
cleaning solvent or detergent. Never use cor-  
rosive fluids in the container.  
Your  
Tool  
Air  
Compressor  
Quick  
Coupler  
Quick  
Coupler  
Air Hose  
3. Connect the gun body to the fluid container.  
Filter  
4. Connect the engine cleaning gun (Figure 1) to  
Figure 2. Installing your tool.  
an air supply set at 60 PSI.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Grizzly Lathe H8259 User Manual
Grundig Stereo System CDS 6580 A SPCD User Manual
Haier Freezer HF 240T User Manual
Haier Washer HW60 B1286 User Manual
HannsG Projection Television HSG1044 User Manual
Harman Boiler SF160 User Manual
Hotpoint Clothes Dryer AQCF 852 BI User Manual
Hotpoint Range RGB52524ER User Manual
HP Hewlett Packard Staple Gun C4779x User Manual
IKEA Indoor Furnishings AA 113573 3 User Manual