MODEL H0591
MICRO DIE GRINDER
INSTRUCTION SHEET
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
Only use cutters rated for
56,000 RPM or less!
Figure 1. Model H0591.
RESPIRATORY HAZARD!
Grinding produces fine
dust. Wear the appropriate
protection during use!
Micro die grinder MUST have 3-4 drops of oil
directly dropped into the air fitting before each use
as shown in Figure 2.
Introduction
This Micro Die Grinder allows extreme flexibility
in all kinds of environments. No-load speed is
56,000 RPM and requires 90 PSI of air pressure
with 7 CFM of compressor capacity. Collet size
is 1⁄8".
Inventory
A. Micro Die Grinder....................................... 1
Figure 2. Lubricating directly into air fitting.
1
B.
⁄4" NPT Air Fitting....................................... 1
C. Collet Wrenches......................................... 2
D. Oil Bottle..................................................... 1
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Operation
1
Insert your ⁄8" tool bit into the collet and tighten
with the collet wrenches provided. Make sure
the tool you use is rated for 56,000 RPM or less.
Connect air fitting to your regulated air source.
COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8127 PRINTED IN TAIWAN
Download from Www.Somanuals.com. All Manuals Search And Download.
|