Grandstream Networks, Inc.
Watch the Video Streaming of Grandstream IP Cameras GXV36xx and
Video Encoders GXV350x with Logiware go1984 Ver. 3.8.1.9
Grandstream Networks, Inc. 2011
Download from Www.Somanuals.com. All Manuals Search And Download.
Configuration on go1984:
To configure the go1984 to get the streaming from the Grandstream IP Camera or Video Encoder please
follow the steps below:
1. Launch the go1984 application
2. Depending on your access rights (please refer to go1984 user manual), you can add an IP camera or
Video Encoder. To add an IP camera or a Video Encoder, there are 2 ways:
a. Click On the “Add Camera” pull down menu (see Fig. 2):
i. Select Grandstream
ii. Select your Grandstream IP camera or Video Encoder. The Add Camera dialog box
will pop up.
Fig.2: Adding the Grandstream IP Camera or Video Encoder using the pull down menu
b. By using the search feature (see Fig. 3):
i. Type in “Grandstream” in the search textbox. A list of Grandstream devices will be
displayed.
ii. Click on the picture of the Grandstream IP camera or Video Encoder that you have.
The Add Camera dialog box will pop up.
Fig.3: Adding the Grandstream IP Camera or Video Encoder using go1984 search filter
Grandstream Networks, Inc. 2011
P a g e | 2
Download from Www.Somanuals.com. All Manuals Search And Download.
3. When the Add Camera dialog box is displayed, you can do the following:
a. In the properties section (see Fig. 4),
enter the name of the camera (this
can be any name you want to
identify the camera with).
b. Enter the IP address of the IP
Camera or Video Encoder
c. Enter the port number of your
selected device (By default it’s 80)
d. Enter the Username and
Password of the selected device.
Fig.4: Properties section in Add Camera Dialog Box
4. Grandstream IP camera or Video Encoder video streaming will be displayed on go1984 under the
image tab (see Fig. 5)
Fig.5: Video Streaming of a Grandstream IP Camera or a Video Encoder
NOTE: The Video Encoder GXV3504 can connect 4 Analog Cameras. The Go1984 will choose by default
the first channel. So if you would like to choose one of the other channels then you need add the video
encoder first then access to its video properties and change the Channel value to:
-
-
-
“1”: Second analog port
“2”: Third analog port
“3”: Fourth analog port
References:
For more information about the Grandstream IP Cameras and other products capabilities, please visit
Grandstream Networks, Inc. 2011
P a g e | 3
Download from Www.Somanuals.com. All Manuals Search And Download.
|