Failure to follow these warnings and
result in serious injury or death fro
Toddler Bed
OWNER’S MANUAL
Model No. ___________
Serial No. ___________
Dear Customer,
Please fill in the model and
serial numbers above from
the label on the side
tube of your new
toddler bed.
Strings can cause strangulation.
DO NOT place items with a string
around a child’s neck, such as
hood strings or pacifier cords. DO
NOT suspend strings over toddler
bed or attach strings to toys.
Model No. 8828
Congratulations on your purchase of a
Graco® toddler bed!
Graco is a leader in juvenile products
designed for your child’s comfort and
convenience. We believe your Graco®
toddler bed is a wise choice, promising
many hours of enjoyment for your child.
Before using your toddler bed, please take
a few minutes to read this Owner’s Manual.
The short time you spend reading these
instructions will help you use your
toddler bed properly.
DO NOT use a water mattress or all
foam mattress with this toddler bed.
DO NOT place bed
where cords from b
may strangle a chil
fall out of the windo
Please save your Owner’s Manual
for future use.
Customer Satisfaction
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
ALWAYS use a full-size crib mattress, being at least 515/
(131 cm) in length, 271/
in. (69 cm) in width, and 4 in. (10
cm) in thickness.
Our goal is to make every product the best it can
be! We are also committed to supporting our
products after purchase. If you would like to speak
to Graco about your product, please contact our
Customer Service Department at 1-800-345-4109
Our knowledgeable staff will be ready to answer any
questions you may have concerning parts, use or
maintenance. When you call, please have the
model and serial numbers ready so your call
may be processed quickly and efficiently.
8
in.
4
DISCONTINUE USE OF THE TODDLER BED when your
child weighs more than 50 pounds (23 kg). Use the bed
with only one child at a time.
USE ONLY bed rails provided by Graco®.
© 2000 Graco 606-4-00 606198
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembling the
Attaching the Headboard and Footboard
Headboard and Footboard
Step 1.
Begin by attaching frame to the
footboard.
Step 1.
Bumps
Legs have a small side hole near
one end. For each leg, push end
with side hole firmly down into
a plastic foot. Side hole must be
covered by foot. It may be
Stand footboard at one end of the
metal frame with Graco® name fac-
ing out and four plastic “bumps” of
the footboard facing toward frame.
Side hole
necessary to tap foot on a hard
surface to get it all the way on.
Holding footboard upright, grasp
the two side tubes as shown and
lift carefully. Rest ends of side
tubes on the footboard.
Step 2.
Assemble headboard and long
legs. Push open end of one long
leg onto plastic plug under “knob”
on one side of headboard.
Step 2.
Insert two T-nuts through two
holes in side tubes and into foot-
board tube as shown. Place bolts
into holes on outside of footboard
tubes and into T-nuts. Tighten
bolts with enclosed hex wrench.
Bolt
Then push leg sideways so the
rectangular plug on lower side
of headboard goes into hole on
side of the leg.
T-nut
Attach other long leg in the
same way to other side of the
headboard.
Hex
wrench
Repeat on other side of footboard.
Step 3.
Assemble the footboard and
short legs the same way.
Attach headboard in the same
This side
way. The side with the deeper
faces bed
recess should be facing the bed
as shown.
Step 3.
Insert a hex head screw into
lowest hole on each leg and
into plastic head- or footboard.
After both endboards have been
attached to frame, use the hex
wrench to FIRMLY TIGHTEN all
eight bolts into their T-nuts.
Screw
Tighten screw securely with the
included hex wrench, but do
not over-tighten.
Step 4.
Repeat for other three legs.
To create star panel, first twist
glow-in-the-dark pieces off the
plastic stem (immediately
discard stem). From the back
of the decorative panel, insert
pieces by pushing firmly in the
center of each one. (There are
three different sizes of stars and
star openings.) Check that all
stars are used and no holes are
left empty.
CHECK that all four legs are
securely attached to the
head- and footboards by
pulling on the legs.
Hex
wrench
Assembling the Frame
Step 1.
Line up the side tubes and
crossbars on the floor as
shown at right. It may be
helpful to brace one side tube
against a wall or stationary
object. Holes in side tubes
must face each other.
Step 5.
Hold panel in place on headboard
while inserting five screws through
back of headboard. (The plastic in
the screw holes may need to be
removed.) Tighten screws securely,
but do not over-tighten.
Step 2.
Insert ends of the crossbars
into holes in the side tubes.
606-4-00 606198
5
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Attaching the Mattress Retainers
Finishing Assembly
Place a standard full-size crib
Do not use toddler bed without
mattress retainers. Mattress may slide.
mattress—at least 515/
8
in. (131
cm) long by 271/
4
in. (69 cm)
Step 1.
wide by 4 in. (10 cm) thick—on
finished toddler bed frame. The
mattress must be placed so the two mattress retainers
on frame are outside of the mattress to prevent it from
moving. Your toddler bed is now ready to use.
Mattress
retainer
Ribs
Snap the mattress retainers
onto the center of the side
tubes. The ribs of each retainer
should face the inside of the
bed frame. Line up the holes of
the mattress retainers with the
small holes in the side tubes.
Instructions for ordering replacement parts:
Complete form below. Your toddler bed model number MUST be
included on the form to ensure proper replacement parts. Your model
number can be found on the label on the side tube of your toddler bed.
Payment must accompany your order.
Hex wrench
Step 2.
Parts List:
Price:*
Fasten each mattress retainer
to the side tubes with one T-nut
and bolt. T-nut must be on
inside of frame. Tighten bolts
and T-nuts with the hex wrench.
Side tube ............................................... $ 8.00 (each)
Crossbar ................................................ $ 5.00 (each)
Long leg ................................................ $ 7.00 (each)
Short leg ................................................ $ 5.00 (each)
Foot ....................................................... $ 5.00 (set of 4)
Glow-in-the-dark pieces ........................ $ 5.00
Decorative panel ................................... $ 6.00
Hardware ............................................... $ 5.00
Mattress support ................................... $10.00
Mattress retainer ................................... $ 5.00 (each)
Headboard ............................................. $12.00
Footboard .............................................. $12.00
Left bed rail (as seen from behind headboard) .. $10.00
Right bed rail (as seen from behind headboard) $10.00
Bolt
T-nut
Step 3.
Fold edges
down
Position mattress support with
printed side up as shown. Fold
edges down at creases, and
place on bed so notches in
edges fit over the crossbars.
* Prices subject to change without notice.
IF YOU NEED HELP: If you have any questions or if you
need any part not listed, please call toll-free: 1-800-345-4109
Attaching the Bed Rails
Return the form below with payment to:
GRACO CHILDREN’S PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
Step 1.
There are left and right bed rails.
When installed correctly, the note
on the bed rails, “THIS SIDE
MUST FACE MATTRESS,” will
be to the inside of the bed.
ELVERSON, PA 19520
SHIP TO:
Name
Model No. (required)
Serial No. (required)
Snap bed rails on bed side
tubes as shown.
Address
Side tube
Crossbar
City, State, Zip
Step 2.
Long leg
Short leg
(
)
Telephone
Lift bed rails and slide them to
the inside of the headboard.
Snap to headboard as shown.
Mattress retainer will fit in the
recessed area in the bed rails.
Foot
Glow-in-dark pieces
Decorative panel
Hardware
Mattress support
Mattress retainer
Headboard
Footboard
Left bed rail
Right bed rail
Check enclosed
(payable to Graco Children’s
Products Inc.)
Be sure bed
rails are secure. Bed rails must
be attached to headboard on
the inside of the post.
Charge to credit card:
Visa
MasterCard
Discover
Subtotal:
Shipping
& handling*:
Account #:
$5.00
Step 3.
6% sales tax
(PA only):
Repeat on other side. Both bed
rails must be used. Do not rely
on wall to keep child in bed. See
warnings.
Expiration date:
Signature:
Total:
*$15.00 outside the continental U.S.
7
8
Download from Www.Somanuals.com. All Manuals Search And Download.
|