122193 Beacon Tower Installation
122193 Beacon Tower Installation
Install on a ProMix 2KS
Install on a ProMix 2KE
NOTE: Beacon Tower 122193 is for ProMix 2KS auto-
matic systems (ADxxxx or RDxxxx), or manual systems
with wire harness 15W023 installed.
1. Disconnect the existing alarm from pins 1 and 2 on
the terminal strip. See FIG. 3.
2. Mount the beacon near the control box and secure
with jam nuts. Feed the wires into the box.
1. Remove the 3/4 in. (19 mm) knockout on top of the
EasyKey. Feed the wires through the hole and
secure the beacon (1) with jam nuts (N) on the
inside and outside of the box. See FIG. 1.
3. Connect the yellow wire from the beacon to pin 12
on the terminal strip.
4. Connect the gray wire from the beacon to pin 2 on
the terminal strip.
2. Connect yellow and gray wires from beacon to the
power terminal. See FIG. 2.
5. Connect either the orange, brown, or red wire to pin
1 on the terminal strip.
3. Connect orange, brown, and red wires to header
6. To enable the optional audible alarm, connect sky
blue wire to pin 1 on the terminal strip. When
enabled, it will sound for all system alarms.
4. To enable the optional audible alarm, connect sky
When enabled, it will sound for all system alarms.
7. When beacon wiring is completed, insulate the end
of each unused lead wire with insulation tape.
5. When beacon wiring is completed, insulate the end
of each unused lead wire with insulation tape.
Beacon Wires Schematic
1 2
12 14
SKY BLUE
ti15730a
NOTE: Sky Blue wire is for
optional audible alarm.
FIG. 3. Beacon Connections in Control Box, ProMix 2KE
313542D
3
Download from Www.Somanuals.com. All Manuals Search And Download.
