Gianni Industries Door P MU GS705N 30 User Manual

GS-705N Shear Lock Installation Instruction  
Unbalanced air conditioning (stack pressure) can hinder door alignment and must be corrected to help insure positive locking. It  
is important to note that the Shear Locks need a regulated 12V DC (or 24VDC) at the lock, and use the highest quality door closer  
only. Positive centering door closers are required for all double acting door applicators to help attain consistent dead center  
alignment. Also the door latching problems must be corrected prior to installation.  
Specifications  
Up to 2700 lbs (1226 Kg) in shear.  
Holding Force  
Power Input  
Magnet Assembly  
12/24 VDC selectable via jumpers +10%  
over voltage is acceptable , under voltage  
will reduce holding force.  
0.35 A@12 VDC; 0.17 A@24 VDC The unit  
does not require initial voltage increase to  
operate.  
Current Draw  
Locking Bolt  
Keep Hole  
Push-off button  
Keep Hole  
Finish  
Magnet and Armature: Zinc plated  
Housing: Black powder coated  
Magnet bond sensor output, SPDT rating  
1 AMP@30 VDC  
Monitoring Output  
Armature vertical  
adjustment screws  
Door Gap  
2mm  
Armature Assembly  
Operating Temper.  
-30C to +50C  
Connecting Diagram  
Magnet bond sensor output  
SPDT relay : 1A@30 VDC  
Caution:  
N.C.  
Make sure that the "+" and "-"  
wire are connected correctly.  
Failure to observe polarity will  
result in a short circuit and is  
not covered by products  
warrant.  
COM.  
12Vdc  
24Vdc  
N.O.  
Voltage Selection jumpers  
Check jumper settings before  
connecting the lock to 24 VDC  
input power. Damage to the  
lock may result from incorrect  
jumper settings.  
-
+
-
Power  
+
supply  
Control Device  
N.C. contact or Access Relay  
Dimensions  
6
Install the magnet assembly into the door  
frame before installation the armature assembly  
into the door leaf. The magnet assembly requires  
space to run wires, as wall as space for the  
recesses portion of the unit. However, make sure  
that the position selected for the magnet  
assembly leaves enough room on the door to  
install the armature assembly.  
GS-705N-30  
32  
30  
251  
267  
Locking Bolt  
5.9  
30  
3.5  
Unit: mm  
Copyright Gianni Industries, Inc. All Rights Reserved.  
P-MU-GS705N-30 Ver. C Publish:2007.07.17  
2-1  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Edelbrock Automobile Parts 15017 User Manual
EFJohnson Two Way Radio 001 9800 001 User Manual
Electro Voice Stereo Amplifier CPS211 User Manual
Fisher Paykel Washer Ecosmart User Manual
Fisher Price Baby Accessories P0278 User Manual
Frigidaire Air Conditioner FRS12PYS1 User Manual
GE Clothes Dryer PSXH43 User Manual
Gefen Stereo Receiver EXT HDMI13IR FO 141 User Manual
Gemini Musical Instrument BPM 250 User Manual
Gemini Musical Instrument MM 1000 User Manual