The Digital Keyless Entry system
Operation User's Manual
1. Product Characteristic:
‹
‹
‹
‹
‹
‹
‹
‹
‹
Allows up to 49+50 PIN codes
Dual relays programmable On/Off or pulsed or latched mode
Fully Programmable via keypad and master code
Door Reed Switch Input for Anti-Trailing
3 LED display with audible indication
Non-Volatile Memory
Invalid PIN Lock-out
Durable Stainless Steel housing
With vandal resistant screws
2. Specifications:
‹
‹
‹
‹
‹
‹
Operating Voltage: 12~24 Vdc
Current Draw: Average 15mA, Peak 60mA @ 12Vdc
Input: request-to-exit、Door Reed
Output: Dual relays, N.O./N.C./Com. Output (free voltage contact)
Relays Electric Current: 2A MAX @30Vdc ；0.4A @ 120Vac
Relay Activation Time: （＊100、＊200）
„
„
Strike Time: 1~99 seconds（adjustable）
Strike mode: Access Timer or Latch
‹
Memory Volume: 49+50 PIN codes
„
„
Relay 1 is controlled by 001~049 user slots
Relay 2 is controlled by 050~099 user slots
‹
‹
‹
‹
‹
PIN codes: 5 digit codes only
Operating Temperature: -20~+70℃
Ambient Humidity: 5~95% relative humidity non-condensing
Factory Master Code: 12345
Invalid PIN Lock-out: The system will shut down for 60 seconds while 32 codes of
incorrectly Master Codes enrolled or PIN codes attempted.
EPROM: Non-volatile memory, System will retain all programs and codes after a total
loss of power.
‹
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG25 Ver. B Publish:2008.08.01
Page: 1/ 3
Download from Www.Somanuals.com. All Manuals Search And Download.
‹ Changing the Master codes:
Enter the Programming mode, Enter「＊000」Followed by the new 5 digit master
code→（beep）→enrolled→Enter 「#」 to exit from the programming mode, or
program other operating.
‹ Master Code reset to Factory 「12345」
Insert the jumper P1Æ 1-2 positionÆ5 audible beepsÆReset successfulÆ Return
Insert the jumper to 2-3 position.
5. Wiring diagram:
Power Supply
Fail-Secure
Locking Device 1
Fail-Safe
Locking Device 2
Contact door reed switch
Power Supply
This reed switch is used
to reset the re-locking time
to 0 second when the door
is moved.
(Using N.O. contact in case
of door closed,
Push Button 2
changeover to N.C. When
door is moved)
Push Button 1
Master Code
reset to
1
2
3
Factory
「12345」
Note:
‹
‹
The suggested wire gauge is #22~26 AWG.
The varistor or diode must be connected across the lock terminal (electromagnet...)
operated by the device. The vartistor controls the overload produced by the strike coil
(EMP).
‹
Egresses switch should be N.O. type.
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG25 Ver. B Publish:2008.08.01
Page: 3/ 3
Download from Www.Somanuals.com. All Manuals Search And Download.
|