Genesis Servo Bass Cable
Owner’s Manual
Rev.1.0
Download from Www.Somanuals.com. All Manuals Search And Download.
Instructions For Grounding the Shield
On Genesis Servo Cables
Step 1.- Remove the grounding screw from the amplifier chassis. This screw is located on
the rear left hand corner of the chassis bottom.
Figure 1
Step 2. – Using a small piece of 240 grit sandpaper sand the paint around the screw
hole until the chassis metal is exposed.
Figure 2
Figure 3
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 3. – Using the screw removed in step 1, attach the ring terminal connector on the
Y-cable to the chassis.
Figure 4
Step 4. – Connect the male 1/8” mini jack connector on the ground lead of the left
channel cable pair to one of the female 1/8” mini jack connectors on the Y-
cable.
Figure 5
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 5. – Connect the male 1/8” mini jack connector on the ground lead of the right
channel servo cable pair to the second female 1/8” mini jack connector on the
Y-cable.
Figure 6
Download from Www.Somanuals.com. All Manuals Search And Download.
|