ZIS360NX
GE Monogram® 36" Built-In Side-by-Side Refrigerator with Automatic
Icemaker and Water Filter
The Installation Space
Dimensions and Installation Information (in inches)
35"
Case Width
36" Models 12"
42" Models 18"
48" Models 20"
* Shipping height.
The refrigerator
can be adjusted to
25-3/4"
fit into a cutout that
is 83-1/2" min. to
*Finished Width
*84" From 84-1/2” max. height.
Floor to
Top Frame
Note that the top
case trim at the
front is 1/2" higher
and will overlap
upper cabinetry or
soffit. Use leveling
legs and wheels
for a maximum 1"
height adjustment.
*83-1/2"
at
6"
Electrical
Area
Rear
84-1/2" max
83-1/2" min
Finished
5"
75" From Floor
to Bottom
of Electrical
Area
Opening
24"
36"
27-3/4"
including
handle
Frame to Frame
5"
5"
Water Supply
3-1/2"
Product Clearances
3-1/2"
Water and electrical locations
The opening must be prepared with the electrical and water
supply located as shown.
These refrigerators are equipped with a 2 position door stop.
The factory set 130° door swing can be adjusted to 90° if
clearance to adjacent cabinets or walls is restricted.
90° Door Swing
The cutout depth must be 24".
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
130° Door Swing
13"
19"
23-7/8"
Behind
Frame
The cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot exceed the
24" installation depth shown. The top case trim overlaps the
bottom of the soffit.
20-5/8"
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded 3-
prong electrical receptacle recessed into the back wall.
Electrical must be located on rear wall as shown.
4" Min.
to Wall
Allow minimum clearances for freezer door and fresh food
door for a full 130° door swing and to allow for pan removal.
4" minimum clearance is required when door swing is
adjusted to 90°. If the 90° door stop position is used, pan
access is maintained, but pan removal is restricted.
Note: GFI (ground fault interrupter) is not recommended.
• Water line can enter the opening through the floor or back
wall. The water line should be 1/4" O.D. copper tubing or
GE SmartConnect™ kit between the cold water line and
water connection location, long enough to extend to the
front of the refrigerator. Installation of an easily accessible
shut off valve in the water line is recommended.
Installation Information: Before installing, consult
installation instructions packed with product, or online
at Monogram.com, for current dimensional data.
For answers to your Monogram,® GE Profile™
or GE® appliance questions, visit our website
at ge.com or call GE Answer Center® service,
800.626.2000.
As an EnErgy StAr®
partner, gE has determined
Listed by
Underwriters
that this product meets the
Laboratories
EnErgy StAr guidelines
for energy efficiency.
Specification Created 3/08
110111
Download from Www.Somanuals.com. All Manuals Search And Download.
ZIS360NX
GE Monogram® 36" Built-In Side-by-Side Refrigerator with Automatic
Icemaker and Water Filter
Dimensions and Installation Information (in inches)
3/4" Overlay Panel
Dimensions
Important Note: Maximum total
panel weight:
• Fresh food door panel – 75 lbs.
• Freezer door panel – 53 lbs.
• Grille panel – 18 lbs.
A
For a more custom appearance,
overlay panels may be installed
on trimmed models. The overlay
panel must be secured to a 1/4"-
thick backer panel which slides
into the trim. A spacer panel 0.10"
thick must be placed between the
overlay and backer panels.
Door
Grille Panel
B
C
3/4"
Overlay
Panel
.250" + .10" + .750" =
1.100" Total Panel Thickness
1/4"
Backer
Panel
.10"
Spacer
Freezer
Fresh Food
Panel
Overlay Panel
Spacer Panel
Backer Panel
Panel
Center each panel over the
other. Assemble the panels
with glue and screws. Screws
must be countersunk into the
backer panel.
D
E
36" Side-by-Side (in inches)
A
B
C
D
E
NOTE: Left-to-right offset
is not always equal to
top-to-bottom offset.
1/4" Backer Panel 33-7/8
.10" Spacer Panel 33
9
68-3/8 14-9/16 18-9/16
13-1/4 17-1/4
8-3/8 67
3/4" Spacer Panel 34-1/8 9-1/4 68-5/8 14-13/16 18-13/16
1/4" Framed Panel
Dimensions
If you choose to install framed
panels, they must be cut to the
dimensions shown. The panels will
slide into the frame on the door and
grille.
If the custom panel is less than 1/4"
thick, and it fits loosely in the door
frame, it can be backed up with a
piece of filler material or foam tape
to improve the fit.
33-7/8"
5/16"
Trim
Grille Panel
9"
Door
Reveal
1/4"
Panel
68-3/8"
Important Note: Maximum weight
for fresh food panel is 50 pounds and
30 pounds for freezer panel.
Freezer
Panel
Fresh Food
Panel
For answers to your Monogram,® GE Profile™
or GE® appliance questions, visit our website
at ge.com or call GE Answer Center® service,
800.626.2000.
14-19/16"
18-9/16"
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
Specification Created 3/08
110111
Download from Www.Somanuals.com. All Manuals Search And Download.
ZIS360NX
GE Monogram® 36" Built-In Side-by-Side Refrigerator with Automatic
Icemaker and Water Filter
Dimensions and Installation Information (in inches)
Advance Planning for Built-In Custom Side-by-Side Refrigerators
Frameless Cabinets: The case trim overlaps
Use this page to determine door swing
cabinets at the top and sides. Therefore,
interaction with adjacent cabinets
or countertops.
frameless cabinets may require filler strips
to prevent interference with cabinet door
swing. The opening must allow for filler strips.
Refrigerator
23-7/8" From
Rear of
Refrigerator
1"
2"
1-3/4"
3"
2-3/4"
Case
Trim
3/4"
1/2"
1/4"
1-1/2"
1-1/4"
2-1/2"
2-1/4"
Top View
130° Door Swing
(Factory setting)
Scale 1:1
1/4"
1/2"
3/4"
1"
IMPORTANT NOTE –
FOR DISPENSER MODELS
Dispenser models are supplied with
two dispenser trims, one to fit framed panels
and one for overlay panels. Dispenser trim
fitto the custom panel depends on correct
panel thickness. Framed panels must be
1/4" nominal. Overlay panels should be
constructed as shown to accomplish a total
1.100" thickness.
1/4"
1/2"
3/4"
1"
1-1/4"
Door
3/4" Overlay
Panel
(Nominal Size)
For answers to your Monogram,® GE Profile™
or GE® appliance questions, visit our website
at ge.com or call GE Answer Center® service,
800.626.2000.
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
Specification Created 3/08
110111
Download from Www.Somanuals.com. All Manuals Search And Download.
ZIS360NX
GE Monogram® 36" Built-In Side-by-Side Refrigerator with Automatic
Icemaker and Water Filter
Dimensions and Installation Information (in inches)
Refrigerator
Case Trim
23-7/8"
From Rear of
Refrigerator
Advance Planning for Built-In
Side-by-Side Refrigerators
Use this page to determine door swing
interaction with adjacent cabinets
or countertops.
Frameless Cabinets: The case trim overlaps
cabinets at the top and sides. Therefore,
frameless cabinets may require filler strips
to prevent interference with cabinet door swing.
The opening must allow for filler strips.
1/4"
1/2"
3/4"
1"
1-1/4"
1-1/2"
Top View
90° Door Swing
(Optional setting)
Scale 1:1
IMPORTANT NOTE –
FOR DISPENSER MODELS
Dispenser models are supplied with two
dispenser trims, one to fit framed panels and
one for overlay panels. Dispenser trim fit to
the custom panel depends on correct panel
thickness. Framed panels must be 1/4" nominal.
Overlay panels should be constructed as shown
to accomplish a total 1.100" thickness.
1/4"
Door
1/2"
3/4"
1"
1-1/4"
3/4" Overlay
Panel
(Nominal Size)
For answers to your Monogram,® GE Profile™
or GE® appliance questions, visit our website
at ge.com or call GE Answer Center® service,
800.626.2000.
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
Specification Created 3/08
110111
Download from Www.Somanuals.com. All Manuals Search And Download.
ZIS360NX
GE Monogram® 36" Built-In Side-by-Side Refrigerator with Automatic
Icemaker and Water Filter
Features and Benefits
• Halogen Light Columns - Located in the freezer and fresh
food compartments, extend the full length of the interior
compartments providing brilliant, all-level illumination
• LED Lighting - Located at the top of the fresh food
compartment, and inside the high-humidity and climate-
control drawers, illuminates contents without
compromising space
• Advanced Temperature Management System with Multi-Shelf
Air Tower - Provides even distribution of air throughout
the refrigerator
• Climate-Control Drawer - Allows you to express-chill
beverages, express-thaw meats and select specific
temperatures for perishable foods
• Humidity-Controlled Vegetable Drawer - Helps preserve the
freshness of foods
• Gallon-Size Door Bin - Holds milk containers, two-liter bottles
and pitchers
• Adjustable Spillproof Glass Shelves - Easily accommodate
party trays and platters
• Drop-Down Shelf - Provides additional space for a casserole
dish or pizza box
• Adjustable Deli Drawer on Full-Extension Slides - Keeps
meats, cheeses and other everyday foods within easy reach
• Dairy Bin with Center Divider - Has a unique magnetic seal
that locks in freshness
• Adjustable Door Bins - Can be moved to one of two positions
in seven locations
• Model ZIS360NX – Non-dispenser model
For answers to your Monogram,® GE Profile™
or GE® appliance questions, visit our website
at ge.com or call GE Answer Center® service,
800.626.2000.
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
Specification Created 3/08
110111
Download from Www.Somanuals.com. All Manuals Search And Download.
|