Installation
Instructions
ZKHCSS2
Tubular Stainless Steel Handles
and Handle Side Trim
Before you begin – Read these instructions completely and carefully.
Note to Installer: Be sure to leave these instructions with the Consumer.
Note to Consumer: Keep these instructions with your Owner’s Manual for future reference.
Right hand door swing models are illustrated in these
instructions. Follow these same instructions for left hand
models.
A
B
D
This kit provides for the installation of Tubular Stainless
Steel handles or custom handles on 3/4" overlay custom
panels.
C
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 7/32", 1/8" bits and 7/8" spade bit
• Custom door panels,
• Safety glasses
F
E
• Center punch
G
• Hammer
• Pencil
H
Parts List:
A. Freezer tubular handle (95376) and
fresh food tubular handle (95377)
B. 4 Handle standoffs, 70536
C. 6 Screws for handle standoffs
#10-32x1" pan head machine screws (4 required, 2 extra), 36298
D. 6 Set screws (4 required, 2 extra) 70539
E. 3/32” Allen wrench for set screws, 70548
F. 6 Plastic spacers (4 required, 2 extra) 70540
G. 5 Trim screws (4 required, one extra) 8665
H. Handle side trim for LH models (75468), trim for RH models (75469)
STEP 1 REMOVE DOOR AND
DRAWER HANDLES
• Open refrigerator door to 90°. Remove the 4 screws
holding the handle to the door.
• Remove 4 screws holding handle side trim. Discard all
screws and trim. Discard handle.
• Open freezer drawer to access handle and trim.
Remove and discard handle, retain screws and trim.
If you are installing custom handles, go to STEP 3.
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 INSTALL ASSEMBLED PANELS
Install
8 Screws
• Slide assembled panel into the drawer trim.
• Secure the original drawer trim using original round
head trim screws.
Install 4
Handle Side
Trim Screws
• Install custom handles according to the manufacturer’s
instructions.
• Slide assembled door panel into
the trim.
Custom Trim
• Determine the correct trim for
your model (for left or right
door swing). Place trim against
the side of the refrigerator door,
aligned top to bottom. The holes
in the trim should align to the
holes in the door. Discard the
other trim piece.
Refrigerator
Door
Trim to Panel Fit
• Remove trim. Use a 1/8" bit to drill the semi-punched
holes in the refrigerator door.
• Secure the new custom handle side trim using the
supplied screws.
-3-
Download from Www.Somanuals.com. All Manuals Search And Download.
Note: While performing installations described in this book,
safety glasses or goggles should be worn.
For Monogram® local service in your area, call
1-800-444-1845.
Note: Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and
specifications are subject to change without notice.
®
Monogram.
We bring good things to life.
General Electric Company
Louisville, KY 40225
Pub. No. 31-46033-2
Dwg. No. 197D4869P001
(N.D. 532) 9/02
75470
Download from Www.Somanuals.com. All Manuals Search And Download.
|