GE Model 19217
c. Mark the 4 holes using the base as a template with the arrow pointing up.
d. If mounting in sheetrock wall, drill 5/32” holes and insert the plastic
screw anchors, otherwise drill pilot hole for screw.
e. Mount the chime base using the 4x25mm screws.
f. Attach the wires for the pushbuttons as shown in the schematic.
g. Put the cover on the chime
Wired Chime Kit
5. Mount the pushbuttons.
Installation Instructions for Wired Door Kit
a. Locate the mounting location and pull the wires through the slot in the
pushbutton.
b. Remove the pushbutton cover.
c. Use the base as a template and mark the mounting holes with the arrow
pointing up.
d. Drill pilot holes using a 1/16” drill.
e. Connect the wires matching the schematic.
f. Put the cover on the pushbutton.
g. Replace the pushbutton cover.
Included hardware:
1: Chime
2: (2) Push buttons
3: Transformer
6. Reapply power and test the chime.
Replacement Installation
Included Hardware:
(4) Plastic screw anchors
(4) 4x25mm screws (for anchors)
(4) 3x20mm screws
1. Shut off power at fuse box or circuit breaker.
2. Remove the cover from the old door chime and disconnect wires from screw
terminals and label them for reference.
3. Install new chime
a. Remove the cover for the chime.
b. Pull the wires through the slot in base of chime.
c. Mark the 4 holes using the base as a template with the arrow pointing up.
d. If mounting in sheetrock wall, drill 5/32” holes and insert the plastic
screw anchors, otherwise drill pilot hole for screw.
e. Mount the chime base using the 4x25mm screws.
f. Attach the wires for the pushbuttons as shown in the schematic.
g. Put the cover on the chime.
(3) Wire nuts
Required Tools:
Wire stripper/cutter, small flat blade screwdriver, Phillips screwdriver, drill,
and drill bit (1/16” and 5/32”)
Chime Tune Setting
1. Remove the chime cover and locate the two 3 position dip switches shown
below.
For technical support contact Jasco Products Company at 1-800-654-8483
Made in China
Hecho en China
2. Select the desired chime sound from the table below.
Chime Sound Table
is a trademark of
General Electric Company
and is used under license to
Jasco Products Company LLC,
10 E. Memorial Road,
Oklahoma City, OK 73114.
19217
Position
1
2
3
Westminster
Ding Dong
Knock
Bronze Chime
Cuckoo Clock
Foghorn
OFF
OFF
ON
OFF
ON
ON
ON
OFF
ON
OFF
ON
OFF
ON
ON
ON
OFF
OFF
ON
ON
OFF
ON
Rev. 3-07
Gong
New Installation Instructions
Use the proper type of wire for your application, in accordance with local
electrical codes. If you are unsure of the requirements consult a licensed
electrician.
1. Shut off power at fuse box or circuit breaker
2. Locate and mount the included power transformer in a dry location.
3. Connect the house power to the transformer input as shown in the
schematic.
a. House Black to Transformer Black
b. House White to Transformer White
c. House Green to Transformer Green
4. Locate the mounting location for the chime.
a. Remove the cover for the chime.
b. Pull the wires through the slot in base of chime.
Removal and Replacement of Push button cover
Download from Www.Somanuals.com. All Manuals Search And Download.
|