Using IP/P2P with GCC Elite XL8/Elite XL16/Elite XL20
and Elite 12 Series printers.
.
Download and install IP/P2P on your
Windows 98 or Windows Me System
Open up IP/P2P from the Programs List.
You will note that the
Max Hops and IP Port
Windows are already
filled in. These values
can remain unchanged
during this installation.
Now click on the ‘Printers’ button.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Now open your ‘Printers’ Folder
Assuming you have already
installed your GCC Elite 12 as
a local printer it will be available
in this window.
Place your cursor over the ICON
and, using a Right Click select
properties from the drop down
menu.
Select the ‘Details’ Tab on the
‘Properties’ window.
From the Details Tab you will click on
the down arrow in the ‘Print to the following
Port window.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
At this point you will see your Printer
Listed as you entered it in the IP/P2P
Window earlier.
Select the printer port listed and click ‘Apply’
You will see the below message, click OK.
Verify the port is displayed in the Print to the
Following Port’ window and also verify that
you have GCC Elite 12xxxx selected as the
driver to use. The specific driver name will
depend on which specific printer model you
have installed.
This example shows a GCC Elite 1212
Click on ‘Spool Settings’ and select
‘Disable Bi-Directional Printing’
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Now go to the Postscript Tab
Click on Advanced
On the next Window
Select Pure Binary Data
Click OK
…….then click Apply
Now go back to the General Tab.
Click on Print Test Page.
Your Windows 98 or Windows Me
Test Page should print.
You may now close the properties window, you have successfully set up LPR Printing
for your GCC Printer using IP/P2P.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
|