4. Lift up the stacker and stacker extension
according to the length of the sheet.
Test-Scanning Documents
Side Guides
Chute
Using ScandAll PRO, you can test-scan
documents to check if they are scanned correctly.
The following describes how to test-scan a
document:
Stacker
Extension 2
Extension
Chute
Extension 1
1. Press the [Power] button on the operator
panel of the scanner.
Stacker
Check
Check LED
4. Launch ScandAll PRO.
Function
Number
Display
Function
Select the [Start] menu J [All Programs] J
[Fujitsu ScandAll PRO] J [ScandAll PRO].
Send to
Scan
/Stop
Power
5. Select the [Tool] menu J [Preferences].
D The [Setup] dialog box appears.
[Power] Button
6. On the [Scan] tab, select a driver to use,
D The power is turned on, and the [Power]
button lights in green.
During initialization, the Function Number
Display of the operator panel changes as
follows: "8" J "P" J "0" J "1". The
scanner is ready when "1" is displayed.
and then click the [OK] button.
To use a TWAIN driver, click [TWAIN].
To use an ISIS driver, click [ISIS/VRS].
7. Select the [Scan] menu J [Select
Scanner].
If "1" is not shown in the Function
Number Display, refer to "Chapter 8
Troubleshooting" in the Operator's
Guide.
D The [Select Scanner] dialog box appears.
8. Select the scanner you want to use, and
then click the [Select] button.
Select the scanner model which is connected
to your computer.
The list of scanner models varies depending
on the scanner driver installed.
When you press the [Power] button,
the Check LED will flash once. Note
that this is an initial diagnosis and not
a malfunction.
TWAIN Driver
ISIS Driver
2. Turn on your computer.
FUJITSU fi-6110dj
Fujitsu fi-6110
D The scanner is automatically detected.
When the [Found New Hardware]
dialog box appears, select [Locate and
install driver software
9. Click the [Scan] menu J [Scan Settings].
D The [Scan Settings] dialog box appears.
(recommended)], and install the driver
by following the on-screen
instructions.
10. Clear the [Save to file] check box.
3. Load a sheet into the scanner.
1. Pull out the chute extension 1 and chute
extension 2 according to the length of the
sheet.
You only check the operation now, so
you do not have to save to file.
2. Load the document in the ADF paper chute.
Set the sheet with its front side (scanning
side) facing the ADF paper chute.
11. Click the [Scanner Setting] button.
D The scanner driver's setup dialog box
3. Adjust the side guides to the width of the
appears.
sheet.
Download from Www.Somanuals.com. All Manuals Search And Download.
7
