Warmer Drawer
FPWD3085K F
30" Electric
More Easy-To-Use Features
SpaceWise™ Half-Rack
4-Hour Auto Power-Off
Bread Proofing Setting
Fully Extendable Drawer
Power Indicator Light
A.D.A. Compliant*
Capacities
1.6 Cu.ꢀFt. Drawer Capacity
Overall Exterior Dimensions
Height
Width
Depth
11-1/4"
30"
23-3/8"
Available in:
Stainless
(F)
*ꢀWhen properly installed, meets the appliance standards
in the American with Disabilities Act and the Architectural
Barriers Act Accessibility Guidelines as published by the
United States Access Board on June 23, 2004.
Signature Features
Real Stainless Steel
Pro-Select™ Controls
Real stainless steel with a protective
coating that reduces fingerprints and
smudges so it's easy to clean.
With a temperature range from 80°ꢀF
to 190°ꢀF, you can proof bread or keep
your entire meal warm.
Large Capacity
Adjustable Humidity Control
The humidity level can be adjusted
to keep food from drying out before
serving.
This large 1.6 cubic foot capacity
drawer, along with the half-rack that
creates more space, makes keeping
your meal warm easy.
frigidaire.com
Download from Www.Somanuals.com. All Manuals Search And Download.
30"ꢀCombination Installation
Built-In Microwaveꢀ/ꢀSingle Wall Ovenꢀ/ꢀWarmer Drawer
30" Combination Installation Specifications
30" Electric Single Wall Oven Specifications
Single phase 3- or 4-wire cable, 120ꢀ/ꢀ240 or 120ꢀ/ꢀ208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
•
•
Always consult local and national electric codes.
(Refer to product-specific electrical specifications on this page.)
•
Minimum 23-5/8" deep cutout dimension is critical for proper
combination installation, to ensure that each built-in product’s
faceplate will fit flush against cabinet front.
•
•
For detailed electrical requirements, refer to model-specific product
page and installation guide on web.
To support Wall Oven when using in combination with Warmer
Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base,
capable of supporting 200 Lbs. Do NOT use full base, since planks
are necessary to allow for proper air displacement.
•
•
Bases must be level and cabinet front must be square.
Minimum 4-1/2" required distance from bottom of Warmer Drawer
cutout to floor.
•
•
Respect critical dimensions as noted for proper installation of
built-In products.
30" Warmer Drawer Specifications
• Voltage Rating – 120Vꢀ/ꢀ450Wꢀ/ꢀ60 Hzꢀ/ꢀ15 Amps
Minimum 21" clearance needed for Wall Oven door depth when open.
• Connected Load (kW Rating) @ 120 Volts = 0.5 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120V = 3.8 Amps
• Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
30" Built-In Microwave Specifications
•
For built-in installation, microwave MUST be installed with optional
30" Trim Kit which includes Bottom Duct Assembly – shipped in
separate box, ordered by individual part number.
•
•
Voltage Rating – 120Vꢀ/ꢀ60 Hzꢀ/ꢀ15 or 20 Amps
Connected Load (kW Rating) @ 120 Volts = 1.7 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
•
•
Amps @ 120 Volts = 14.3 Amps
Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
•
Minimum 2-7/8" clearance required from bottom of Built-In Microwave
cutout to top edge of Wall Oven’s faceplate, leaving a 2" visible gap
between both product faceplates.
FRIGIDAIRE®
•
•
•
•
USA 250 Bobby Jones Expressway Martinez, GA 30907 1-800-FRIGIDAIRE frigidaire.com
Specifications
subject to change.
•
•
•
•
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4 1-800-265-8352 frigidaire.ca
MOSS_EW_WD 30INST FR 04/09 © 2009 Electrolux Home Products, Inc.
Printed in the U.S.A.
Download from Www.Somanuals.com. All Manuals Search And Download.
|