Model WRT1
Installation and Operation Instructions
WRT1 PTAC Wireless Remote Thermostat
Base Module
For assistance with this product, please
Thermostat Operation
Base Module Tips
call Friedrich Technical Assistance Center
at 877-599-5665 ext. 261 between the
hours of 8:00 AM - 5:00 PM CST.
4
5
6
7
8-9
10
11
12
13
14
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
(Behind Door)
Friedrich Tip
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Range between the WRT1 and the base module is up to 100 feet with no obstructions and
up to 50 feet through standard building materials. To optimize the range try placing the base
module higher if in a basement or further away
from large metal objects.
The base module is designed to be mounted behind the front grille of your Friedrich packaged
terminal air conditioner (PTAC). Refer to the Friedrich PTAC Installation & Operation Manual for
instructions in removing the front grille. Check clearance to ensure the fit of front grille after base
module installation. Ensure if mounting with screws that wires and lines are not damaged. See
below for a few suggested options to mount the base module.
Note: For Friedrich Single Package Vertical Air Conditioners (Vert-I-Pak®) install module on the
outside of the unit, in close proximity to the low-voltage terminal board.
Note:
It is recommended to use an adhesive
tape instead of screws when mounting
the Base Module inside the PTAC
housing.
Friedrich Tip
5
Download from Www.Somanuals.com. All Manuals Search And Download.
The WRT1 thermostat is
Friedrich Tip
The thermostat can be hardwired to a 24V power supply, however, it is not required. Batter-
ies should be checked annually if 24V power is not connected.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
UP
7
Download from Www.Somanuals.com. All Manuals Search And Download.
9
24 VAC Transformer power
24 VAC Transformer power
Second stage of heat
WRT1
Friedrich PTAC or Vert-I-PAK® Installation and
Operation Manual to enable remote thermostat operation.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Friedrich PTAC
Friedrich PTAC
In Friedrich PT AC units with single seped fan op eration, a jumper (not suplied) should
be installed between G L and HG.
Friedrich PTAC and Vert-I-PAK
9
Download from Www.Somanuals.com. All Manuals Search And Download.
2
3
3
2
Friedrich PTAC units
will require ELEC fan relay.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
P
V
for PTAC configuration
for Vert-I-Pak configurations
WRT1
12
ON configures
the thermostat
for heat pump
P
V
systems.
*
OFF configures
the thermostat
for non heat
pump systems.
**
V
*
Select OFF on HU configuration for Friedrich models with the following suffix: A, B, C, D or E
**
11
Download from Www.Somanuals.com. All Manuals Search And Download.
WRT1
WRT1.
WRT1.
WRT1.
WRT1
12
Download from Www.Somanuals.com. All Manuals Search And Download.
subbase
.
ꢀ5ꢀ ꢀ&ꢀWHUPLQDOꢀFRQQHFWHGꢀWRꢀꢁꢂꢀV$&ꢃꢀ&ODVVꢀ,,ꢀSRZHU
13
Download from Www.Somanuals.com. All Manuals Search And Download.
WRT1 Thermostat
( 17.2°C)
(-17.67°C to -16.67°C)
(-17.67°C to -16.67°C)
Radio transmission frequency
Friedrich Air Conditioning Co.
10001 Reunion Place, STE 500
San Antonio, Texas 78216
Toll-free: 1-800-541-6645
Website: www.friedrich.com
Hours of Operation: Monday - Friday 8 AM - 5 PM CT
94993001_00
14
Download from Www.Somanuals.com. All Manuals Search And Download.
|