Model 100-SSV
Stainless Steel Vertical Changing Station
Installation Instructions
Thank you for purchasing a quality Foundations® product. Our goal is 100% consumer satisfaction!
If, for any reason you are not satisfied or if you have questions regarding your product or installation,
please contact our customer service team at 1-877-716-2757. Please DO NOT contact your distributor
or reseller as we are better prepared to assist you.
WARNING
•
•
Failure to follow these warnings and the installation instructions could result in serious injury
or death.
Read all instructions before installing diaper changing station. Keep these instructions. DO NOT
discard.
SI260D
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION - RECESSED
For A. D. A. compliance, top of lower double stud should be
22-1/2"
1"
(571 mm)
30.5“ (78 cm) from the floor.
(25.4 mm)
TOP
VIEW
3-7/8"
(98.6 mm)
Recommended Blocking:
22-1/2" (571 mm)
Rough-in
Double Stud
Wood double stud blocking is necessary. Contact an architect and
building official to make sure the blocking is adequate and complies
with building codes (Fig. b).
1. Slide changer into blocking area and mark mounting hole location
on blocking studs.
34-1/8"
(867 mm)
Rough-in
FRONT
VIEW
HINT: This may require 2 additional people to help hold changer
30-1/2”
(775 mm)
in position while you are marking the locations.
2. Shim changer for a snug fit.
3. Align holes in changer with marked holes and secure using the
appropriate fasteners (Fig. c).
For A. D. A.
Double Stud
Compliance
30.5”
NOTE: It is installers responsibility to provide correct fastereners
(78 cm)
Fig. b
A. F. F
for other substrates.
Recess
4. Ensure all six (6) fasteners are tight.
Mounting
Holes
Recess
Mounting
Holes
Recess
Mounting
Holes
Fig. c
INSTALLATION - SURFACE-MOUNT
Recommended Blocking:
Top
If the walls do not have studs on center, then additional blocking is necessary
(Fig. d).
Contact an architect or building contractor to make sure the blocking is adequate
and complies with building codes.
16"
26"
(406 mm)
on center
(660 mm)
on center
For A. D. A.
Compliance
62 3/4”
For A. D. A. compliance, measure up 62 3/4” (159 cm) from the floor and mark the
(159 cm)
wall. This locates the position for the top left attachment hole.
NOTE:
- Changer MUST be mounted to studs (Fig. e).
- This unit incorporates a finishing collar that seats behind the changer’s
outside flange. Center the collar as the unit is being tightened against
the wall (Fig. f).
A. F. F
Fig. d
Surface-Mount
Holes
Collar
Wall
Unit
Fig. f
Fig. e
2
Download from Www.Somanuals.com. All Manuals Search And Download.
|