QuickStart
V240/Mini
Shown Mini; V240 operates in the same manner.
Features of Your FoodSaver Appliance
A
B
Indicator Light
Open/Cancel Button
Note: This appliance is a compact design that saves counter space.
It can be used with pint-size and quart-size FoodSaver Bags, and 6-inch
and 8-inch FoodSaver Rolls.
C
D
E
Vacuum Channel
Rubber Gasket
Sealing Strip
For important safety information and helpful tips, please refer to the FoodSaver Reference Guide
1-877-804-5383 (Canada). Get tips on vacuum packaging.
Download from Www.Somanuals.com. All Manuals Search And Download.
Tips for Successful Vacuum Packaging
For more usage tips and safety information, please refer to the FoodSaver Reference Guide or visit our website at www.foodsaver.com.
GeneralTip
If appliance lid is locked, press Open/Cancel
Button (B) to open lid.
Sealing a Bag
Make sure you’ve placed the bag in the proper place.
When making a bag from a roll, make sure end of cut
piece is on Sealing Strip (E), not over rubber gasket
(D) or in Vacuum Channel (C).
excess liquids. Just be sure to leave at least 3 inches
between paper towel and end of bag so that bag
seals properly with paper towel inside.
Make sure you give appliance time to cool down.
Wait at least 20 seconds between seals. Under very
heavy usage, appliance will shut off automatically to
prevent overheating. If it does, wait 20 minutes to
allow appliance to cool off.
Prevent moisture or liquid from being pulled into
theVacuum Channel or trapped in the seal. Either
pre-freeze moist foods such as raw meat for 1-2
hours before vacuum packaging, or place a folded
paper towel between food and end of bag to absorb
Removing Air from a Bag
Make sure you’ve placed the bag in the proper
place. When vacuuming packaging, make sure open
end of bag is inside Vacuum Channel (C).
If motor runs for more than 30 seconds without
stopping, you may need to adjust bag and try again.
If you are making initial seal on a piece of bag material
with two open ends, make sure bag is placed on
Sealing Strip, not on rubber gasket (D). If you are
vacuum packaging with a bag, make sure open end is
placed down inside Vacuum Channel.
Check for wrinkles in the bag along the Sealing
Strip. Wrinkles in seal may cause leakage and allow
air to come back into bag. Check for wrinkles in bag
along Sealing Strip (E) before closing lid and vacuum
packaging. If you find wrinkles after sealing bag,
simply cut bag open and vacuum package again.
Download from Www.Somanuals.com. All Manuals Search And Download.
Tips for Successful Vacuum Packaging
(continued)
GeneralTips
1. Vacuum packaging is NOT a substitute for the
heat process of canning. Perishables still need to
be refrigerated or frozen.
5. Do not create your own side seams for a
FoodSaver Bag. These bags are manufactured
with a special side seam, which is sealed all the
way to the outer edge.
2. For best results, use FoodSaver Bags.
6. To prevent wrinkles in seal when vacuum
packaging bulky items, gently stretch bag flat
along Sealing Strip before you close lid.
3. During the vacuum packaging process, small
amounts of liquids, crumbs or food particles can
be inadvertently pulled into Vacuum Channel,
clogging the pump and damaging your appliance.
To prevent this, follow these tips:
7. If you are unsure your bag was sealed properly,
simply reseal bag about 1 4 inch above first seal.
⁄
a. For moist and juicy foods such as raw meats:
Freeze first and avoid overfilling bags. You can
also place a folded paper towel inside top of bag,
but below seal area, before vacuum packaging.
b. For soups, sauces and liquids: Freeze first and
avoid overfilling bags.
c. For powdery or fine-grained foods: Avoid over-
filling bags. You can also place a coffee filter or
paper towel inside before vacuum packaging.
8. When you are vacuum packaging items with sharp
edges (dry spaghetti, silverware, etc.), protect
bag from punctures by wrapping item in soft
cushioning material, such as a paper towel.
9. Pre-freeze fruits and blanch vegetables before
vacuum packaging for best results. See pages 2-3
of FoodSaver Reference Guide for more information.
4. To avoid overfilling, always leave at least 3 inches
of bag material between bag contents and top of
bag. Then leave at least one additional inch of bag
material for each time you plan to reuse bag.
Copyright © 2004 Tilia, Inc. All rights reserved. This material may not be reproduced or redistributed in any fashion without the express written consent of Tilia, Inc.
FoodSaver and the Freshness Shield logo are trademarks or registered trademarks of Tilia Int’l, Inc. in the United States and other countries. All other trademarks
are property of their respective owners. Tilia, Inc. and Tilia Int’l, Inc. are Jarden companies.This product is protected by one or more of the following Patents:
U.S. RE 34,929; 4,660,355; 4,941,310; 5,655,357; 6,058,998; 6,256,968; Canada 1,315,746; and their equivalent international patents.
First Printing: 6/2004
Item # T180-00209-000 (6/04)
Download from Www.Somanuals.com. All Manuals Search And Download.
|