Safety Information
Use the FLK-TI-SBC3 only as specified in this instruction sheet or other Fluke
product-specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.
Charging the Battery
Before using the battery pack for the first time, charge the battery in the two-bay charging
base for at least two and one-half hours. For complete charging instructions, see the “Ti32,
TiR32 Thermal Imagers User Manual.”
A Warning identifies hazardous conditions and actions that could cause bodily harm or
FLK-TI-SBC3
Charging Base/Power Supply with Adapters
death.
Specifications
See Table 2 for the specifications.
A Caution identifies conditions and actions that could damage the Imager or cause
permanent loss of data.
Table 2. Specifications
WWarning
Instruction Sheet
10-15 Vdc 2 A or charge battery pack in Imager with included ac
Battery Charging
To avoid injury:
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a
charging base, power supply, and power outlet adapters.
●
●
●
●
Do not disassemble or short circuit the battery pack.
Do not expose the battery pack to temperatures above 50 °C (122 °F).
Do not incinerate or mutilate the battery pack.
Use only ac adapters approved by Fluke for the product to charge the battery or
power the product.
Status
Charging LED
no battery detected
charged
Power LED
off
no dc power input
Charging / Power LED
solid green
dc power present
blinking green
blinking red
charging
na
na
Table 1. Symbols
fault
Dimensions
159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
-10 °C to 70 °C (-14 °F to 158 °F)
Symbol
P
Description
Operating Temperature
Storage Temperature
Humidity Range
Conforms to requirements of European Union and European Free Trade Association.
Imager connected to battery charger.
Y
TTER
-20 °C to 80 °C (-4 °F to 176 °F) without batteries
10 % to 95 % non-condensing
3
BA
T
R
SMA
CHARGER
"
Ti SBC3
WER
PO
Conforms to relevant Australian standards.
;
Conforms to relevant Canadian and US standards
Important information. See manual.
)
W
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for
recycling information.
~
PN 3481481 August 2009
© 2009 Fluke Corporation. All rights reserved. Printed in USA.
All product names are trademarks of their respective companies. Specifications are subject to change without notice.
Download from Www.Somanuals.com. All Manuals Search And Download.
|