V4553
IMPORTANT! KEEP FOR FUTURE REFERENCE.
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts
Assembly
IMPORTANT! Please remove all parts from the package and identify
them before assembly. Some parts may be packed in the pad.
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Fisher-Price
®
for replacement parts and instructions if needed. Never substitute parts.
Pad
Base Tube
Toy Bar
Left Base Wire
Right Base Wire
1
• Place the base tube on a flat surface.
• Position the left and right base wires as shown.
• Fit the left base wire and right base wire into the base tube.
Seat Back Tube
Footrest
Non-skid Surface
2
Left Base
Wire
• Position the feet so the non-skid surface is down.
• Fit the feet on the base tube, as shown.
Base Tube
2 Feet
Right Base
Wire
M5 x 20 mm Screw – 4
Note: Screw shown actual size. Tighten or loosen all screws
with a Phillips screwdriver. Do not over-tighten the screws.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Seat Back Tube
Retainer Socket Up
3
• Insert an M5 x 20 mm screw through each foot and tighten.
Footrest
5
• Make sure the socket in the retainer is upright.
• Fit the seat back tube onto the ends of the base wire.
• Push the seat back tube to be sure it is completely on the base wires.
Base Wires
4
• Position the footrest so that the soothing unit is upright.
• Fit the footrest onto the ends of the base wires.
6
• Insert an M5 x 20 mm screw in each hole in the seat back tube,
base wire and into the inside of the retainer. Tighten the screw.
• Pull the seat back tube up to be sure it is secure.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Retainers
Pad Seat Back Pocket
Soothing Unit
9
7
• Fit the retainers through the side openings in the pad.
• Fit the edges of the soothing unit through the large opening in the
front of the pad.
• Position the pad above the frame.
• Fit the upper pocket on the back of the pad onto the seat back tube.
Pad Lower Pocket
Toy Bar Plugs
8
• Fit the lower pocket on the back of the pad onto the footrest.
Sockets
10
• Insert and “snap” the toy bar plugs into each retainer socket.
Hint: The toy bar is removable. Press the ends of the latches and
lift the toy bar.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
Hint: We recommend using an alkaline batteries for longer
battery life.
1,5V
“D” (LR20)
2
1,5V x 2
“AA” (LR6)
Soothing Unit
• Loosen the screw in the battery compartment door. Remove the
battery compartment door.
• Insert one “D” (LR20) alkaline battery into the battery compartment.
• Replace the battery compartment door and tighten the screw.
• Pull and fit the pad seat bottom pocket around the soothing unit
and footrest.
• Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
• If the soothing unit begins to operate erratically, you may need to
reset the electronics. Slide the power switch off and then back on.
B
A
A
3
Toy Bar
• Loosen the screws in the battery compartment door.
• Insert two "AA" (LR6) alkaline batteries into the battery compartment.
• Replace the battery compartment door and tighten the screws.
• If the toy bar begins to operate erratically, you may need to reset
the electronics. Remove the batteries and replace them.
1
Soothing Unit
• Pull to remove the pad from around the retainers and the soothing
unit A .
B
• Remove the pad bottom pocket from the footrest
.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause
a chemical burn injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
6 • If removeable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Download from Www.Somanuals.com. All Manuals Search And Download.
Setup and Use
WARNING
To prevent serious injury or death:
Restraint System
• Fall Hazard - Never use on any elevated
surface, since child’s movement may cause
product to slide or tip over. Use only on
a floor.
• Suffocation Hazard - Never use on a soft
surface (bed, sofa, cushion) since product
can tip over and cause suffocation in
soft surfaces.
• Always use restraint system.
• Never leave child unattended.
• Do not use product once child can
sit unaided.
• This product is not intended to replace
a cot or bed for prolonged periods of sleep.
• Never use toy bar to carry product.
• Never use as a carrier or lift while child
is seated.
2
• Tighten each waist belt so that the restraint system is snug against
your child. Please refer to the next section for instructions to
tighten the waist belts.
Anchored End
Anchored End
Restraint Pad
Free End
Free End
TIGHTEN
LOOSEN
3
To tighten the restraint belts:
• Feed the anchored end of the restraint belt up through the buckle
A
to form a loop . Pull the free end of the restraint belt
.
B
To loosen the restraint belts:
• Feed the free end of the restraint belt up through the buckle to
A
form a loop . Enlarge the loop by pulling on the end of the loop
toward the buckle. Pull the anchored end of the restraint belt to
Restraint Belts
B
shorten the free end of the restraint belt
.
1
Securing Your Infant
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the restraint belts to the restraint pad. Make sure you hear
a “click” on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Soothing Unit
Care
• The pad is machine washable. Wash it separately in cold water on
the gentle cycle. Do not use bleach. Tumble dry separately on low
heat and remove promptly.
• The frame, toy bar and toys may be wiped clean using a mild
cleaning solution and damp cloth. Do not immerse the toy bar.
Do not use bleach. Do not use harsh or abrasive cleaners.
Rinse clean with water to remove residue.
C
B
A
Power Switch
A
• Make sure your child is properly secured in the seat.
• Slide the power switch to: Vibrations or Off.
IMPORTANT! Low battery power causes this product to operate
erratically: no vibrations and the product may not turn off.
Remove and discard the battery and replace with a new
“D” (LR20) alkaline battery.
To remove the pad:
• Pull to remove the pad from around the retainers and the soothing
A
unit
.
B
• Remove the bottom pocket of the pad from the footrest
• Lift to remove the pad
.
C
.
• Pull the ring on the toy for music and sounds.
• To replace the pad, refer to Assembly steps 7 - 9.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
|