Fisher Price Car Seat 79013 User Manual

Futura 20/60Car Seat Tether Strap Kit  
Instructions  
Model Numbers 79013, 79014  
Tools needed for tether strap attachment: Screwdriver or other blunt object, Hammer.  
5
16  
Tools needed for tether anchor installation (if needed): Drill with / " Bit and two Wrenches.  
Tether Strap Installation  
1
4
7
Tether Strap  
Metal Tube  
Pad  
Loop  
Shell  
Upper Slots  
Lower Slots  
Shoulder Straps  
Remove the top of the pad from the top of the  
car seat shell.  
IMPORTANT! Before you complete this step – please  
take notice of the location you have selected for the  
shoulder straps. If the shoulder straps are inserted into  
the lower shoulder strap slots – the tether strap will be  
inserted through the lower center slot. If the shoulder  
straps are inserted into the upper shoulder strap slots –  
the tether strap will be inserted through the upper,  
center slot.  
Turn the car seat around so that the back is facing you.  
Fit the metal tube through the loops in the shoulder  
straps and tether strap.  
2
Shell  
8
Insert the loop end of the tether strap through either  
the upper, center slot or the lower, center slot.  
Metal Tube  
5
Pad  
Metal Tube  
Shell  
Shoulder Straps  
Fit the end of a blunt object,  
such as a screwdriver, into the  
end of the metal tube on the  
back of the car seat. Pry the  
While pushing the plastic grommets from the front of  
the car seat (one at a time) tap the metal tube (near  
each plastic grommet) into the groove in the shell.  
Make sure the metal tube “snaps” into place. The metal  
tube should be completely inserted into the groove so  
that it is below the surrounding outer surface.  
Note: If the metal tube does not “snap” into place or  
if the plastic grommets are not secured to the shell, you  
probably have not inserted the plastic grommets with  
the hooked end up. Please re-read step 6.  
metal tube from the groove in the shell.  
Remove the metal tube from the shoulder straps. Set the  
metal tube aside.  
While holding the tether strap in place, carefully fit the  
top of the pad back onto the top of the shell.  
3
Shoulder Strap Slots  
6
Hook  
Tether Strap  
Loop  
Shoulder  
Straps  
Hooked End  
Position the plastic grommets so  
that the hooked ends are up.  
Position the tether strap so that the hook is facing down.  
IMPORTANT! If the hook is not facing down, you will  
not be able to use the tether strap properly.  
Re-insert the plastic grommets into  
the selected shoulder strap slots.  
Re-insert the shoulder straps through  
Grommet  
the plastic grommets and slots in the  
shell. Make sure the shoulder straps  
are not twisted.  
Insert the loop end of the tether strap through the large  
slot in the top of the shell, as shown.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Ecom Instruments Home Safety Product H 251 A User Manual
EdgeStar Fan EAC211TS User Manual
Extron electronic Network Card RGB 190FM User Manual
FieldServer Power Supply FS 8700 124 User Manual
Freud Tools Router Router User Manual
Garland Electric Heater MCOE5L User Manual
Garmin GPS Receiver 101 User Manual
GE Door 19204 User Manual
GE Freezer FUF20DM User Manual
GE Monogram Dishwasher ZBD6800K User Manual