™
Classical Chorus
Bouncer
Model Number: B0772
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required. Tool required for assembly:
Phillips Screwdriver (not included).
Requires three “C” (LR14) alkaline batteries (not included).
ver
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts
Toybar
Seatback
Tube
Retainer
Pad
Footrest
Retainer
Right Base Wire
Soothing Unit
Base Tube
3
4
#8 x / " Screw - 2
Left Base Wire
Shown Actual Size
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
1.5V x 3
“C” (LR14)
SHOWN ACTUAL SIZE
Battery Compartment Door
• Loosen the screw in the soothing unit battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert three “C” (LR14) alkaline batteries, as indicated inside the
battery compartment.
• Replace the battery compartment door and tighten the screw with a
Phillips screwdriver. Do not over-tighten.
Hint: We recommend the use of alkaline batteries for longest battery life.
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use. Always remove
exhausted batteries from the product. Battery leakage and corrosion
can damage the product. Dispose of the batteries safely.
• Do not dispose of batteries in a fire. The batteries may explode or leak.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as recommended in the
“Battery Installation” instructions are to be used.
• If removable rechargeable batteries are used, they are only to be charged
under adult supervision.
• Rechargeable batteries are to be removed from the product before they
are charged.
• If you use a battery charger, it should be examined regularly for damage to
the cord, plug, enclosure and other parts. Do not use a damaged battery
charger until it has been properly repaired.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Colored Tabs
Base Tube
Right Base Wire
Left Base Wire
1
Base Tube
Base Wire
• Place the base tube on a flat surface
as shown.
Colored Tab
• Position the left and right base wires as
shown. Note the location of the colored
tabs on the left and right base wires.
Back View
• Fit the left base wire into the base tube.
• Fit the right base wire into the base tube.
• Make sure both colored tabs on the base wires are visible through the
holes in the base tube.
Soothing Unit
Clip Screw
2
Footrest
Soothing Unit
• Loosen the screw in the soothing unit clip with a Phillips screwdriver.
• Slide the soothing unit onto the footrest, as shown. Make sure the footrest
is completely in the grooves around the sides and back end of the
soothing unit.
• Tighten the screw in the soothing unit clip with a Phillips screwdriver.
Do not over-tighten.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Footrest with Soothing Unit
Flex Base
Wires Inward
Tab
Tab
3
• Position the footrest so that the soothing unit is upright.
• While flexing the base wires toward each other, hook the footrest onto the
ends of the base wires.
• Push the footrest down completely to the tabs on the base wires.
Base Wire
Seat Back Tube
Base Wire
4
• Fit the seat back tube completely onto the base wires.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Retainer
Socket
Up
Retainer
Socket
Up
Seat Back Tube
5
PULL UP
• Fit a retainer to the outside of the seat
back tube, as shown. Make sure the
socket in the retainer is upright.
• Insert a screw through the hole in the
seat back tube, base wire and into the
inside of the retainer.
• Tighten the screw with a Phillips screw-
driver. Do not over-tighten.
• Repeat this procedure to assemble the
other retainer to the other side of the
seat back tube.
• Pull up on the seat back tube to be sure it is secure. If you can remove
either end of the seat back tube, you have not assembled the retainers
correctly. Remove the screws, re-read and repeat Assembly steps 4 and 5.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Pad
Footrest
Soothing
Unit
ạ
Ạ
Seat Back
Tube
6
• Position the pad above the frame with the blanket toward the soothing unit.
• Fit the upper pocket on the back of the pad onto the seat back tube Ạ.
• Lift the footrest. Fit the lower pocket on the back of the pad onto the
footrest ạ. Lower the footrest.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Toy Bar
Retainer
Socket
Retainer
Socket
Plugs
7
• Fit the toy bar plugs into each retainer socket.
• The toy bar is removable. Simply pull to remove.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
WARNING
To prevent serious injury and/or falls:
• Never use on any elevated surface,
since child’s movement may cause
bouncer to slide or tip over.
• Never use as a carrier or lift while child
is seated.
• Always use the restraint system.
• Never leave child unattended.
• Never use with a child able to sit
up unassisted.
Belt
1
Buckle
Restraint
Securing Your Child
• If the toy bar is attached, remove it before placing your child in the seat.
• Place your child in the seat. Position the restraint between your child’s legs.
• Fasten both belts to the buckles on each side of the restraint. Make sure
you hear a “click” on both sides.
• Check to be sure the restraint is securely attached by pulling it away from
your child. The restraint should remain attached.
• Attach the toy bar, if desired (see Assembly Step 7).
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
Buckle
Buckle
Anchored End
Anchored End
Ạ
ạ
ạ
Ạ
2
Free End
Free End
Loosen
Tighten
To tighten the restraint:
• Feed the anchored end of the belt up through the buckle to form a loop Ạ.
• Pull the free end of the belt ạ.
• Repeat this procedure to tighten the other belt.
To loosen the restraint:
• Feed the free end of the belt up through the buckle to form a loop Ạ.
Enlarge the loop by pulling on the end of the loop toward the buckle.
• Pull the anchored end of the belt to shorten the free end of the belt ạ.
• Repeat this procedure to loosen the other belt.
Please Note: After adjusting the belts to fit your child, make sure you pull on the
restraint to be sure they are securely fastened.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
3
Power Button
Mode Switch
Music and Calming Vibrations
• Make sure your child is properly secured in the seat.
• Slide the mode switch on the soothing unit to select music, calming vibrations
or both! Then press the power button to turn your selection on.
Music
• Slide the mode switch to
.
• Press the power button
to turn music on with low volume;
press again for on with high volume; press again to turn music off.
Vibrations
• Slide the mode switch to
.
• Press the power button
turn vibrations off.
to turn vibrations on; press again to
Music and Vibrations
• Slide the mode switch to
• Press the power button
.
to turn vibrations on and music on
with low volume; press again to turn vibrations on and music on with high
volume; press again to turn music and vibrations off.
Hints:
• Be sure to press the power button AFTER making your mode selection to turn
the soothing unit on.
• Turn the soothing unit off after each use by sliding the mode switch to the
off
position.
• Music and/or vibrations will shut off automatically after 10-15 minutes. To turn
them back on, press the power button.
IMPORTANT! Change the batteries when vibrations/music will not shut off or
the soothing unit does not function properly as described in the instructions.
You will also need to change the batteries if vibrations/music from the
soothing unit become faint, or if there are no vibrations or music. Remove
the batteries from the soothing unit and dispose of them properly. Replace the
batteries with three, new “C” (LR14) alkaline batteries.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
Blanket
4
• Fold blanket up on baby’s lap.
Storing the Blanket
• Pull the blanket down completely.
• Fold the blanket under the footrest wire.
• Tuck the blanket into the pocket on the underside of the pad.
13
Download from Www.Somanuals.com. All Manuals Search And Download.
Care
The pad is machine washable. Wash it separately in cold water on
the gentle cycle. Do not use bleach. Tumble dry separately on low
heat and remove promptly. The frame, toy bar and toys may be
wiped clean using a mild cleaning solution and a damp cloth.
Do not immerse the soothing unit.
Colored Tab
14
Download from Www.Somanuals.com. All Manuals Search And Download.
FCC Note (United States Only)
Note:This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the man-
ufacturer responsible for compliance could void the user‘s authority
to operate the equipment.
15
Download from Www.Somanuals.com. All Manuals Search And Download.
Consumer Information
Questions? We’d like to hear from you!
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM – 6 PM EST Monday through Friday. Hearing-impaired
consumers using TTY/TDD equipment, please call 1-800-382-7470.
Or, write to:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
For other countries, outside the United States:
Canada: call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.
Great Britain: telephone 01628 500302.
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2002 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in China
B0772pr-0920
Download from Www.Somanuals.com. All Manuals Search And Download.
|