73499
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver (not included).
™
Stride-to-Ride Walker™
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
CAUTION
2
Caster
Wheels
This product contains small parts in
its unassembled state.
Adult assembly is required.
1
Wheel
Assembly
Base
Bottom View
• Insert and “snap” the caster wheels into the base,
as shown. This may require some force.
• Turn the base over.
Pegs
Pegs
Bottom View
• Place the base upside down on a flat surface.
• Fit the wheel assembly onto the pegs on the base,
as shown
• Insert four #8 x 1/2" (1,3 cm) screws through the holes in
the wheel assembly and into the pegs on the base.
Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
4
3
Basket
Tabs
Backboard
Posts
Base
Small Slots
Base
Large Slots
• Insert and “snap” the basket tabs into the small slots in
the topside of the base.
• Insert and “snap” the backboard posts into the large
slots in the topside of the base.
Hint: You may need to rock the backboard to secure it
properly into the base.
One time assembly is now complete.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
PRINTED IN CHINA
©2006 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
73499b-0920
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Replacement
Battery Safety Information
In exceptional circumstances, batteries may leak fluids
that can cause a chemical burn injury or ruin your
product. To avoid battery leakage:
1.5V x 3
“AA” (LR6)
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery
compartment.
SHOWN ACTUAL SIZE
• Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Dispose of batteries safely. Do not dispose of product
in a fire. The batteries inside may explode or leak.
Battery
Compartment
Door
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
Power/Volume Switch
Back View
For best performance, we recommend replacing the
batteries that came with this toy with three, new
alkaline “AA” (LR6) batteries.
• Locate the battery compartment on the backboard.
• Loosen the screws in the battery compartment door
with a Phillips screwdriver. Remove the battery
compartment door.
Power/Volume Switch
• Insert three "AA" (LR6) alkaline batteries, as indicated
inside the battery compartment.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the
screws with a Phillips screwdriver. Do not over-tighten.
• When lights or sounds from this toy become faint or
stop, it’s time for an adult to change the batteries!
• Locate the power/volume switch on the backboard.
• The switch has three positions: off O, on with low
volume
and on with high volume
.
• Slide the switch to off O position when the toy is not
in use.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Walker
To change to Walker mode,follow these steps:
1
• Turn the toy over.
Press and slide the
latch to an open
Press the nose or walk
along for fun music
and dancing lights!
position, as shown.
Latch
1
Press
2
Slide
Bottom View
2
• Spread the seat
halves until they
“click” in place.
Turn the toy over.
It is now ready to
be used as a walker.
Ball play! Toss the
balls into the hoop.
Bottom View
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Ride-On
To change to Ride-On mode, follow these steps:
Press the nose or roll
along for fun music
and dancing lights!
1
• Press the button
and hold it while
closing the seat
halves. Turn the
toy over.
PRESS
Top View
2
• Slide the latch to
a closed position.
It should “click”
into place.Turn the
toy over. It is now
ready to be used
as a ride-on.
Latch
Ball play! Toss the
balls into the hoop.
Bottom View
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Care
Consumer Information
• Wipe this toy with a clean cloth dampened with a mild
soap and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not
take this toy apart.
Call Fisher-Price® Consumer Relations, toll-free at
1-800-432-5437, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment,
please call 1-800-382-7470.
• Do not drop this toy on a hard surface.
Write to us at: Fisher-Price® Consumer Relations,
636 Girard Avenue, East Aurora, New York 14052.
FCC Statement
(United States Only)
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd.,
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre,
Harbour City, Tsimshatsui, HK, China.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Changes or modifications not expressly approved
by the manufacturer responsible for compliance could void
the user's authority to operate the equipment.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
|