Product Category
DVC 501 SD • Setup Guide
The Extron DVC 501 SD receives SD-SDI, HD-SDI, and 3G-SDI serial digital video signals and converts them to DVI-D and
analog RGB or component video. It is compliant with SMPTE 259M, 292M, 424M, and ITU digital video standards. The RGB
output can be set for RGBHV, RGBS, and RGsB. Bi-level or tri-level sync can be selected when the unit is set for component
video output. The DVC 501 SD features extraction of embedded AES3 audio, RS-232 and USB serial control, and a buffered
loop-through that delivers reshaped and restored multi-rate SDI signals.
NOTE: For full installation, configuration, and operation details, see the DVC 501 SD User Guide, available at
Rear Panel Features and Connections
1
6
2
3
4
5
100-240V ~ 0.3A MAX
INPUT
OUTPUT
AUDIO
BUFFERED
LOOP-THROUGH
DVI-D
3G / HD / SD-SDI
RGB/R-Y,Y,B-Y
L
R
RS-232
7
50/60 Hz
N/A
Tx Rx
AC power connector
DVI-D output connector
Audio output connector
RS-232 connector
a
b
c
d
e
f
g
3G/HD/SD-SDI input connector
Buffered Loop-through connector
RGB/YUV output connector
Installation Steps
1. Disconnect power from all equipment.
2. (Optional) Mount the unit to a rack or furniture.
3. Connect the video input. Connect an SD-SDI, HD-SDI, or 3G-SDI source to the 3G/HD/SD-SDI port of the BNC input
connector (b in the rear panel illustration above).
4. (Optional) Connect a monitor or recording device. Attach a monitor or video recording device to the Buffered
Loop-through BNC connector (c).
5.
Connect the video output. Connect a display or other output device to the DVD-D digital video connector (d) or to
the RGB/R-Y,Y,B-Y analog RGB (RGBHV, RGBS, and RGsB) or YUV component video connector (e).
6. Connect a control device. Connect a host device, such as a computer or touchpanel control system to one or both of
the following DVC ports to configure and control the DVC via Simple Instruction Set (SIS™) commands.
_
z
RS-232 port (rear panel) — Connect a host device to the Tx, Rx, and (ground) pins of this 5-pole captive screw
connector (g). The first and second pins of this connector are not used. The default protocol for this port is
9600 baud, 1 stop bit, no parity, 8 data bits, and no flow control.
z
Config port (front panel) — Connect a USB cable (USB A to USB mini B) between a USB port on your computer
and this port (a on the front panel illustration on the next page).
7. Connect the audio output. Connect an amplifier or other audio output device to the 5-pole captive screw audio
connector (f on the rear panel illustration), as shown below.
Tip
Ring
Sleeves
Tip
Tip
Sleeves
Tip
Do not tin the wires!
Ring
Balanced Audio Output
Unbalanced Audio Output
CAUTION:
For unbalanced audio, connect the sleeves to the ground contact. DO NOT connect them to negative (–)
contacts.
8. Connect power to the DVC 501 SD by plugging a standard IEC power cord (provided) from a 100 to 240 VAC, 50-60 Hz
power source into the power receptacle (a).
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|