PMK 150 • Installation Guide
Pipe Clamp
The Extron® PMK 150 Pole Mount Kit is a
simple solution for mounting Extron devices
and their external power supplies to a
projector pole.
PMK 150
Mounting Plate
The PMK can be installed on a 1½ inch pipe
within a 4 inch space between the projector
and the ceiling.
(2) Hex Bolts
(2) Washers
Including the power supply, the
following devices can be mounted:
(2) Tie Wraps
•
•
•
one three-inch deep half-rack device, or
two 3-inch deep quarter rack devices, or
an MPA 401
Figure 1. PMK 150 Parts
Figure 1 shows the parts that are included in the kit.
CAUTION: The maximum load for the PMK 150 is 5 lbs (2.25 kg).
NOTE: The PMK 150 is to be used only with Extron UL listed products.
Installation
NOTE: Ensure the finished installation is in accordance with local and national
building codes, fire and safety codes, UL requirements, and local and
national electrical codes.
To install the PMK 150 (with a device) on a projector pole:
1. Place the plate on the base of the device and align holes in the plate with
the mounting holes in the device (see figure 2).
(2) 4-40 x 3/16"
Screws
2. Secure the device to the plate with 4-40
screws (see note below).
CAUTION: Use only the screws supplied
with the device to avoid damaging it.
PMK 150
NOTE: When installing the MPA 401 onto
the PMK 150, install it with the rear
panel facing the projector pipe. Allow
enough space for the connectors on
the cables to fit without bending the
Use 2 mounting
holes on opposite
cables excessively. If the space for
corners.
this is inadequate, turn the MPA 401
around and place it on the PMK so the
front panel of the device is closest to
the pipe, and then connect the cables.
Figure 2. Attaching the Device
Continued on side 2.
Download from Www.Somanuals.com. All Manuals Search And Download.
|