Excalibur electronic Motorized Toy Car 9511 99 User Manual

User’s Guide for  
®
1:10 Nascar RC  
#99 Carl Edwards  
Model No.  
9511-99  
Download from Www.Somanuals.com. All Manuals Search And Download.  
What is included with  
1:10 Nascar® RC  
Functions of Buttons  
consistent straight line driving.  
Switch left or right to align the  
wheels.  
LEFT SWITCH ON TRANSMITTER:  
Switch up to drive the vehicle  
forward. Switch down to drive  
the vehicle in reverse.  
ON/OFF SWITCH: Switch to turn  
the transmitter on or off.  
RIGHT SWITCH ON TRANSMIT-  
TER: Switch left to steer the  
vehicle left. Switch right to  
steer the vehicle.  
ON/OFF/SPEAKER OFF SWITCH:  
Switch ON to drive the vehicle  
with sound. Switch OFF to turn  
the vehicle off. Switch SPEAK-  
ER OFF to drive the vehicle  
without sound.  
TRIM SWITCH CONTROL: The  
trim switch is located on the  
underside of your vehicle. This  
is used to align the wheels for  
Manual  
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Another radio control  
vehicle using the same fre-  
quency is operating near  
your vehicle, or a CB is  
being operated nearby. If  
that is the case, you should  
race other vehicles that use  
different frequencies or  
channels, or move away  
from your location until  
there is no more interfer-  
ence.  
Trouble-  
shooting  
How to Play  
To begin, insert the  
switches to turn your 1:20  
Nascar® RC in any direc-  
tion you would like.  
antenna wire through the  
hollow tube. Avoid pulling  
the wire too tight. The wire  
is on the top of your 1:10  
Nascar® RC. Tie a knot on  
top to secure.  
If your 1:10 Nascar® RC  
doesnt move, please check  
the following potential  
causes:  
To maneuver the auto  
forward, turn the right  
switch to the right and flip  
the left switch up.  
1. The POWER switch is  
turned off. If that is the  
case, turn the POWER switch  
on.  
2. Your 1:10 Nascar® RC  
is too far away from the  
controller. If that is the case,  
bring your 1:10 Nascar® RC  
closer to the controller.  
Turn the switch to the ON  
position for power.  
To turn the auto left  
while driving in reverse use  
the switches as follows: flip  
the right switch left and flip  
the left switch back.  
In a clockwise direction,  
screw the antenna into the  
cavity located at the top of  
the transmitter.  
If your 1:10 Nascar® RC  
drives slowly, please check  
the following potential  
causes:  
Use the control switches  
on the transmitter to drive  
your 1:10 Nascar® RC. The  
switches allow you to drive  
it forward, reverse, left and  
right. You can also honk the  
horn and lift the left and  
right doors up.  
1. There are weak batter-  
ies in the transmitter. If that  
is the case, replace with  
new batteries.  
Tip  
3. The metal tab in the  
battery cartridge is flattened  
and not touching the batter-  
ies installed. If that is the  
case, lift up the metal tab so  
it touches the tip of the bat-  
tery.  
Check the wheel mecha-  
nisms for lint, thread, hair  
or dust frequently. This  
ensures the wheels move  
freely and that the motor is  
not stressed.  
2. There is strong inter-  
ference in the surrounding  
area. If that is the case, you  
should move to a better  
location to drive your 1:10  
Nascar® RC.  
You can control your  
1:20 Nascar® RC’s turns  
with the control switches.  
Maneuver both control  
If you lose control of your  
1:10 Nascar® RC, please  
check the following poten-  
tial cause:  
Changes or modifications to this unit not expressly  
approved by the party responsible for compliance could  
void the users authority to operate the equipment.  
7
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Special Care & Handling  
Avoid rough handling such as bumping or dropping.  
Avoid moisture and extreme temperatures. For  
best results, use between the temperatures of 39º F and  
100º F (4º C and 38º C).  
Never drive your 1:10 Nascar® RC on a wet floor, on  
sand, or in mud, rain or snow. These can damage it.  
Be sure to remove the batteries from your 1:10 Nascar®  
RC and transmitter when storing the product.  
To protect your 1:10 Nascar® RC’s wheel mechanism  
from lint, thread, hair and dust particle, you can use a  
small brush, tweezers or tie a small bit of cloth to the  
tip of a toothpick, etc., and wipe it off.  
Caution  
• Do not operate your 1:10 Nascar® RC in  
thunderstorms.  
• Do not touch the wheels when the switch is turned ON.  
• Do not leave your 1:10 Nascar® RC or transmitter  
near sources of heat or under direct sunlight for  
long periods of time.  
• Do not operate your 1:10 Nascar® RC near small  
children.  
• Do not drive your 1:10 Nascar® RC in busy  
streets. Always choose a safe place to play.  
Always keep your 1:10 Nascar® RC clean. Use a  
dampened cloth to wipe off, and then wipe all the water  
off with a dry cloth. Never use chemicals to clean your  
1:10 Nascar® RC.  
Avoid holding the wheels when rotating. Holding them  
will cause the electronic components to short-circuit,  
overheat and cause malfunction.  
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
BATTERY INFORMATION  
90-Day Limited Warranty  
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer  
that its products are free from any electrical or mechanical defects for a peri-  
od of 90 DAYS from the date of purchase. If any such defect is discovered  
within the warranty period, EXCALIBUR ELECTRONICS, INC., will repair  
or replace the unit free of charge upon receipt of the unit, shipped postage  
prepaid and insured to the factory address show at right.  
Use alkaline batteries for best performance.  
Use six AA batteries for your 1:10 Nascar® RC.  
Use one 9-volt batteries for your transmitter.  
Do not use rechargeable batteries.  
The warranty covers normal consumer use and does not cover damage that  
occurs in shipment or failure that results from alterations, accident, misuse,  
neglect, wear and tear, inadequate maintenance, commercial use, or unrea-  
sonable use of the unit. Removal of the top panel voids all warranties. This  
warranty does not cover cost of repairs made or attempted outside of the fac-  
tory.  
Remove exhausted batteries from the unit.  
Do not short circuit battery terminals.  
To avoid explosion or leakage, do not dispose of  
batteries in a fire or attempt to recharge standard  
or alkaline batteries.  
Any applicable implied warranties, including warranties of merchantabil-  
ity and fitness, are hereby limited to 90 DAYS from the date of purchase.  
Consequential or incidental damages resulting from a breach of any applica-  
ble express or implied warranties are hereby excluded. Some states do not  
allow limitations on the duration of implied warranties and do not allow  
exclusion of incidental or consequential damages, so the above limitations  
and exclusions in these instances may not apply.  
Be sure to insert batteries with the correct polarities  
and always follow the toy and battery  
manufacturers’ instructions.  
Remove batteries and store them in a cool, dry place  
when not in use.  
The only authorized service center in the United States is:  
Always remove old and dead batteries from the product.  
Excalibur Electronics, Inc.  
th  
13755 S.W. 119 Avenue  
Miami, FL 33186 U.S.A.  
Phone: (305) 477-8080  
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-  
ing two conditions: (1) this device may not cause harmful interference, and (2) this  
device must accept any interference received, including interference that may cause  
undesired operation.  
Fax: (305) 477-9516  
NOTE: This equipment has been tested and found to comply with the limits for a Class  
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-  
vide reasonable protection against harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio frequency energy and, if not installed  
and used in accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful interference to radio or tel-  
evision reception, which can be determined by turning the equipment off and on, the  
user is encouraged to try to correct the interference by one or more of the following  
measures:  
Ship the unit carefully packed, preferably in the original  
carton, and send it prepaid, and adequately insured. Include  
a letter, detailing the complaint and including your daytime  
telephone number, inside the shipping carton.  
If your warranty had expired and you want an esti-  
mated fee for service, write to the above address, spec-  
ifying the model and the problem.  
PLEASE DO NOT SEND YOUR  
UNIT WITHOUT RECEIVING AN  
ESTIMATE FOR SERVICING. WE  
CANNOT STORE YOUR UNIT!  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet on a circuit different from that  
to which the receiver is connected.  
Consult the dealer or an experienced radio/TV technician for help.  
10  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
EXCALIBUR ELECTRONICS, INC.  
13755 SW 119TH AVENUE  
MIAMI, FLORIDA 33186 U.S.A.  
PHONE: 305.477.8080  
FAX: 305.477.9516  
Play games live at:  
9511-99 (MA) 1:10 Nascar RCCarledwards 071906 V6  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Ei Electronics Smoke Alarm EI105C User Manual
Extron electronic Stereo Amplifier MPA 152 MD User Manual
Fisher Paykel Ventilation Hood 6102 Series User Manual
Fisher Price Baby Toy C4780 User Manual
Ford Automobile 2011 Escape User Manual
Foundry Networks Flat Panel Television RX 32 User Manual
Freescale Semiconductor Network Card iMX31 PDK 14 User Manual
Friedrich Air Conditioner ZQ05C10 User Manual
Frigidaire Air Conditioner FRS093LC1 User Manual
FujiFilm Camera Lens 3228 User Manual