TROUBLE SHOOTING
Limited 90-Day Warranty
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free from
any electrical or mechanical defects for a period of 90 DAYS from the date of purchase. If any such
defect is discovered within the warranty period, EXCALIBUR ELECTRONICS, INC., will repair or
replace the unit free of charge upon receipt of the unit, shipped postage prepaid and insured to the
factory address below. The warranty covers normal consumer use and does not cover damage that
occurs in shipment or failure that results from alterations, accident, misuse, abuse, neglect, wear
and tear, inadequate maintenance, commercial use, or unreasonable use of the unit. Removal of the
top panel voids all warranties. This warranty does not cover cost of repairs made or attempted
outside of the factory. Any applicable implied warranties, including warranties of merchantability
and fitness, are hereby limited to 90 DAYS from the date of purchase. Consequential or incidental
damages resulting from a breach of any applicable express or implied warranties are hereby
excluded. Some states do not allow limitations on the duration of implied warranties and do not
allow exclusion of incidental or consequential damages, so the above limitations and exclusions in
these instances may not apply. The only authorized service center in the United States is:
Problem
Causes
Correction
Vehicle
doesn't
move
• Power switch is turned OFF.
• Vehicle is too far away from the
controller.
• The metal tab in the battery
cartridge is flattened and not
touching the installed batteries.
• Turn the power switch ON.
• Bring the vehicle closer to
the transmitter.
• Lift up the metal tab so that
it makes a secure contact with
the battery tip.
RADIO-CONTROLLED VEHICLE
AGES
+
7
Loss of
Control
• Another radio control vehicle
using the same frequency is
operated near your vehicle
• Race against other vehicles
using a different frequency or
channel.
Vehicle drives
slowly
• Weak batteries in the vehicle.
• Replace with new batteries,
following the + / - marking.
Excalibur Electronics, Inc.
13755 SW 119th Ave.
Miami, FL 33186 U.S.A.
Poor
range
control
• Weak battery in the transmitter.
• Strong interference in the
surrounded area.
• Replace with new battery.
• Move to a better location to
Drive your vehicle.
Ship the unit carefully packed, preferably in the original carton, and send it prepaid, and adequately
insured. Include a letter detailing the complaint, along with your daytime telephone number, inside
the shipping carton. If your warranty has expired and you want an estimated fee for service, write to
the above address, specifying the model and the problem.
Excalibur Electronics voids warranty.
WARNING: Modifications not approved by
PLEASE DO NOT SEND YOUR UNIT WITHOUT RECEIVING AN ESTIMATE FOR SERVICING.
WE CANNOT STORE YOUR UNIT!
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. NOTE: This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable l interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
1:20
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SCALE
EXCALIBUR ELECTRONICS
27Mhz
MODEL # 9455Y
THIS PRODUCT IS FOR THE USE IN U.K., SPAIN, GERMANY, FRANCE, BELGIUM, ITALY,
SWITZERLAND, THE NETHERLANDS, DENMARK, U.S., CANADA AND PORTUGAL.
Excalibur Electronics, Inc.
13755 SW 119th Avenue • Miami, FL 33186
INSTRUCTION MANUAL
RADIO REPLICAS is a trademark of Excalibur Electronics, Inc.
HUMMER, H2, and all related emblems, and the distinctive vehicle model body and grille designs are General Motors
Trademarks used under license to Zaptoys International Ltd. / Lucky Plastic and distributed by Excalibur Electronics, Inc.
Actual product may differ slightly from photograph.
CHOKING HAZARD Small parts.
-
Please read through this instruction manual carefully before starting to operate.
Please ensure to remove all accessories and components from packaging.
Not suitable for children under 3 years.
Made In China
How to Play
E
MAINTENANCE AND CAR
1. Turn Hummer‘s switch to "ON" position for power.
it on a wet floor, on sand, or in mud,
• To avoid damage to vehicle, never drive
rain or snow.
2. Turn Transmitter‘s switch to "ON" position for power. You are set to run!
emperatures.
he vehicle and transmitter when
• Do not expose the vehicle to extreme t
• Be sure to remove the batteries from t
storing the product away.
• To protect the vehicle's wheel mechan
particles, use a small brush, tweezers
any dust or debris.
RADIO-CONTROLLED VEHICLE
Moving Your Vehicle
See diagram below.
AGES
Instruction Manual
Please read through this instruction manual
Please ensure to remove all accessories and com
ism from lint, thread, hair, and dust
or the tip of a toothpick, and wipe off
+
7
carefully before starting to operate.
LEFT / RIGHT STEERING
ponents from packaging.
pened cloth to wipe off, and then wipe
use chemicals to clean the product.
• Always keep vehicle clean, use a dam
all moisture off with a dry cloth. Never
• Keep this instruction manual for future us
• Avoid holding the wheels when rotating,
components to short-circuit, overheat and
What Is Required To Play
e.
FORWARD
REVERSE
this will cause the electronic
cause malfunction.
.
high heat level which causes wear and tear
• Long periods of play time can generate
To extend product life, allow 10 minutes
eries.
to cool down before installing new batt
HELPFUL HINTS
.
itter, move closer to the vehicle and try again
• If vehicle does not respond to the transm
es and
e a loss of performance, replace the batteri
• If vehicle loses power or you experienc
try again.
Vehicle
Transmitter
Manua
l
for
batteries and check the wheel mechanisms
• If the vehicle moves slowly, try changing the
lint, thread, hair or dust.
eplace the battery in the controller.
• When the transmitter range decreases, r
• If someone uses a CB nearby, it might int
move the car and transmitter away from the
erfere with control of the car. If this occurs,
Battery Requirements
CB.
Recommended to use alkaline batteries for best performance.
Vehicle : 3 x 1.5V (AA) size batteries
Transmitter : 1 x 9V (006P, 6F22) size batteries
CAUTION
Battery Installation
transmitter.
• Do not apply a big shock to vehicle and
• Do not play in thunderstorms.
Transmitter
ngerous.
for long
tch is turned ON because it is extremely da
• Do not touch the wheels when the swi
• Do not leave the vehicle or transmitter
periods of time, which may damage sens
.
1. Remove battery cover located at the back
near sources of heat or under direct sunlight
rking.
2. Insert 1 x 9V battery following the + / - ma
itive electronic instruments.
3. Replace battery cover.
children.
• Do not operate the vehicle near small
• Do not mix old and new batteries together
• Always select a safe place to play. Neve
• Non-rechargeable batteries are not to be r
. Do not mix battery type or brands.
r drive your vehicle in the street.
Vehicle
derside.
the + / - marking.
1. Open battery cover located at the un
echarged
9v
2. Insert 3 x 1.5V (AA) batteries following
3. Close battery cover.
y being charged.
• Rechargeable batteries are to be removed from the to
arged under adult supervision.
• Rechargeable batteries are only to be ch
• Only batteries of the same or equivalent t
• Batteries are to be inserted with the correct
• Exhausted batteries are to be removed from the to
ype as recommended are to be used.
Instructions fold inward
Trim Switch Control
Trim switch is located on the underside of the vehicle,
between the two front wheels. and is used to align the
wheels for consistent straight line driving.
polarity.
y.
cuited.
• The supply terminals are not to be short-cir
• Do not touch the motor after play, as it ma
y become hot during long period of playtime.
L
R
Download from Www.Somanuals.com. All Manuals Search And Download.
|