FCC Compliance
Troubleshooting
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable l interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
If the vehicle does not move:
1. Are the battery contacts matched correctly in the transmitter?
2. Are the metal contact tabs touching, rusty or dirty in the transmitter?
3. Are there batteries in the transmitter?
4. Is the power switch on the transmitter turned on?
5. Are the batteries exhausted?
RADIO-CONTROLLED VEHICLE
Battery and Other Information
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
•
Batteries should be installed or replaced only by an adult. Also wires and plugs should be
periodically checked by an adult.
•
•
•
Install batteries with the correct polarity.
Your car uses 3 AA alkaline batteries and one 9V battery for the transmitter, not included.
Do not mix alkaline, standard
Limited 90-DayWarranty
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free from any electrical or mechani-
cal defects for a period of 90 DAYS from the date of purchase. If any such defect is discovered within the warranty period,
EXCALIBUR ELECTRONICS, INC., will repair or replace the unit free of charge upon receipt of the unit, shipped postage
prepaid and insured to the factory address below. The warranty covers normal consumer use and does not cover damage that
occurs in shipment or failure that results from alterations, accident, misuse, abuse, neglect, wear and tear, inadequate
maintenance, commercial use, or unreasonable use of the unit. Removal of the top panel voids all warranties. This warranty
does not cover cost of repairs made or attempted outside of the factory. Any applicable implied warranties, including
warranties of merchantability and fitness, are hereby limited to 90 DAYS from the date of purchase. Consequential or
incidental damages resulting from a breach of any applicable express or implied warranties are hereby excluded. Some
states do not allow limitations on the duration of implied warranties and do not allow exclusion of incidental or consequential
damages, so the above limitations and exclusions in these instances may not apply. The only authorized service center in the
United States is:
(carbon-zinc) or rechargeable (nickel-metal hydride) batteries.
Do not mix old and new batteries.
Do not use rechargeable batteries.
Remove exhausted batteries from the unit.
Take caution when removing leaking or damaged batteries.
To avoid explosion or leakage, do not dispose of batteries in a fire or attempt to recharge
alkaline or other non-rechargeable batteries.
•
•
•
•
•
•
•
•
•
Leakage may occur if the battery is not used for an extended period of time.
Dispose of all batteries properly. Do not disassemble the batteries.
Do not short circuit battery terminals.
Remove batteries and store in a cool, dry place when not in use.
Excalibur Electronics, Inc.
13755 SW 119th Ave.
Miami, FL 33186 U.S.A.
Important Information
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Ship the unit carefully packed, preferably in the original carton, and send it prepaid, and adequately insured. Include a letter
detailing the complaint, along with your daytime telephone number, inside the shipping carton. If your warranty has expired
and you want an estimated fee for service, write to the above address, specifying the model and the problem.
PLEASE DO NOT SEND YOUR UNIT WITHOUT RECEIVING AN ESTIMATE FOR SERVICING. WE CANNOT STORE YOUR UNIT!
RSS-310 Compliance
This radiocommunication device complies with all the requirements of Industry Canada
Standard RSS-310.
THIS PRODUCT IS FOR THE USE IN U.K., SPAIN, GERMANY, FRANCE, BELGIUM, ITALY,
SWITZERLAND, THE NETHERLANDS, DENMARK, U.S., CANADA AND PORTUGAL.
Carrier Frequency: 27.145MHz
EXCALIBUR ELECTRONICS
CHOKING HAZARD
-
Small parts.
Field Strength: Vertical: 49.00 dBuV/m at 3m Horizontal: 29.30 dBuV/m at 3m
Carrier Frequency: 49.86MHz
Not suitable for children under 3 years.
Made In China
1:20
SCALE
Field Strength: Vertical: 72.70 dBuV/m at 3m Horizontal: 49.40 dBuV/m at 3m
MODEL # 9356
Excalibur Electronics, Inc.
13755 SW 119th Avenue • Miami, FL 33186
Tel: 305.477.8080 • Fax: 305.477.9516 • ww.ExcaliburElectronics.com
RADIO REPLICAS is a trademark of Excalibur Electronics, Inc.
MINI COOPER, MINI COOPER S, and all related emblems, and the distinctive vehicle model body and grille designs are
BMW Trademarks used under license to Zaptoys International Ltd. / Lucky Plastic and distributed by Excalibur Electronics,
Inc. Actual product may differ slightly from photograph.
INSTRUCTION MANUAL
Excalibur Electronics voids warranty.
Please read through this instruction manual carefully before starting to operate.
Please ensure to remove all accessories and components from packaging.
WARNING: Modifications not approved by
Operation
Interference
There is an OFF/ON switch on the transmitter and on the bottom of the car. (See illustrations
below.) Turn both switches to “on” for power. Switch the vehicle and transmitter off after use.
Re
It is advisable not to use the vehicle close to high tension wires or CB radios. Interference from
radio waves may affect the vehicle’s performance.
Helpful Hints
RADIO-CONTROLLED VEHICLE
AGES
•
Avoid heat, water or wet surfaces, dusty surfaces or sand.
Off-road vehicles run easier on grassy surfaces.
+
7
Instruction Manual
On/Off
•
•
•
Avoid hard-impact collisions. Collisions against hard surfaces may damage the vehicle.
The vehicle cannot operate on thick carpets or dusty floors.
If you wish to operate more than one vehicle at a time, you must purchase another vehicle
on another frequency.
If the car does not respond to the transmitter, move closer to the car and try again.
If the car starts to lose power, performance may decrease. If this happens, simply recharge
your car again.
Congratulations on your purchase of Excalibur Electronics’ Mini Cooper S 1:20 Scale Radio
Control Car. Now you can race anywhere with this super-fast, full-function 1:20 replica of the
real Mini Cooper S. Go in all directions with its smooth, fully directional steering, and enjoy
hours of fun. The radio transmitter is included.
Forward/
Reverse
Left/
Right
•
•
Your Mini Cooper S is easy to use, but be sure to use it safely. Before starting, please read this
manual thoroughly, especially noting safety, care and battery information. Keep this manual for
reference. This package includes 1 Mini Cooper S vehicle, 1 Transmitter and 1 User’s Guide.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules and R&TTE Directive 1999/5/EC. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference with radio
communications.
Note: Use caution when disconnecting the batteries, as improper handling may damage the unit.
What Is RequiredTo Play
How to Race
However there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning equipment off and on, the user should try to correct the interference by
one or more of the following measures:
Your transmitter (remote control) features two joysticks. The one on the left moves up
(forward) and down (reverse) to control the forward and backward motion of the car.
Press it up or down and hold to move your car. The joystick on the right moves to the right
and left to control the turning of your car.
Vehicle
Transmitter
Manual
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment and the receiver into different outlets.
Consult the dealer or an experienced radio/TV technician for help.
Range
Battery Installation
When the vehicle goes beyond radio signal contact, loss of control or slowness will
occur. Extend the transmitting antenna higher for better signal. Make sure the antenna
is screwed on tightly.
1. Push up (in the direction of the arrow) to unlock the
battery cover and lift.
Special Care & Handling
•
•
Avoid rough handling such as bumping or dropping.
2. Install 3 AA batteries, making sure to match the
polarity (+ and -) with the diagram on the inside of the
battery compartment.
Avoid moisture and extreme temperatures. For best results, use between the temperatures
of 39ºF and 100ºF (4º C and 38º C) and keep away from fire.
Trim Switch Control
•
Avoid using the vehicle for long periods under direct sunlight. Sunlight or excessive heat
may damage electronic parts.
The switch is located on the underside of the vehicle
between the two front wheels. It is used to align the
wheels so that vehicle drives consistently in a straight
line. If your car turns when it should go straight, adjust it
by turning the trim switch until the problem is eliminated.
3. Lower the battery cover and push down into place.
•
•
Store the vehicle transmitter in a dry, cool place away from heaters or warm areas.
Do not use cleaners with chemical agent. Clean using only slightly damp cloth. Then use a
dry cloth to wipe off the moisture. Dust, dirt, or other foreign objects can also be removed
from your vehicle by using a brush or by tying a small bit of cloth to the tip of a toothpick or
tweezers and using that to wipe off your car.
Transmitter Battery Installation
1. Push the battery cover down with your thumbs.
Instructions fold inward
2. Install a 9V battery, making sure to match the
polarity (+ and -) with the diagram on the inside of the
battery cover.
Battery Life
Extend the battery life by switching the unit off when not in use. Battery life affects how your car
responds. When the transmitter range decreases, replace the batteries in the controller.
3. Replace battery cover.
Download from Www.Somanuals.com. All Manuals Search And Download.
|