Special Features
TM
•
•
Convenient 2-ways to charge
Built-in Ni-MH rechargeable
battery
Flashlight
•
Charge by plugging directly
into any 120V AC
outlet or by turning the EZTM
Crank handle
ongratulations for
•
Automatically turns on
during a power outage
Nightlight indicator
Three super bright LED
bulbs provide up to 80
minutes of continuous light
Switch from single LED to
triple LED lights
purchasing Excaliburʼs
EZ CrankTM Power Failure
Flashlight. Whether youʼre
going to use it at home or while
traveling, this multi-function
light is the perfect tool in a
blackout, car breakdown, or any
other emergency. Featuring two
convenient ways to recharge,
this super-bright LED flashlight
always works and never needs
batteries! Youʼll want to keep
several of these multi-tasking
flashlights plugged in around
the house.
•
•
•
with the flip of a switch
EZ Crank
Handl e
LED Housing
MODE SELECT
Download from Www.Somanuals.com. All Manuals Search And Download.
To charge using an AC outlet:
for approximately one hour
at a speed of 120 revolutions
per minute.
3. Once fully charged, the flash
light will last approximately
80 minutes using single LED
light or 40 minutes using the
triple LED lights
4. For stubborn stains and to
maintain a bright,
NIGHTLIGHT
INDICATOR
AC Pl ug
1. Turn the swivel handle 90
degrees in order to
intensive beam of light,
use a damp cloth with
mild soap and water
to clean the transparent
bulb cover.
expose the polarized plug.
2. Rotate the plug 90 degrees
and insert directly into an
standard 120V AC outlet.
3. Fully charge the unit
for 24 hours.
4. Once fully charged, the
flashlight will last
approximately 80 minutes
using the single LED
90-DAY LIMITED
WARRANTY
Replacing the Ni-MH
Rechargeable Battery
SWIVEL HANDLE
EXCALIBUR ELECTRON-
ICS, INC., warrants to the original
consumer that its products are free
from any electrical or mechanical
defects for a period of 90 DAYS
from the date of purchase. If any
such defect is discovered within
the warranty period, EXCALI-
BUR ELECTRONICS, INC.,
will repair or replace the unit
free of charge upon receipt of
the unit, shipped postage prepaid
and insured to the factory address
shown below.
The warranty covers normal
consumer use and does not cover
damage that occurs in shipment
or failure that results from altera-
tions, accident, misuse, abuse,
neglect, wear and tear, inadequate
maintenance, commercial use,
or unreasonable use of the unit.
1. Using a flat head screw
driver, remove the battery
cover.
2. Disconnect the battery and
replace with a new Ni-MH
3.6V 80mAh battery.
Operating your Flashlight
light or 40 minutes using the
triple LED lights.
Using Mode Select :
5. When left plugged into the
AC outlet with the ON/OFF
switch set to the ON position,
the flashlight will turn on
automatically when there is a
power outage.
6. The red nightlight will
automatically turn on when
the unit is plugged in.
Click the mode select
switch once to make use
of a single LED. This
is useful to spotlight an area
but donʼt want or need to
use the maximum amount
of light.
3. Replace the battery cover.
Special Care and Handling:
1. Avoid excessive humidity,
moisture, and extreme
temperatures. For
best results, store the unit
between the temperatures
of 14° F and 122° F (-10°C
and 50° C).
2. Do not immerse the unit in
water.
3. Clean using only a damp
cloth. Do not use any
chemicals or solvents.
Click the mode select
switch one more time to
activate all 3 LED lights,
giving you the maximum
amount of light and
illumination.
To charge using the EZ Crank
handle:
1. Lift the EZ Crank handle and
turn clockwise.
2. Fully charge your flashlight
by turning the EZ Crank
Download from Www.Somanuals.com. All Manuals Search And Download.
|