EverFocus Security Camera EHD363 User Manual

EVERFOCUS  
Dual Power High Resolution Vandal Proof  
Weather Resistant 3-Axis IR Dome Camera  
Operation Instructions  
Model No. EHD363  
Please read this manual first for correct installation and operation. This manual should be retained for  
future reference. The information in this manual was current when published. The manufacturer reserves  
the right to revise and improve its products. All specifications are therefore subject to change without  
notice.  
PRECAUTIONS  
1. Do not install the camera near electric or magnetic fields.  
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers and audio speakers  
since the electromagnetic fields generated from these devices may distort the video image or otherwise interfere  
with camera operation.  
2. Never disassemble the camera beyond the recommendations in this manual nor introduce materials  
other than those recommended herein.  
Improper disassembly or introduction of corrosive materials may result in equipment failure or other damage.  
3. Try to avoid facing the camera toward the sun.  
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or internal circuits, as  
well as creating unbalanced illumination beyond the capability of the camera to compensate.  
4. Keep the power cord away from water and other liquids and never touch the power cord with wet  
hands.  
Touching a wet power cord with your hands or touching the power cord with wet hands may result in electric  
shock.  
5. Never install the camera in areas exposed to oil, gas or solvents.  
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.  
6. Cleaning  
For cameras with interchangeable lenses, do not touch the surface of the sensor directly with the hands. Use  
lens tissue or a cotton tipped applicator and ethanol to clean the sensor and the camera lens. Use a damp soft  
cloth to remove any dirt from the camera body. Please do not use complex solvents, corrosive or abrasive  
agents for cleaning of any part of the camera.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Weather resistant, IP66 rated  
Dual power: 12VDC/24VAC  
PACKAGE CONTENTS  
Camera Unit x 1  
Mounting kit includes:  
-Screws x 4  
-Security wrench for housing screws x 1  
-Expanding Anchors x 4  
-Washers x 4  
Operation Instructions (this document) x 1  
Weatherproof bushing x 1  
Power cable x 1  
Video cable x 1  
Power adapter pigtail (for NTSC model only) x 1  
Mounting template x 1  
SPECIFICATIONS  
Pickup Device  
Video Format  
Picture Elements  
Horizontal Resolution  
Sensitivity  
SONY 1/3” 960H EXview HAD II CCD High Resolution  
NTSC  
976 x 494  
700 TV line  
0.01Lux / F1.4; 0Lux / IR  
More than 54 dB  
S/N Ratio  
Electronic Shutter  
Video Output  
Gamma Correction  
Lens Type  
1/60s~1/100,000s  
BNC-F 1.0Vp-p 75  
0.45  
Vari-Focal 3.7~12mm / F1.4 DC Drive Auto Iris Lens  
True day/night with motorized IR cut filter  
Automatic  
Day/Night  
Gain Control  
White Balance  
Digital WDR  
Noise Reduction  
Sync. Mode  
ATW (1800°K~10500°K) with Anti-CR Function  
ATR On (Luminance and Contrast = High)  
2-D DNR (C Level 4, Y Level 4)  
Internal Sync.  
IR LED  
11 Units High Efficiency IR LED  
850nm  
IR Wavelength  
IR Distance  
30m (~98ft.) nominal; depends on environment  
IP 66  
Weather Resistant  
Vandal Proof  
Power Source  
Power Consumption  
IK10  
12VDC or 24VAC  
283mA @12VDC, 8W @ 24VAC  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
Operating Temperature  
Dimensions (O.D. x H)  
Weight  
-10°C~50°C / 14°F~122°F  
142mm x 115.5mm / 5.6” x 4.55”  
979 g / 2.16 lbs  
Certifications  
CE / FCC  
DIMENSIONS  
C
B
A
Dimensions  
Front View  
D
F
E
G
Bottom View  
Bottom View  
A. Lens  
E. Mounting holes  
F. BNC Connector  
G. DC Connector  
B. IR-LED  
C. Side conduit entry  
D. Back conduit entry  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
INSTALLATION INSTRUCTIONS  
Drill the Holes  
1. Locate the desired mounting location; position housing with camera pointed generally in the desired  
direction and mark location.  
2. Use template to fix hole locations. Drill 4 holes for mounting screws (or anchors and insert plastic  
anchors into holes after drilling as required).  
Mounting Steps  
1. Use the security wrench provided to loosen the 4 screws holding the dome cover.  
2. Remove the dome cover. (IF REAR WIRE MUST BE REMOVED/RELOCATED, SEE STEPS  
4~8) Attach the camera body to the mounting surface with the mounting screws provided  
3. Tighten the 4 mounting screws to secure the camera body to the mounting surface.  
4. If you need to wire cable through side conduit hole, use a coin to remove the conduit plug; save the  
plug as it will be used to close the rear conduit hole.  
Back conduit  
hole  
Conduit plug  
Side conduit hole  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
5. Disconnect the power and video wire from the camera board end of the wire (1x 4 pin white connector)  
and the 2 power wires from the power board attached to the base plate (1 x 2 pin connector with blue  
marking and 1 x 2 pin connector with white color). Gently pull the wires out from under the plate until  
they are free. Using wrench or pliers, remove the weather tight bushing from the rear conduit hole. Using  
the plug removed in step 3 above, close the rear conduit hole (additional caulk or other sealant  
recommended).  
6. Pass the camera end of the power/video cable through side conduit hole. Using wrench or pliers,  
carefully tighten the weather tight bushing into the side conduit hole.  
7. (Optional) Pass the power/video wires under the base plate and up through the center hole.  
8. Position the power/video wires so that they don’t interfere with the camera module and carefully  
attach the 4 pin white connector to the camera board, being sure to position the connector so it fits  
properly onto the tiny pins within. Next, attach the blue 2 pin connector and the white 2 pin connector to  
the matching color receptacles on the power board. NOTE: the 2 pin blue connector goes into the  
receptacle marked in blue on the power board. Failure to properly attach these connectors may  
permanently damage the camera.  
General Connection and Setup  
1. Connect the power cord to DC 12V or AC 24V power supply  
2. Use 75 ohm type coaxial cable to connect the camera to a monitor or DVR.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
3. Loosen the screws which lock the tilt mechanism. Rotate the pan and tilt mechanisms to point  
the camera in the desired direction. Rotate the camera module on its axis if necessary to align the  
image ‘upright’. Loosen the lens adjusting screws and adjust the lens to obtain the desired field of  
view and focus.  
Tilt lock  
2 places  
Lens adjustment  
Focus adjustment  
4. Lock the lens and tilt screws. Put the dome cover back and align the clear window in the dome  
cover with the lens. Attach the dome cover to dome base with the 4 mounting screws.  
NOTE: The cover only goes on in ONE direction. There is a key and slot; if not aligned, cover will not  
close properly.  
NOTE: If you move the camera module, it is necessary to loosen the dome and liner and reposition  
the liner so the lens points out through the slot, and the rubber seal presses onto the clear part of the  
dome and not the liner. Loosen 4 Philips screws, reposition liner, then TIGHTEN four cover attachement  
screws (else seal and vandal resistance is compromised).  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
EverFocus Electronics Corp.  
EverFocus Taiwan:  
EverFocus Europe - Germany:  
12F, No.79, Sec. 1, Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
Albert-Einstein-Strasse 1, D-46446  
Emmerich, Germany  
TEL: +886 2 2698 2334  
TEL: +49 2822 93940  
FAX: +49 2822 939495  
FAX: +886 2 2698 2380  
EverFocus China - Shenzhen:  
4F, No. 2, D4 Building, Wan Yelong  
Industrial Park, Tangtou Road, Shiyan,  
Baoan, Shenzhen, Guangdong 518101, China  
TEL: +86 755 2765 1313  
EverFocus China - Beijing:  
Room 609, Technology Trade Building,  
Shangdi Information Industry Base,  
Haidian District, Beijing 100085, China  
TEL: +86 10 6297 3336~39  
FAX: +86 755 2765 0337  
FAX: +86 10 6297 1423  
EverFocus USA - California:  
EverFocus USA - New York:  
1801 Highland Avenue, Unit A, Duarte, CA 91010,  
USA  
415 Oser Avenue, Unit S, Hauppauge, NY 11788, USA  
TEL: +1 631 436 5070  
TEL: +1 626 844 8888  
FAX: +1 626 844 8838  
FAX: +1 631 436 5027  
EverFocus Japan:  
EverFocus Europe - UK:  
5F, Kinshicho City Building, 2-13-4  
Koto-Bashi,Sumida-Ku, Tokyo, 130-0022, Japan  
TEL: +81 3 5625 8188  
Unit 12, Spitfire Business Park,  
Hawker Road, Croydon Surrey, CR0 4WD, UK  
TEL: +44 20 8649 9757 / +44 845 430 9999  
FAX: +44 20 8649 9907  
FAX: +81 3 5625 8189  
EverFocus India:  
Suite 803, Housefin Bhavan, C-21, Bandra Kurla  
Complex, Bandra (East), Mumbai 400051, India  
TEL: +91 22 6128 8700  
FAX: +91 22 6128 8705  
Ihr EverFocus Produkt wurde entwickelt  
und hergestellt mit qualitativ  
hochwertigen Materialien und  
Komponenten, die recycelt und wieder  
verwendet werden können.  
Dieses Symbol bedeutet, dass  
elektrische und elektronische Geräte am  
Ende ihrer Nutzungsdauer vom  
Hausmüll getrennt entsorgt werden  
sollen.  
Bitte entsorgen Sie dieses Gerät bei  
Ihrer örtlichen kommunalen  
Your EverFocus product is designed  
and manufactured with high quality  
materials and components which can  
be recycled and reused.  
This symbol means that electrical and  
electronic equipment, at their  
end-of-life, should be disposed of  
separately from your household waste.  
Please, dispose of this equipment at  
your local community waste  
collection/recycling centre.  
In the European Union there are  
separate collection systems for used  
electrical and electronic product.  
Please, help us to conserve the  
environment we live in!  
Sammelstelle oder im Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu  
erhalten, in der wir leben!  
August 2013  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  

Everpure Water System CGS 10 10 User Manual
EVGA Computer Hardware 121 LF E652 User Manual
FEIN Power Tools Drill ASze 648a User Manual
Fisher Price Crib X7035 User Manual
Frigidaire Dishwasher 154768701 User Manual
Frigidaire Dishwasher 154811101 User Manual
Futrex Scale 5500A WL User Manual
GE Washer WWA8657R User Manual
Giant Water Pump GP8045 User Manual
Goodman Mfg Heat Pump GSZ11 User Manual