Setup
Tube
1
• Slide a tube through one of the sleeves on
the quilt.
Hint: You may need to adjust the fabric on the
sleeve after you insert the tube.
• Repeat this procedure to attach the
remaining tubes.
Tab
Elastic Loop
3
• Insert the foot at the bottom of each tube
through the elastic loops on the quilt.
• Make sure the elastic loop is fitted below the
tab on each tube.
Hub
Tube
2
• Insert the ends of the tubes into the sockets in
4
the hub. Make sure you hear a "snap".
• Pull each tube to be sure it is secure to the hub.
• Hang the toys from the loops around the gym.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Safety Information
FCC Statement
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn injury
or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of product in a fire. The batteries
inside may explode or leak.
United States Only
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
ICES-003
This Class B digital apparatus complies with
Canadian ICES-003.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
NMB-003
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
L’utilisation de ce dispositif est autorisée seulement
aux conditions suivantes : (1) il ne doit pas
produire de brouillage et (2) l’utilisateur du
dispositif doit être prêt à accepter tout brouillage
radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fonctionnement
du dispositif.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
T4264pr-0920
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
Music, Lights and
Ocean Friends!
1,5V x 3
“AA” (LR6)
Mode Button
• Slide the power/volume switch on the top of
the hub to ON with low volume , or ON with
• Locate the battery compartment on the top of
the hub.
• Loosen the screws in the battery compartment
door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three, new “AA” (LR6) alkaline batteries.
Hint: We recommend alkaline batteries for
longer battery life.
high volume
.
• Press the mode button to play up to 20 minutes
of fun sounds and lights!
• Press the button again to turn long play mode
off and let baby's movement activate sounds
and lights!
• When you are finished playing with this toy,
slide the power/volume switch OFF
.
• Replace the battery compartment door and
tighten the screws.
• If this product begins to operate erratically,
you may need to reset the electronics. Slide the
power switch off and then back on.
• When sounds or lights from this toy become
faint or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Storage
PRESS
Hub
Tube
3
• Fold the quilt in half, as shown.
• Then, fold in half again.
1
Storage Strap
Storage Loop
• Press the button above each tube on the hub to
release the tubes.
4
• Slide one end of the storage strap through the
storage loop.
• Fasten the ends of the storage strap.
Hub
2
• Lay the tubes across the center of the quilt.
• Place the hub under one of the mesh arches,
as shown.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
|