with remote control
Product Number: B3001
Please keep this instruction sheet for future reference,
as it contains important information.
Projector requires four "D" (LR20) alkaline batteries (not included).
Requires one KRP 113 Krypton light bulb (included).
Remote controller requires two (LR44) button cell batteries (included).
Adult assembly is required for battery installation and bulb replacement.
Tool required for battery installation and bulb replacement:
Please keep this instruction sheet for future reference,
Phillips screwdriver (not included).
as it contains important information.
No assembly is required.
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Replacement – Remote Controller
Battery Safety Information
Batteries may leak fluids that can
cause a chemical burn injury or ruin
your toy. To avoid battery leakage:
• Do not mix old and new batteries
Battery
Compartment
or batteries of different types:
alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium).
• Insert batteries as indicated
either inside or outside the
battery compartment.
• Remove batteries during long
periods of non-use. Always
remove exhausted batteries
from the toy. Dispose of batteries
safely. Do not dispose of batteries
in a fire. The batteries may
explode or leak.
• Never short-circuit the battery
terminals.
• Use only batteries of the same or
equivalent type, as recommended.
1.5V x 2 LR44 or Equivalent
Shown Actual Size
• Locate the battery compart-
ment on the side of the
remote controller.
• Do not charge non-rechargeable
batteries.
• Loosen the screw in the battery
compartment door with a
Phillips screwdriver. Remove
the battery compartment door.
• Remove rechargeable batteries
from the toy before charging.
• Insert two button cell (LR44)
alkaline batteries.
Hint: We recommend using
alkaline batteries for longer life.
• If removable, rechargeable batter-
ies are used, they are only to be
charged under adult supervision.
• Replace the battery compart-
ment door and tighten the
screw with a Phillips screw-
driver. Do not over-tighten.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Light Bulb Replacement
CAUTION
To prevent burns from hot bulb, let bulb
cool for several minutes before replacing.
Bulb Sleeve
Bulb
IMPORTANT! Should the light bulb stop
working, an adult should remove it and
replace it.
• Loosen the screws in the battery compartment with a Phillips screwdriver
and remove the door.
• Remove the batteries.
• Loosen the screw in the bulb compartment door with a Phillips screw-
driver and open the door.
• Remove the bulb sleeve from the bulb compartment.
• Pull to remove the light bulb. Beware of cracked or broken glass.
• Insert a new, KRP113 Krypton bulb (or equivalent) into the bulb sleeve.
• Place the bulb sleeve back in the bulb compartment.
• Close the bulb compartment door and tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Replace the four size "D" (LR20) alkaline batteries as indicated inside
the battery compartment.
• Replace the battery compartment door and tighten the screws with
a Phillips screwdriver. Do not over-tighten.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Put On A Show Tonight!
Power
Switch
1
3
Advance Lever
Focus Ring
• Press the advance lever once
to align the reel.
• Slide the power switch forward
to turn the projector on.
• Turn the focus ring until the
image is sharp.
Remote Controller
4
2
• Remove the remote controller
from under the handle.
• Insert any View-Master® reel into
the slot near the projector lens.
Be sure to push the reel all the
way in.
• To remove the reel, simply pull
the reel straight up.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
PRESS
5
Remote Controller
• Point the remote controller
at the projector and press
the button to advance to the
next frame.
Hints:
• The remote controller works
best when you have a clear
path between the remote
controller and the projector
with no obstructions.
• The maximum range of the
remote controller is about
Advance
Lever
• You can also change pictures by
pushing the advance lever on
the projector.
• If you do not advance the reel
for a few minutes, the projector
shuts off automatically. Press the
advance lever on the projector
to turn it on again.
• It is normal for the projector
to be warm to the touch after
extended periods of use.
10 feet. If you find the range of
your remote controller is greatly
reduced, battery power in the
remote controller may be weak.
Replace both batteries in the
remote controller with fresh,
new alkaline batteries.
• After the show, snap the
remote controller back under
the handle for storage.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Fun Tips
• For the steadiest picture show, place the projector on a hard flat surface.
• Make sure the room is completely dark for the best possible image.
• You can turn the projector into a flashlight by simply removing the reel.
Care
• Wipe this toy with a clean cloth dampened with a mild soap and water
solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this toy apart.
• Do not drop this toy on a hard surface.
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manu-
facturer responsible for compliance could void the user's authority to
operate the equipment.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Questions? We’d like to hear from you!
Call Fisher-Price® Consumer Relations, toll-free at
1-800-432-5437, 8 AM - 6 PM EST Monday through Friday.
Hearing-impaired consumers using TTY/TDD equipment, please
call 1-800-382-7470. Or, write to: Fisher-Price® Consumer
Relations, 636 Girard Avenue, East Aurora, New York 14052.
For countries outside the United States:
CANADA
Questions? 1-800-567-7724, Mattel Canada Inc., 6155 Freemont Blvd., Mississauga,
Ontario L5R 3W2.
GREAT BRITAIN
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302.
AUSTRALIA
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA
Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
View-Master® and View-Master Logo are U.S. trademarks of Mattel, Inc.
Printed in China
B3001a-0920
Download from Www.Somanuals.com. All Manuals Search And Download.
|