Fisher Price Baby Accessories P6033 User Manual

P6033  
WARNING  
IMPORTANT! KEEP INSTRUCTIONS  
FOR FUTURE REFERENCE.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Parts  
Assembly  
IMPORTANT! Before assembly, inspect this product for damaged  
hardware, loose joints, missing parts or sharp edges. DO NOT use  
if any parts are missing or broken. Contact Mattel for replacement  
parts and instructions if needed. Never substitute parts.  
CAUTION  
This package contains small parts in  
its unassembled state. Adult assembly  
is required.  
Front Leg  
Back Leg  
IMPORTANT! Please remove all parts from the package and identify  
them before assembly. Some parts may be packed in the pad.  
1
• Slide the front and back legs on the swing frame outward until  
they "click" into place.  
• Repeat this procedure to open the other swing frame.  
2 Swing Frames  
Press Buttons on Front Legs  
Seat Frame  
Base Tube  
2
2 Base Tubes  
Seat Pad  
• While pressing the buttons on the end of each front leg, insert the  
front legs into the ends of one of the base tubes.  
• Push the front legs down into the base tube until the buttons  
"click" into place.  
Note: Tighten or loosen all screws with a Phillips screwdriver.  
Do not over-tighten the screws.  
#6 x 3 cm Screw – 2  
Shown Actual Size  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
PULL UP  
PULL UP  
Base Tube  
3
Base Tube  
5
• While standing on the base tube, pull the front legs up. The front  
legs should remain secured to the base tube. If you can remove  
the front legs, you have not assembled them correctly to the base  
tube. Re-read and repeat assembly step 2.  
• While standing on the base tube, pull the back legs up. The back  
legs should remain secured to the base tube. If you can remove  
the back legs, you have not assembled them correctly to the base  
tube. Re-read and repeat assembly step 4.  
Seat Frame  
Press Buttons  
on Back Legs  
Base Tube  
4
Seat Hubs  
Frame Arm  
• While pressing the buttons on the end of each back leg, insert the  
back legs into the ends of the remaining base tube.  
• Push the back legs down into the base tube until the buttons  
"click" into place.  
Socket  
6
• Position the seat frame so that the tubes are upright, as shown.  
Hint: Note the location of the socket inside each seat hub.  
The ends of the frame arms will be inserted into these sockets.  
• Fit the end of each frame arm into the socket in each seat hub.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Seat Hub  
Slots  
Waist Belt  
Seat Hub  
7
• Insert a screw through the outside of each seat hub and into  
each frame arm. Tighten the screws.  
Fasteners  
9
• From behind the assembly, insert the waist belts through the  
slots in the pad.  
• Press to fasten the waist belt assembly to the pad.  
Pad Upper Pocket  
Pad Lower Pocket  
Seat Bottom Tube  
Seat Back Tube  
10  
Waist Belts  
8
• Fit the pad lower pocket onto the seat bottom tube, as shown.  
• Fit the pad upper pocket over the seat back tube.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Battery Installation  
Battery Safety Information  
In exceptional circumstances batteries may leak fluids that can  
cause a chemical burn injury or ruin your product. To avoid  
battery leakage:  
• Do not mix old and new batteries or batteries of different types:  
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).  
• Insert batteries as indicated inside the battery compartment.  
• Remove batteries during long periods of non-use. Always remove  
exhausted batteries from the product. Dispose of batteries safely.  
Do not dispose of product in a fire. The batteries inside may  
explode or leak.  
Battery Compartment Door  
1,5V x 4  
LR14 (“C”)  
• Never short-circuit the battery terminals.  
• Use only batteries of the same or equivalent type, as recommended.  
• Do not charge non-rechargeable batteries.  
• Remove rechargeable batteries from the product before charging.  
• If removable, rechargeable batteries are used, they are only to be  
charged under adult supervision.  
• Locate the battery compartment door on the frame.  
• Loosen the screws in the battery compartment door.  
• Remove the battery compartment door.  
• Insert four LR14 ("C") alkaline batteries.  
Hint: We recommend using alkaline batteries for longer  
battery life.  
• Replace the battery compartment door and tighten the screws.  
• If this product begins to operate erratically, you may need to reset  
the electronics. slide the power switch off and then back on.  
Note: Low battery power may cause product movement to slow  
and sound volume to become faint or turn off all together. If this  
should happen, please remove and discard all four batteries  
and replace with four, new LR14 ("C") alkaline batteries.  
• Protect the environment by not disposing of this  
product with household waste (2002/96/EC).  
Check your local authority for recycling advice and  
facilities (Europe only).  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Securing Your Child  
Restraint System  
WARNING  
To prevent serious injury from  
falls and being strangled in the  
restraint system:  
• Always use the restraint system.  
• Not recommended for children who  
can sit up by themselves (6 months  
approximately, until 9 kg/20 lbs).  
• Never leave child unattended.  
• It is dangerous to use this product  
on an elevated surface.  
2
• Tighten each waist belt so that the restraint system is snug  
against your child. Please refer to the next section for instructions  
to tighten the waist belt.  
Waist Belt  
Anchored End  
Anchored End  
Buckle  
Free End  
Free End  
Restraint Pad  
TIGHTEN  
LOOSEN  
3
1
To tighten the belts:  
• Feed the anchored end of the belt up through the buckle to form  
• Place your child in the seat. Position the restraint pad between  
your child’s legs.  
A
a loop . Pull the free end of the belt B . Repeat this procedure  
to tighten the other belt.  
To loosen the belts:  
• Fasten both waist belts to the buckles on each side of the  
restraint pad.  
• Feed the free end of the belt up through the buckle to form  
Make sure you hear a "click" on both sides.  
A
a loop . Enlarge the loop by pulling on the end of the loop  
• Check to be sure the restraint system is securely attached  
by pulling it away from your child. The restraint should  
remain attached.  
IMPORTANT! The maximum weight limit for this product is  
9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs), but is  
really active and appears to be able to climb out of the swing,  
immediately discontinue its use.  
toward the buckle. Pull the anchored end of the belt to shorten  
the free end of the belt B . Repeat this procedure to loosen the  
other belt.  
Please Note: After adjusting the belts to fit your child, make sure  
you pull on them to be sure they are securely fastened.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Starting the Swing  
Storage  
IMPORTANT! Before each use, inspect this product for damaged  
hardware, loose joints, missing parts or sharp edges. DO NOT use  
if any parts are missing or broken. Contact Mattel for replacement  
parts and instructions if needed. Never substitute parts.  
Power Switch  
• Lift the seat bottom.  
• Slide the power switch to any of five speed settings.  
• Give the seat a light push to start the swinging motion. Adjust  
the power switch to the desired swing motion setting.  
Hint: As with most battery-powered swings, a heavier child will  
reduce the amount of swinging motion on all settings. In most  
cases, the low setting works best for a smaller child while the high  
setting works best for a larger child.  
• If swinging stops while using a lower setting, try a higher setting.  
Give the seat a light push to start the swinging motion again.  
• Be sure to turn this product off when not in use. Slide the power  
switch to the off setting O.  
• Press the frame release buttons on the inside of the frames and  
push the front legs inward.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cobra Digital GPS Receiver 7750 PLT User Manual
Cooper Lighting Indoor Furnishings 196 User Manual
Cornelius Ice Maker 620046139 User Manual
Curtis MP3 Docking Station IP202UK User Manual
CyberData Speaker VoIP Ceiling Speaker User Manual
Delta Electronics Power Supply 1411 User Manual
Delta Electronics Power Supply STQ127 User Manual
Fellowes Paper Shredder PDS 1 User Manual
Fisher Price Doll 78157 User Manual
GE Ventilation Hood SCA2000BBB User Manual