EverFocus Security Camera EZ350 User Manual

EVERFOCUS  
1/3” 560 TVL Bullet Style  
Weatherproof Color Camera  
Operation Instructions  
Model No. EZ350  
Please read this manual first for correct installation and operation. This manual should be retained  
for future reference. The information in this manual was current when published. The  
manufacturer reserves the right to revise and improve its products. All specifications are therefore  
subject to change without notice.  
PRECAUTIONS  
1. Do not install the camera near electric or magnetic fields.  
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,  
audio speakers since the magnetic fields generate from above devices will distort the video  
images.  
2. Never disassemble the camera nor put impurities in it.  
Disassembly or impurities may result in trouble or fire.  
3. Never face the camera toward the sun.  
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.  
4. Keep the power cord away from water and liquid.  
Touching the wet power cord may result in electric shock.  
5. Never install the camera in areas exposed to water, oil or gas.  
Water, oil or gas may result in failure, electric shock or fire.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
SPECIFICATIONS  
Pickup Device  
1/3'' SONY Super HAD CCD  
NTSC or PAL  
Video Format  
NTSC: 525 TV lines, 60 fields/sec  
PAL: 625 TV lines, 50 fields/sec  
768 x 494(NTSC) ; 752 x 582(PAL)  
560TVL  
Scanning System  
Picture Elements  
Horizontal Resolution  
Sensitivity  
0.5Lux/F=1.2  
S/N Ratio  
Over 48dB(AGC off)  
Electronic Shutter  
Lens Type  
1/50(1/60)~1/100,000  
Vari-focal lens, Auto Iris  
f=3.8~9.5mm/F=1.2 , f=9~22mm/F=1.6  
*Lens models and availability vary in different regions  
ON/OFF Switch  
Back Light Comp.  
Auto Gain Control  
Flickerless  
ON/OFF Switch  
ON/OFF Switch  
Auto White Balance  
Gamma Correction  
Video Output  
Sync. Mode  
Yes  
0.45  
BNC 1.0Vp-p , 75ohm  
Line Lock/Internal Sync  
Yes, built-in  
Heater  
Weatherproof  
Power Source  
IP66  
12VDC/24VAC  
24VAC: 6VA max. (Heater OFF)  
24VAC: 12.5VA max. (Heater ON)  
12VDC: 4W max. (Heater OFF)  
12VDC: 7.5W max. (Heater ON)  
With sun shield : 90.7 mm(W) x 70mm(H) x 172mm(L);  
3.57”(W) x 2.8"(H) x 6.8"(L)  
Without sun shield: 132mm(L) x 57mm(O.D);  
5.2"(L) x 2.2"(O.D)  
Power Consumption  
Dimensions  
Weight  
0.71 kg ; 1.6 lbs  
0.91 kg ; 2 lbs (with bracket)  
-40°C~50°C ; -40°F~122°F (20%~80% Humidity)  
Yes, 10°C On / 20°C Off  
FCC/CE  
Operating Temperature  
Heater Activation Temp:  
Certifications  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
DIMENSIONS  
MAJOR PARTS NAME & THEIR FUNCTIONS  
Back Fixing Plate  
Swivel  
Screw  
Mounting  
Base  
Sun Shield  
Cover  
Assembly  
Screw  
Fixing Screw  
Front  
Fixing Plate  
IRIS ALC/Level Adjustment  
O-ring Seal  
Focus Zoom  
Lens  
Heater  
Mounting Bracket  
Control Switch  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
INSTALLATION  
1. Using the supplied screws, mount the bracket base on the desired location.  
2. Connect the BNC connector of the camera to a monitor or other video device through a 75 ohm  
type coaxial cable with BNC female connector at cable extension.  
3. Connect the 24VAC or 12VDC regulated power source of the camera (power jack) to the  
power-in jack with 2mm plug. For 12VDC power source, please make sure the power plug is  
center+ outer- for heater normal operation.  
4. If the factory settings are out of focus, or any other adjustment is required, follow the  
procedures below.  
a. Remove the fixing screw in the front, which hold the sun shield cover. Remove the sun  
shield cover.  
b. Twist open and carefully remove the housing cover.  
(Please pay attention to prevent damage to the “O”-Ring seal.)  
c. Loosen the focal lens and focus locking screws.  
d. Adjust the lens to bring the subject into focus.  
(Caution: Heater elements could be hot! When camera power is on, be cautious with camera  
adjustment.)  
e. Retighten the screws.  
f. Please refer to the Settings section for the details of the other adjustments. Adjust accordingly  
if necessary.  
g. When all the adjustments and settings are completed, overlaying the cover gently. Be careful  
not to damage to the “O”-Ring and camera components.  
h. To reassemble the sun shield, match the hole on the sun shield to the back fixing plate of  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
camera, fix the screw on the front fixing plate. Make sure the wider side of the fixing plate  
holds the edge of the camera well.  
5. Attach the camera onto the mounting bracket.  
6. Loosen the swivel screw and point the camera to the desired direction.  
7. Tighten the swivel screw. To strengthen the fixing power of the swivel screw, tighten the  
set-screw with the set-screw wrench (supplied).  
Notes:  
(A) Make wiring connections only when it is determined that power is in a disconnected  
status.  
(B) There is a desiccant pack attached to the housing base under the camera which is  
designed to absorb any moisture trapped inside the housing during adjustment. To  
avoid excessive moisture build up, it is recommended to avoid rainy or excessively  
damp conditions during installation of camera. It is also advisable to limit the  
frequency of removing the housing cover. The desiccant pack can be replaced if  
condensation develops inside the housing.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
SETTINGS  
The camera is set up at factory and normally requires no adjustments. However, adjustments  
may be necessary in some cases. Please refer to the following description for the function details.  
The IRIS ALC and IRIS Level adjustments are located on the side circuit board, use a  
screwdriver to adjust if it is necessary.  
IRIS Level  
Adjustment  
IRIS ALC  
Adjustment  
DIP Switch  
IRIS Level Adjustment  
To adjust iris level –  
Turn the IRIS Level Adjustment VR counterclockwise to get darker picture.  
Turn the IRIS level adjustment VR clockwise to get brighter picture.  
IRIS ALC Adjustment  
To select light metering method –  
Turn the IRIS ALC Adjustment VR counterclockwise for Average Metering.  
Turn the IRIS ALC Adjustment VR clockwise for Peak Metering.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
The 4 DIP switch also locate on the side circuit board, they are Flickerless, Back Light Comp,  
Auto Gain Control and Line Lock accordingly.  
Normal  
FL  
On  
On  
On  
On  
Normal  
Off  
BLC  
AGC  
Off  
LL  
DIP switch  
FL(Flickerless) ON/OFF  
When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of electronic  
shutter at 1/100(NTSC) or 1/120(PAL) automatically, and reduce the flicker immediately. The  
default setting is Off.  
BLC (Back Light Compensation) ON/OFF  
When BLC is turned on, the AGC, ES and IRIS operating points are determined by averaging  
over the center area instead of entire field-of-view, so that foreground object at center area can be  
clearly distinguished from brightly backgrounds.  
BLC should not be used unless it is needed to compensate for strong backlight. The default setting  
is Off.  
AGC (Automatic Gain Control) Off/On  
AGC ON: The sensitivity increases automatically when light is low.  
AGC OFF: A-low-noise picture is obtained under a low light condition.  
The default setting is ON.  
LL (Line-Lock) Off/On  
To select the sync mode between Internal Sync.(LL off) and Line-Lock (LL on).  
Set the line-lock off, the camera will synchronize to the internal time base. Set the line-lock on,  
the camera’s vertical synchronization can be driven by the AC signal in the power lines.  
The default setting is Off.  
Note: Line-Lock sync mode operation is working only when used with an AC power source; it is  
not working with a DC power source.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
SIMPLE INSTRUCTIONS FOR THE DESICCANT PACK  
Due to the camera lens blurred from the humidity inside the camera. The desiccant pack is  
therefore attached to absorb the humidity. Easy instruction is as follow:  
Adjust all settings first and place the desiccant pack into the gap of the machine and fix it.  
Install the cover and overlaying gently.  
Installation steps:  
Step 1.  
Desiccant pack  
Step 2.  
Install the cover and  
overlaying gently  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
EverFocus Electronics Corp.  
Head Office:  
Europe Office:  
12F, No.79 Sec. 1 Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
TEL: +886-2-26982334  
FAX: +886-2-26982380  
Albert-Einstein-Strasse 1  
D-46446 Emmerich, Germany  
TEL: 49-2822-9394-0  
China Office:  
USA L.A. Office:  
Room 609, Technology Trade Building,  
Shangdi Information Industry Base, Haidian  
District, Beijing,China 10085  
TEL: +86-10-62973336/37/38/39  
FAX: +86-10-62971423  
1801 Highland Ave. Unit A  
Duarte, CA 91010, U.S.A.  
TEL: +1-626-844-8888  
FAX: +1-626-844-8838  
Japan Office:  
USA N.Y. Office:  
1809 WBG MARIBU East 18F,  
2-6 Nakase.Mihama-ku.  
Chiba city 261-7118, Japan  
TEL: +81-43-212-8188  
FAX: +81-43-297-0081  
415 Oser Avenue Unit S  
Hauppauge, NY 11788  
TEL: 631-436-5070  
FAX: 631-436-5027  
Your EverFocus product is designed and  
manufactured with high quality materials and  
components which can be recycled and  
reused.  
Ihr EverFocus Produkt wurde entwickelt und  
hergestellt mit qualitativ hochwertigen  
Materialien und Komponenten, die recycelt  
und wieder verwendet werden können.  
Dieses Symbol bedeutet, dass elektrische und  
elektronische Geräte am Ende ihrer  
Nutzungsdauer vom Hausmüll getrennt  
entsorgt werden sollen.  
This symbol means that electrical and  
electronic equipment, at their end-of-life,  
should be disposed of separately from your  
household waste.  
Please, dispose of this equipment at your  
local community waste collection/recycling  
centre.  
Bitte entsorgen Sie dieses Gerät bei Ihrer  
örtlichen kommunalen Sammelstelle oder im  
Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu erhalten, in  
der wir leben!  
In the European Union there are separate  
collection systems for used electrical and  
electronic product.  
Please, help us to conserve the environment  
we live in!  
P/N: MZ35G00600_Ver.C  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  

Clarion Car Video System VMA6491 User Manual
Cobra Digital Digital Camera DC4200 User Manual
Cuisinart Blender SP 2 User Manual
Digital Spectrum Digital Photo Frame 800 PLUS User Manual
Dimplex Thermostat MCN20 User Manual
Dixon Lawn Mower ZTRCLASSIC User Manual
Dual Marine RADAR MXD25 User Manual
Fisher Price High Chair V3393 User Manual
Fusion Radio Antenna 21 User Manual
GE Air Conditioner 4100 User Manual