Dualit Hot Beverage Maker Dome Kettle User Manual

2006 Dome Kettle_1.pdf  
23/8/06  
9:46:14 am  
9088DomeKettle.qxp 5/12/2006 10:28 Page 1  
Make sure that your hands are  
clean and free from hand cream,  
soap or similar, which might leave  
a slight taint to the water.  
If the powercord is damaged it must  
be replaced by a special cord set  
available from Dualit or an  
authorised Dualit service agent.  
This part should only be refitted  
by a competent electrician.  
4
CARE AND CLEANING  
Minimise Scale Build-up  
Switch the kettle off (lift it from the  
power base), unplug the power  
base from the wall socket, and let  
the kettle cool down completely  
before cleaning. Wipe the outside  
and inside surfaces of the kettle  
with a damp cloth.  
Empty the kettle after each use;  
do not allow water to stand in the  
kettle overnight; use filtered water  
instead of tap water.  
Remove the kettle from the power  
base and ensure kettle is cold.  
Descale the kettle regularly, at least  
once a month, using a proprietary  
brand of descaler. In areas of very  
hard water descaling may be  
necessary more often.  
1
If it still does not work, telephone  
the Dualit Customer Helpline on:  
+ 44 (0) 1293 652 500 or the  
shop where you bought it.  
In the USA call Dualit Helpline:  
973 623 9370  
Open the lid. Hold the top of the  
filter and pull it gently up and out  
of the kettle. Rinse it under a tap  
whilst softly brushing it with a soft  
brush. Rinse the kettle out with  
fresh water.  
Safeguards  
If necessary, you may use a little  
household detergent. To clean the  
filter, see “Water filter” below.  
C
M
2
Before Use  
3
When descaling, follow the  
instructions on the packet of the  
descaler. When descaling has  
finished, empty the kettle and rinse it  
out numerous times with fresh water,  
then refill with freshwater, boil,  
and discard boiled water.  
If you use detergent inside the  
kettle, rinse thoroughly afterwards  
to remove all traces.  
Y
To replace, align the sides of the  
filter with the grooves in the filter  
holder, and slide it slowly  
6
GUARANTEE  
How To Use  
Ensure that all connectors and  
sockets are kept dry.  
CM  
MY  
CY  
CMY  
K
Any defect affecting the functionality  
of the appliance which becomes  
apparent within one year of its  
purchase will be corrected by free  
repair or replacement provided that  
it has been used and maintained in  
accordance with the instructions and  
has not been abused or misused  
in any way.  
4
downwards and back into place.  
Do not immerse the kettle or power  
base in water or any other liquid.  
Care And Cleaning  
Water Filter  
5
AFTER SALES SERVICE  
GUARANTEE AND  
IN S T R U C T I O N S  
F O R D U A L I T  
DOME K E T T L E  
Depending upon the hardness of the  
water the scale particles that remain  
suspended in the water may give a  
cloudy appearance. The filter fitted to  
your kettle will help prevent these  
particles passing into your drink. You  
therefore must ensure that the filter is  
kept clean and clear of deposits,  
otherwise the performance of the filter  
may be affected, your drinks may  
contain scale and the water inside the  
kettle may look cloudy.  
5
Do not use harsh or abrasive  
cleaners or solvents.  
If the kettle is not working correctly,  
check that:  
After Sales Service  
Descaling  
You have followed the  
instructions correctly.  
6
Scale build-up will cause the  
element to overheat, reducing its  
working life. It may also cause the  
safety cutout to operate  
prematurely, switching the kettle off  
before the water actually boils.  
Guarantee  
The plug fuse has not blown.  
This warranty does not cover any  
consequential damages.  
Your statutory rights are not affected.  
The main supply fuse/circuit  
breaker has not blown/tripped.  
As the kettle uses an under floor  
type element, lime scale can only  
build up on the walls and floor of  
the kettle, this is readily seen and  
should be promptly dealt with.  
You should clean the filter whenever  
there are any obvious deposits left  
on the mesh and especially if  
pouring is affected.  
DUALIT LIMITED COUNTY OAK WAY CRAWLEY WEST SUSSEX RH11 7ST  
TELEPHONE: +44 (0) 1293 652 500 FACSIMILE: +44 (0) 1293 652 555  
EMAIL: info dualit.com WEB: www.dualit.com  
@
DDK110506  
Download from Www.Somanuals.com. All Manuals Search And Download.  
9088DomeKettle.qxp 5/12/2006 10:28 Page 2  
Please read these instructions before  
using your kettle, keep them in a safe  
place for future reference.  
Carefully remove all packaging  
before use but keep the packaging  
until you are satisfied that the kettle is  
working correctly.  
Do not switch on unless the kettle  
Use the kettle only with the power  
Replacement fuses are available  
from Dualit and should be ASTA  
approved to BS 1362.  
Replace the lid and ensure it is  
firmly in place. Check that it is  
fully closed, otherwise the kettle  
may not switch off when boiling.  
Remove the kettle from the power  
base before attempting to pour.  
contains at least 1 cupful of water.  
base supplied and vice versa.  
Do not allow the mains lead to  
hang over the edge of the worktop,  
or anywhere it may accidentally be  
caught or tripped over.  
Do not operate any appliance with a  
damaged lead or plug, or after the  
appliance malfunctions, or has been  
damaged in any manner.  
If the mains lead is damaged, it must  
be replaced by a special cordset  
available from Dualit helpline:  
When filling or carrying the kettle,  
do not tilt it backwards, as this may  
allow water to pass through the  
steam tube onto the control area.  
Should this happen, the kettle must  
be allowed to dry before reuse.  
3
HOW TO USE  
Switching On  
Position the power base as close to  
a wall socket as possible. Locate  
the mains cable so that it does not  
overhang the work surface, and  
cannot be caught accidentally.  
Shorten the mains lead by winding  
it around the cord storage area  
under the power base, and bring it  
out of the cord exit in the base.  
Check that the switch is in the  
“Off” position (lift the kettle  
from the power base and set it  
down again taking care not to  
spill any water). The switch will  
only operate when the kettle is  
correctly fitted onto the base.  
Close supervision is necessary when  
any appliance is used near children.  
1
IMPORTANT  
SAFEGUARDS  
Do not leave appliance unattended  
when in use.  
+ 44 (0) 1293 652 500  
To avoid the risk of splashing, pour  
slowly and do not over-tilt the kettle.  
When using any electrical  
appliances, basic safety precautions  
should always be followed, including  
the following:  
SAVE THESE  
INSTRUCTIONS  
This appliance is not intended for  
use by young children or infirm  
persons without supervision.  
Plug the power base into the  
wall socket. If necessary, switch  
on the wall socket.  
Opening the Lid  
WARNING: IF THE KETTLE HAS  
JUST BOILED, IT WILL BE FULL OF  
STEAM, WHICH WILL ESCAPE AS  
SOON AS THE LID IS OPENED.  
2
BEFORE USE  
This kettle is for household  
use only.  
READ ALL  
INSTRUCTIONS  
Remove the kettle from the power  
base. If the switch has been  
pushed down inadvertently, it will  
spring up into the “off” position.  
Remove all packaging from the kettle  
and its power base. Before using the  
kettle for the first time, or if it has been  
out of use for a long time, fill to the  
max mark and boil, then discard the  
boiled water and rinse the kettle out  
with fresh cold water.  
Press the switch down. The neon  
light will light up and the kettle  
will start to heat up.  
Unplug the power base from the  
wall socket when not in use,  
before moving and cleaning.  
Allow the kettle to completely cool  
down before cleaning and storing.  
To be protected against electrical  
hazards do not immerse the mains  
lead, plug, power base, or kettle  
in water or any other liquid.  
Boil Dry  
Hold the kettle handle firmly in one  
hand, hold the lid knob in the other,  
and pull the lid straight up. As soon  
as it separates from the kettle,  
When the water has boiled the  
kettle will automatically switch off,  
the switch will return to the “Off”  
position and the neon light will  
go out.  
Do not switch the kettle on unless it  
contains at least one cup of water.  
Misuse of this kind will shorten the  
life of the kettle.  
Ensure that the lid is fully closed before  
switching the kettle on, otherwise it  
may not properly switch off.  
Do not use in a bathroom or  
outdoors.  
move it out of the rising steam.  
Connection To The Mains Supply  
Filling  
Check that the voltage marked on  
the appliance corresponds with the  
supply voltage.  
NOTE: When you lift the kettlee  
from the base, you  
will see drops of moisture  
on the surface of the power base.  
This is the steamm  
Use handles or knobs. Do not touch  
hot surfaces.  
Ensure that the kettle is correctly  
placed onto the power base before  
switching on.  
If the kettle is accidentally switched  
on when it does not contain  
Open the lid and fill the kettle  
via the lid aperture. Not through  
the spout.  
Do not open the lid when the  
water is boiling.  
sufficient water, a boil-dry device  
will automatically switch it off.  
Wait until the kettle has cooled  
down before refilling. The lid may  
be hot and the water may spit as it  
touches the kettle base.  
NOTE: Any plug cut from power  
supply cord should be disposed  
of immediately. Inserting any cut  
off plug into a 13A socket-outlet  
Do not fill above the bottom of the  
max mark on the water level  
indicator. Remove the kettle from its  
power base before filling or pouring.  
Observe water level when filling,  
you must use at least one cup of  
water, but the water level must be  
below the Max mark.  
used to switch the kettle  
Take care when pouring – pour  
slowly, and do not over-tilt the kettle.  
off automatically, which then  
condenses and escapes via vents  
in the unnderside of the kettle. This  
is perfectly normal, and should not  
be cause for alarm or returning  
thee kettle.  
is hazardous.  
3
Water will remain hot for a  
considerable time after boiling  
and can present a scald hazard.  
Keep the kettle, power base and  
the mains lead away from the  
edge of worktops and out the  
reach of children.  
Do not place the kettle, power base,  
or mains lead on or near any hot  
surface, hot hob or gas burners.  
Never use the plug without the  
fuse cover fitted. Ensure replacement  
fuse is the same current value as  
original.  
Do not overfill the kettle. If the  
kettle is overfilled, there is a risk  
that boiling water may be ejected  
from the spout and lid.  
Do not use the kettle for any  
purpose other than heating water.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Conair Styling Iron CS69 User Manual
Craftsman Saw 31528462 User Manual
Crosley Refrigerator 241824301 User Manual
Cuisinart Mixer HTM 3 HTM 5 User Manual
Edelbrock Automobile Parts 17932 User Manual
Edimax Technology Network Card EW 7206PDg User Manual
Extron electronic Stereo Amplifier DA RGBHV Series User Manual
Fisher Price Riding Toy J4390 User Manual
Five Star Ranges Range PN510 7BW User Manual
GBC Speaker CC175 User Manual