Dixon Lawn Mower ZTR 310 User Manual

TECHNICAL DATA BROCHURE  
ZTR 310  
.IMPORTANT - READ OPERATOR'S MANUAL BEFORE OPERATION.  
Seat Adjustment  
Loosen Bolts on sliding brackets under each side of seat, slide seat forward or rearward to desired position.  
Re-tighten bolts. Do not operate mower with bracket bolts in a loose condition.  
Mower Blade Operation  
To start mower blades, move lever on floor slowly to "ENGAGE" position. To stop mower blades,  
move lever on floor slowly to "DISENGAGE" position.  
Body Removal  
1. Disconnect throttle cable from engine.  
2. Disconnect the rear wiring loom (P/N 4109) from the body by lightly squeezing the Econo-Seal plug. This  
Is located at the left rear of the body.  
3. Note: Loosen bolts that hold body switch (P/N 4079) and slide switch away from engaging rod. Tighten one  
bolt just enough to hold switch 1n this position until body is reassembled.  
4. Remove 4 control lever bolts and remove upper control levers (P/N 1689 i 1690).  
5. Remove engaging handle (P/N 6089) by removing bolt and nut under handle.  
6. Remove the 2 attach nuts on floor of body and 2 sheet metal screws at the rear of body.  
7. Place height adjustment lever i n vertical position, engage parking brake and carefully lift body up and  
off chassis.  
8. Reverse the above procedure for assembly.  
Safety Checks  
With the mower deck in the engaged position slide the body switch (P/N 4079) toward  
the engaging rod (P/N 6038) until the switch leaf just makes contact with the  
switch button. Tighten both bolts 1n switch bracket.  
with mower deck engaged, attempt to start engine in all cutting height positions.  
if engine starts in any cutting height position, re-adjust the switch. Disengage  
the mower deck and start the engine In each cutting height position. If engine  
fails to start in any cutting height position, re-adjust switch.  
with operator in normal mowing position, engage mower deck and remove weight from  
seat. The engine should stop. Repeat this procedure in each cutting height  
position. If engine does not stop when operator rises from seat in each cutting  
height position, return to an authorized Dixon dealer for adjustment or repairs.  
Parking Brake Adjustment  
Remove body as described above. Tighten nut on brake rod (P/N2533) (Located 1n front of the transaxle on  
each side.), just enough to prevent brake from slipping when engaged. CAUTION: Over tightening may  
cause premature wear on brake band (P/N 5085).  
Mower Drive Belt Adjustment  
Belt tension for mower drive belt (P/N 2412) is adjusted by loosening nut on the connecting arm assembly  
(P/N 2148) and turning bolt to achieve desired tension. Re-tighten nut. Tension should be checked with  
belt 1n engaged position.  
Removing Mower Deck  
1. Remove engaging handle (P/N 6089) by removing bolt and nut under handle.  
2. Loosen belt keeper (P/N 2234) located under engine by loosening 2 rear engine mount bolts to allow mower  
deck drive belt to come free of rear pulley. Re-tighten belt keeper.  
3. Remove 4 attach pins (P/N 6107) and clips fro* 4 mower deck attach points and 2 stabilizer bars (P/N 6159).  
4. Raise front of mower chassis to allow mower deck engaging rod (P/N 6038) to clear the chassis. At this time,  
mower may be rolled free of mower deck for service and/or replacement.  
5. To re-install, reverse the above procedure.  
Removing Hower Cutter Blade  
Secure mower cutter blade (P/N 2406) from turning (observe blade position when removing) remove blade bolt  
from center of blade.  
DIXON INDUSTRIES,INC. BOX 494 COFFEYVILLE, KANSAS 67337-0494 (316) 251-2000  
P/N 8536 (H/83)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Illustration -Chassis Assembly (Model ZTR 310)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Illustration -Transaxle Assembly (Model ZTR 310)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Illustration -Body Assembly (Model ZTR 310)  
tn  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Illustration Mower Deck Assembly 30” (Model ZTR 310)  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cornelius Beverage Dispenser A8530 User Manual
Crosley Microwave Oven CMT135SG User Manual
Cypress Clock CYV15G0104TRB User Manual
Dacor Dishwasher renaissance built in dishwasher User Manual
Dixon Lawn Mower ZTR 424 User Manual
Dualit Hot Beverage Maker Dome Kettle User Manual
Dynex CRT Television DX 15E220A12 User Manual
Extron electronic Stereo Amplifier FOX 500 DA6 User Manual
GE Answering Machine 347A8232 0001 User Manual
Glen Dimplex Home Appliances Ltd Oven BI 90 MF User Manual