Cub Cadet Lawn Mower Accessory 759 04080 User Manual

Installation Instructions  
759-04080 CRUISE CONTROL KIT  
For Series 6000 Tractor Models  
KIT COMPONENTS  
3
5
2
6
1
7
Ref. Pt. No.  
Description  
1. 1750736  
2. 1768971  
3. 703-05791  
4. 712-0240  
5. 725-0157  
6. 725-04246  
7. 736-0171  
Special Screw  
Magnet w/Spring Assy.  
Cruise Latch Bracket  
Hex Jam Nut, 7/16-20  
Cable Tie  
Cruise Switch  
Lock Washer, 7/16"  
4
Introduction  
NOTE: The wire harness connector for the cruise switch  
may be connected to the dash panel plug. If so, carefully  
pull the wire harness connector up through the dash  
panel while removing the plug. If the wire harness leads  
are not connected to the plug, it will be necessary to re-  
move the dash panel insert.  
The cruise control kit is designed to allow the tractor op-  
erator to maintain a desired “foot free” forward speed  
in areas where constant speed changes are not re-  
quired. The cruise control feature can only be operated  
in the forward direction.  
Installing the Cruise Control Kit  
NOTE: Some installation procedures are more easily  
performed from beneath the tractor. If equipped, the  
mower deck may be removed from the tractor to im-  
prove access.  
Remove  
Plug  
Wire leads w/connectors needed to power the cruise  
control magnet are provided in the tractor wire harness.  
To install the cruise control kit, proceed as follows:  
• Remove the plug from the right side of the dash  
panel by sliding a thin flat edged tool beneath the  
plug and prying upward. See Figure 1.  
Figure 1  
CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019  
PRINTED IN U.S.A.  
FORM NO. 769-01718 (3/05)  
1
Download from Www.Somanuals.com. All Manuals Search And Download.  
• Insert the cruise latch bracket (Ref. 3) down  
through the opening in the fender/running board so  
that its large plate area is against the left side of  
the magnet. See Figure 8.  
Lock Washer  
Special Screw  
Spring  
Tractor  
Frame  
Hex  
Jam  
Nut  
Hex Tapp  
Screw  
Cruise  
Latch  
Bracket  
Pedal Shaft Plate  
Drive Shaft Shield  
Figure 6  
• Slide the lock washer (Ref.7) onto the special  
screw, then thread the hex jam nut (Ref.4) onto the  
screw. Refer to Figure 6.  
Magnet  
NOTE: Because of limited space between the ped-  
al shaft plate and frame, it may be easier to install  
the hex jam nut from the underside of the tractor.  
Figure 8  
• Pivot the rear of the cruise latch bracket downward  
so that the bracket mounting holes align with the  
holes of the drive shaft shield. Refer to Figure 8.  
• Fully tighten the hex jam nut onto the special  
screw. Then from beneath the right running board  
carefully retighten the hex lock nut to reposition the  
pedal shaft. Refer to Figure 5.  
• While holding the cruise latch bracket tightly  
against the magnet, secure the bracket with the  
two hex tapp screws removed earlier. Refer to Fig-  
ure 8.  
• Hook the bent tab of the magnet (Ref. 2) into the  
square hole of the pedal shaft plate and pivot the  
magnet onto the special screw (See Figure 7).  
Push the magnet onto the screw so that the bent  
tab is behind the plate and retains the magnet on  
the screw.  
• Locate the unused two wire connector of the main  
wire harness along the right side of the frame (See  
Figure 9). Plug the two wires from the magnet into  
the wire harness connector.  
Magnet  
Drive Shaft  
Bent Tab  
Main Harness  
Hook tab &  
pivot onto  
screw  
Square  
Hole  
Wire Harness  
Connector  
Figure 9  
Figure 7  
• Use the cable tie (Ref.5) to secure the wire har-  
ness lead and magnet wires to the main harness,  
away from the drive shaft. Refer to Figure 9.  
• Remove the two hex tapp screws securing the  
right side of the tractor drive shaft shield to the  
frame. Refer to Figure 8.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Setting The Cruise Control  
WARNING: Always use extreme caution  
Disengaging the Cruise Control  
NOTE: Regardless of the method used, the indicator  
light in the cruise switch will turn off when the cruise  
control is disengaged. Simply depress the top of the  
switch to re-engage the cruise control.  
when operating the tractor with the  
cruise control engaged. Use good judge-  
ment and maintain a safe speed for the  
conditions of operation.  
Disengage the cruise control using one of the following  
methods:  
• Depress the brake pedal to disengage the cruise  
control and stop the tractor.  
NOTE: The cruise control feature can only be operat-  
ed in the forward direction.  
• Slowly depress the forward control pedal until the  
desired speed is achieved.  
• Depress the bottom of the cruise control switch to  
disengage the cruise control.  
• While holding the forward control pedal, depress  
the top of cruise control switch to energize the  
magnet and engage the cruise control. NOTE: The  
light of the switch will illuminate to indicate the  
switch has been depressed to the "ON" position.  
NOTE: Although not recommended, depressing the  
forward/reverse pedal to the reverse position will also  
disengage the cruise control.  
To change to the reverse direction when operating with  
cruise control, use one of the recommended methods  
to disengage the cruise control, then depress the re-  
verse control pedal.  
• If the cruise control has engaged, the forward con-  
trol pedal will lock in the desired position, and the  
tractor will maintain the same forward speed when  
you remove your foot from the pedal.  
• If you wish to increase the speed while the cruise  
control is engaged, simply depress the forward  
pedal further. It is not necessary to disengage and  
re-engage the cruise control.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  

Conair Styling Iron CD123 User Manual
Concord Camera Digital Camera Eye Q 3042AF User Manual
Crystal Audiovideo Home Theater System SmArt User Manual
Curtis Marine Instruments 2100R User Manual
Digicom Digital Camera ES3310 User Manual
D Link Network Router Wireless AC1750 User Manual
Earthquake Sound Speaker IQ1500 User Manual
Electro Voice Microphone ND357A User Manual
Fellowes Mouse 9893501 User Manual
Freecom Technologies Computer Drive Hard Drive Dock Duplicator User Manual