Crosley Radio Stereo System CR11 User Manual

WARNING:  
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN  
OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO  
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE  
PERSONNEL.  
CAUTION  
RISK OF ELECTRIC SHOCK  
DO NOT OPEN  
CAUTION:  
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE  
COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER  
SERVICING TO QUALIFIED SERVICE PERSONNEL.  
The lighting flash with arrowhead symbol, within an equilateral  
triangle, is intended to alert user to the presence of uninsulated  
"dangerous voltage" within the product's enclosure that may be  
of sufficient magnitude to constitute risk of electric shock to  
persons.  
The exclamation point within an equilateral triangle is intended  
to alert user to the presence of important operating and  
maintenance (servicing) instruction in the literature accompanying  
the appliance.  
SPECIFICATION  
FREQUENCY RANGE  
: FM 87.5 - 108.5 MHz  
AM 525 - 1710 KHz  
: 25W  
POWER CONSUMPTION  
POWER SOURCE  
ANTENNAS  
: AC 120 V / 60 Hz  
: External antenna for FM  
Built-in ferrite bar for AM  
: 4" dynamic type  
SPEAKER  
TAPE SPEED  
: 4.75 cm / sec.  
: 0.35% JLS. WTD.  
WOW and FLUTTER  
* DESIGN AND SPECIFICATION SUBJECT TO CHANGE WITHOUT  
NOTICE.  
Model: CR11  
910-986000-013  
14. Power Lines - An outside antenna system should not be located in the vicinity  
of overhead power lines or other electric light or power circuits, or where it can  
fall into such power lines or circuits. When installing an outside antenna system,  
extreme care should be taken to keep from touching such power lines or circuits  
as contact with them might be fatal.  
IMPORTANT SAFETY  
INSTRUCTION  
15. Overloading - Do not overload wall outlets, extension cords, or integral convenience  
receptacles as this can result in a risk of fire or electric shock.  
PLEASE READ CAREFULLY ALL THE FOLLOWING IMPORTANT  
SAFEGUARDS  
16. Object and Liquid Entry - Never push objects of any kind into this product through  
openings as they may touch dangerous voltage points or short - out parts that  
could result in a fire or electric shock. Never spill liquid of any kind on the product.  
17. Servicing - Do not attempt to service this product yourself as opening or removing  
covers may expose you to dangerous voltage or other hazards. Refer all servicing  
to qualified service personnel.  
18. Damage Requiring Service - Unplug this product from the wall outlet and refer  
servicing to qualified service personnel under the following conditions;  
a. When the power-supply cord or plug is damaged.  
THAT ARE APPLICABLE TO YOUR EQUIPMENT  
1. Read Instructions - All the safety and operating instructions should be read  
before the product is operated.  
2. Retain instructions - The safety and operating instructions should be retained  
for future reference.  
3. Heed Warnings - All warnings on the product and in the operating Instructions  
should be adhered to.  
4. Follow Instructions - All operating and use instructions should be followed.  
5. Cleaning - Unplug this product from the wall outlet before cleaning. Do not use  
liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.  
6. Attachments - Do not use attachments not recommended by the product  
manufacturer as they may cause hazards.  
7. Water and Moisture - Do not use this product near water - for example, near a  
bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement; or near  
a swimming pool; and the like.  
b. If liquid has been spilled, or objects have fallen into the product.  
c. If the product has been exposed to rain or water.  
d. If the product does not operate normally by following the operating instructions.  
Adjust only those controls that are covered by the operating instructions as  
an improper adjustment of other controls may result in damage and will often  
require extensive work by a qualified technician to restore the product to its  
normal operation.  
e. If the product has been dropped or damaged in any way.  
f. When the product exhibits a distinct change in performance - this indicates  
a need for service.  
8. A product and cart combination should be moved with care. Quick stops, excessive  
force, and uneven surfaces may cause the product and cart  
combination to overturn.  
19. Replacement Parts - When replacement parts are required, be sure the service  
technician has used replacement parts specified by the manufacturer or have  
the same characteristics as the original part. Unauthorized substitutions may  
result in fire, electric shock, or other hazards.  
20. Safety Check - Upon completion of any service or repairs to this product, ask  
the service technician to perform safety checks to determine that the product  
is in proper operating condition.  
21. Wall or ceiling Mounting - The product should be mounted to a wall or ceiling  
only as recommended by the manufacturer.  
22. Heat - The product should be situated away from heat sources such as radiators.  
Heat registers, stoves, or other products(including amplifiers) that produce heat.  
9. Ventilation - Slots and openings in the cabinet are  
provided for ventilation and to ensure reliable operation  
of the product and to protect it from overheating, and  
these openings must not be blocked or covered, The  
openings should never be blocked by placing the product  
on a bed, sofa, rug, or other similar surface. This product  
should not be placed in a built - in installation such as a  
bookcase or rack unless proper ventilation is provided or  
the manufacturer's instructions have been adhered to.  
10. Power Sources - This product should be operated only from the type of power  
source indicated on the marking label, if you are not sure of the type of power  
supply to your home. Consult your product dealer or local power company. For  
products intended to operate from battery power, or other sources, refer to the  
operating instructions.  
11. Grounding or Polarization - This product may be equipped with a polarized  
alternating-current line plug (a plug having one blade wider than the other). This  
plug will fit into the power outlet only one way. This is a safety feature. If you are  
unable to insert the plug fully into the outlet try reversing the  
plug, If the plug should still fail to fit, contact your  
WARNING: Changes or modifications to this unit not expressly approved by the party  
responsible for compliance could void the user’s authority to operate the equipment.  
NOTE: This equipment has been tested and found to comply with the limits for a  
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed  
to provide reasonable protection against harmful interference in a residential installation.  
This equipment generates, uses, and can radiate radio frequency energy and, if not  
installed and used in accordance with the instructions, may cause harmful interference  
to radio communications. However, there is no guarantee that interference will not occur  
in a particular installation. If this equipment does cause harmful intereference to radio  
or television reception, which can be determined by turning the equipment off and on, the  
user is encouraged to try to correct the interference by one or more of the following  
measures:  
electrician to replace your obsolete outlet. Do  
AC  
not defeat the safety purpose of the polarized plug.  
Polarized Plug  
12. Power - Cord Protection - Power - supply cords  
should be routed so that they are not likely to be  
walked on or pinched by items placed upon or against them, paying particular  
attention to cords at plugs, convenience receptacles, and the point where they  
exit from the product.  
13. Lightning - For added protection for this product during a lightning storm, or  
when it is left unattended and unused for long periods of time, unplug it from  
the wall outlet and disconnect the antenna or cable system. This will prevent  
damage to the product due to lightning and power - line surges.  
-
-
-
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an circuit different from that to which the receiver  
is connected.  
-
Consult the dealer or an experienced radio TV technician for help.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Conair Hot Tub Bath Spa User Manual
Craftsman Thermometer 81079 User Manual
Delta Electronics Power Supply HMP1352 User Manual
Dukane Welding System iQ Series User Manual
Faber Ventilation Hood INCA User Manual
Fisher Price Crib T1456 User Manual
Fostex Computer Monitor PM 1MKII User Manual
Frigidaire Clothes Dryer FRQE7000L W User Manual
FUNAI TV VCR Combo SC1303 User Manual
GE Dishwasher CDW9000 Series PDW9000 Series PDW8000 Series User Manual