Crate Amplifiers Musical Instrument Amplifier MXB15 User Manual

Owner's Guide  
for the  
CRATTEE  
Bass Amplifier  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bass Amplifier  
Important Safeguards and Precautions:  
All Crate products are designed for continuous safe operation. Abiding by the following  
rules can help prevent damage to your amplifier, yourself and others.  
The amplifier is equipped with a three-pronged AC power cord. To  
reduce the risk of electrical shock, NEVER remove or otherwise attempt  
to defeat the ground pin of the power cord.  
Connect the amplifier ONLY to a properly grounded AC outlet of the  
proper voltage for your amp.  
Avoid sudden temperature extremes, rain and moisture. Also, avoid  
sudden and intense impact. (If the unit has been subjected to any of the  
preceding abuses, have it looked at by an authorized service center.)  
• Do not expose the unit to splashing or dripping liquid. Do not place liq-  
uid filled objects on the unit.  
NEVER set the amplifier on a support that will not bear its weight.  
Always keep the total speaker impedance at or above the rated load.  
Unplug the amplifier before cleaning it. NEVER spray liquid cleaners  
onto the amplifier. Wipe it with a slightly dampened, lint-free cloth to  
remove dirt and film.  
DO NOT use the amplifier if it has sustained damage to the chassis,  
controls, or power cord. Refer the unit to an authorized service center  
for inspection.  
Prolonged exposure to high volume levels may cause permanent hear-  
ing loss or damage. Such damage is progressive and irreversible!  
Declaration Of Conformity  
#27, Effective 01-01-2001  
Manufacturer’s Name:  
Production Facility:  
SLM Electronics  
11880 Borman Drive, St. Louis, MO 63146, USA  
700 Hwy 202 W, Yellville, AR 72687, USA  
1400 Ferguson Ave., St. Louis, MO 63133, USA  
1400 Ferguson Ave., St. Louis, MO 63133, USA  
Production Facility:  
Shipping Facility:  
Office Facility:  
Product Type:  
Audio Amplifier  
Complies with Standards:  
LVD:  
Safety:  
EMC:  
92/31/EEC, 93/68/EEC, & 73/23/EWG  
EN60065  
EN55013, EN55020, EN55022, EN61000-3-2,  
& EN61000-3-3  
Supplementary information provided by:  
SLM Electronics - R & D Engineering  
1901 Congressional Drive, St Louis, MO 63146, USA  
Tel.: 314-569-0141, Fax: 314-569-0175  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bass Amplifier  
The Front Panel:  
1: INPUT: Use this 1/4” jack to connect your guitar to the amplifier by  
means of a shielded instrument cable.  
2: MASTER GAIN: Use this control to adjust the overall output of the  
amplifier.  
3: LOW: Use this control to adjust the bass response of the amplifier.  
Rotating the control counterclockwise reduces the low frequency output.  
Rotating the control clockwise increases the low frequency output. The  
Low control provides a range of 15dB of boost or cut at 60Hz. It may be  
necessary to reduce the Low frequency output at higher volume levels.  
4: LO MID: Use this control to adjust the “thickness” or “fatness” of the  
amplifier. Rotating the control counterclockwise reduces the lower middle  
frequency output. Rotating the control clockwise increases the lower  
middle frequency output. The Low Mid control provides a range of 18dB  
of boost or cut at 630Hz.  
5: HI MID: Use this control to adjust the clarity and definition of the string  
attack. Rotating the control counterclockwise reduces the upper middle  
frequency output. Rotating the control clockwise increases the upper  
middle frequency output. The High Mid control provides a range of 19dB  
of boost or cut at 2kHz.  
6: HIGH: Use this control to adjust the high frequency response of the  
amplifier. Rotating the control counterclockwise reduces the high fre-  
quency output. Rotating the control clockwise increases the high fre-  
quency output. The High control provides a range of 27dB of boost or cut  
at 10kHz.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bass Amplifier  
7: SPEAKER: Use this jack to connect the amplifier to an external  
speaker. The internal speaker is disconnected when this jack is used.  
The impedance of the external speaker must be 4 ohms or greater.  
WARNING: Do not attempt to use headphones in the Speaker jack!  
Permanent hearing damage could result!  
8: HEADPHONES: Use this jack to connect headphones to the amplifier.  
The internal speaker is disconnected when headphones are used.  
CAUTION: To avoid possible damage to your hearing, do not use  
headphones for extended periods of time at extremely loud levels.  
9: ON LED: This LED illuminates when the amplifier is turned on.  
10: POWER: Use this switch to turn the amplifier on (top of the switch  
depressed) and off (bottom of the switch depressed).  
11: POWER CORD (rear panel, not shown): The grounded power cord  
should only be plugged into a grounded power outlet that meets all appli-  
cable electrical codes and is compatible with the voltage, power, and fre-  
quency requirements stated on the rear panel. Do not attempt to defeat  
the safety ground connection.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bass Amplifier  
Suggested Settings:  
Clean:  
Blues:  
Rhythm:  
Lead:  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bass Amplifier  
System Block Diagram:  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Bass Amplifier  
MXB15 TECHNICAL SPECIFICATIONS:  
Output Power Rating  
Maximum Input Signal Accepted  
Input Impedance  
12 watts RMS @ 5% THD 4 ohms, 120 VAC  
15 volts peak-to-peak  
25k ohms  
Signal to Noise Ratio  
72dB  
Low Control  
15dB Range @ 60Hz  
18dB Range @ 630Hz  
19dB Range @ 2kHz  
27dB Range @ 10kHz  
Low Mid Control  
High Mid Control  
High Control  
Power Requirements  
120 VAC, 60Hz, 30VA  
100/115VAC, 50/60Hz, 30VA  
230VAC, 50Hz, 30VA  
Speaker Size and Rating  
Size and Weight  
Crate Custom Design 8”, 15 watts  
13” H x 13.5” W x 8.25” D, 15 lbs.  
The MXB15 is covered with a durable black Tolex material: wipe it clean with a lint-free cloth.  
Never spray cleaning agents onto the cabinet. Avoid abrasive cleansers which would damage the finish.  
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications  
and information in this manual are subject to change without notice.  
@2002 SLM Electronics, a division of St. Louis Music, Inc • 1400 Ferguson Avenue • St. Louis, MO 63133  
18-431-01 • 04/02  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Conair Electric Toothbrush WJ2B User Manual
Cooper Lighting Work Light E4RPIN User Manual
Craftsman Saw 3152121O0 User Manual
Crosley Washer Dryer 1P N13488880 User Manual
Curtis Portable CD Player SCD266 User Manual
Dualit Coffee Grinder IB CCG2 A User Manual
EdgeStar Air Conditioner AP310SS User Manual
Edimax Technology Network Card EW 7317LDg User Manual
Electro Voice Portable Speaker LF118 User Manual
Fundex Games Games The Storybook Game User Manual