Tm
HOOLIGAN 3
MOdeL 2000001590
7. Assemble thin, black, shock-corded Vent Pole.
8. Insert Vent Pole through
sleeve at back of tent.
(Fig. 5)
9. Insert metal tip into
Before you begin
Vent Pole
Sleeve
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
• For best results in windy conditions, position narrow end of
tent into the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
grommet. Go to opposite
end of Vent Pole and
gradually apply pressure to
pole forming an arch then
insert metal tip into grommet.
(Fig. 6 & 6A)
Back of Tent
Fig. 5
Fig. 6
6A
Pole descriptions
To Attach Rainfly
Pole
Pole
Pole
1. Drape Rainfly over tent. make sure seams on Rainfly are
facing down and centered over poles and the vestibule is
over to door of the tent. (Fig. 7)
description
Qty.
dia.
Repair Kit Replacement Kit
main Pole, black
Vestibule Pole, grey
2
1
8.5mm 5010000541
8.5mm 5010000541
5010000547
5010000547
NOTE: Hook and loop fasteners, located on seams of under-
side of rainfly, should be centered over black poles.
Vent Pole, black
with pre-bent ferrules
1
6.0mm 5010000639
5010000639
To Set Up Tent
Rainfly
1. Unfold tent and spread out on a clean, level surface with the
door facing perpendicular to the wind direction. Unzip door.
2. Assemble main Poles by interlocking the black, shock-cord-
ed, sections.
Vestibule
over Door
3. Insert main Poles through sleeves in top of tent. (Fig. 1)
Fig. 1
Front of Tent
Back of Tent
Door
Fig. 7
2. Fold Rainfly at front of tent back as shown in Fig. 8.
3. Assemble Vestibule Pole by interlocking the grey, shock-
corded, sections.
4. Insert one end of grey Vestibule Pole into pin on metal loop
located at either side of tent. (Fig. 8 & 8A)
5. Go to opposite end of Vestibule Pole and gradually apply
pressure to pole forming an arch. Insert pin into the pole end
(Fig. 8 & 8A).
main
Pole
Sleeve
Sleeve
main
Pole
4. Insert one end of black main pole into pin on metal loop
located at either end of tent. (Fig. 2)
5. Go to opposite end of main Pole and gradually apply pressure
to pole forming an arch. Insert pin into
the pole end (Fig. 2 & 3). Repeat for the
remaining main Pole.
Grey Vestibule Pole
Hook & Loop
Fasteners
main
Pole
metal
Loop
& Pin
Fig. 2
Door
Front of
Tent
Stake
Stake
Fig. 3
Fig. 8
6. Stretch out corners and sides of
tent. Drive in stakes at an angle
through the metal loops to help
anchor the corners & sides of the
tent. (Fig. 3 & 4)
8A
Fig. 4
(continued on other side)
Download from Www.Somanuals.com. All Manuals Search And Download.
|