Clarion Car Video System OHM733 User Manual

OHM733  
OHM833  
7” LCD COLOR MONITOR  
8” LCD COLOR MONITOR  
OWNERS MANUAL  
Download from Www.Somanuals.com. All Manuals Search And Download.  
OHM733,OHM833  
1.PRECAUTIONS:  
The set is for use in DC 12V, negative ground vehicles.  
Do not operate the set in ways other than described in this guide. Doing so may damage it  
and voids your warranty.  
SAFETY FIRST! For rear seat use only. Do not install in dashboard or anywhere else that would  
permit monitor to be viewed by the driver. Monitor must never be used in any manner  
that will distract driver or interfere with the drivers safe operation of the motor vehicle.  
Be careful not to run down the car battery while using the set with the car stopped.  
Do not disassemble or modify the set. Doing so may damage it and voids your warranty.  
Keep drinks and drops from umbrellas away from the set. Water may damage the internal  
circuitry.  
Do not let the set become hot. If the temperature in the car is high or the set has been exposed  
to direct sunlight and is hot, lower the temperature before using it. (The liquid crystal panel will  
work properly within a temperature range of –10°C ~ +60°C (14°F ~ 140°F) .  
In extremely cold temperatures, the movement of the picture may be slow and the picture may  
be dark, but this is not a malfunction. The set will work normally once the temperature  
increases.  
Small black and shiny dots inside the liquid crystal panel are normal for liquid crystal product.  
2.DESCRIPTION  
The OHM733/833 is a TFT active matrix color LCD monitor that delivers a striking picture  
and superior image resolution. The OHM733/833 can be used to enjoy video images  
with the Clarion video sources.  
3.PACKAGE CONTENTS  
DESCRIPTION  
Q’ TY  
LCD Monitor  
1
1
1
2
1
1
5
1
1
Universal Trim Ring  
IR Remote Control  
A/V Din Cables  
FM Modulator Din Cable  
Power Connector  
M3X8 Screws  
Manual/Installation Guide  
Rubber Gasket  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
OWNER’ S MANUAL  
4.MONITOR BUTTON FUNCTIONS  
1. Monitor Release Button  
2. Dome Light Switch  
3. Power Button  
4. Mode Selector  
5. FM Modulator On/Off Button  
6. Auxiliary Input Selector  
7. IR Sensor  
8. Power LED  
9. Not Applicable  
5.DESCRIPTION OF IR REMOTE CONT
1. Power Button for Monitor  
Powers on monitor.  
2. Video Button  
AV1/AV2  
POWER  
1
5
2
Switches between A/V1, A/V2  
3. Picture Select Button for Monitor  
Goes into picture mode menu for Monitor to select  
Contrast, Brightness, Color, Tint and Wide Screen  
Mode.  
PICTURE  
SELECT  
3
4
4. Picture Mode Up Button  
Adjusts selected picture mode.  
5. Picture Mode Down Button  
Adjusts selected picture mode.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
OHM733,OHM833  
6.USING REMOTE CONTROL  
Inside the vehicle, simply aim the IR Remote Control directly at the OHM733/OHM833,  
or at a Clarion monitor, or video source with an IR eye input and press any desired  
button for better results. Also note the following:  
Aim the IR Remote Control from no further than 2 Meters away and no more than 0.9 Meters  
on either side of the sensor.  
Direct sunlight or very bright light will reduce sensitivity to the IR remote signal commands.  
Be sure the monitor is not located in direct sunlight.  
Objects between the monitor will interfere or block IR remote signal commands.  
7.INSERTING THE BATTERIES  
1. Locate the battery compartment on the back of the IR Remote Control.  
2. Remove the battery holder and insert two AAA alkaline batteries matching polarity  
as shown inside the battery holder.  
3. Snap the battery holder back into the remote unit until it locks with a click.  
8.WIRING PRECAUTIONS  
Read all wiring precautions. If you are not sure of the connections, contact your  
Authorized Clarion dealer.  
1. Disconnect the negative (-) lead of the battery before making any power connections.  
2. When creating passage holes for the power wires, use grommets to eliminate any sharp  
edges created during drilling. This will protect the wire from being nicked and causing a  
short circuit.  
3. When connecting the ground lead, fasten the ground lead (black wire) securely to a clean  
metal plate on the vehicle.  
NOTE: The OHM733/OHM833 monitor displays video images only. It does not provide audio output.  
Refer to the owner’ s manual of the connected device for the information on audio output.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
OWNER’ S MANUAL  
9.INSTALLATION INSTRUCTIONS  
The OHM733/OHM833 is an overhead, flip-down 7”/8” monitor with an infrared (IR) eye.  
It will accept a video signal from any video source with composite video out. The IR eye will work  
with Clarion video source products with an IR eye input.(Please check first if Adapter is necessary!).  
1. Look over the vehicle for a location for the monitor. Each vehicle is different and locations will  
vary. Make sure the monitor will not interfere with the driver.  
2. Run necessary wires to the mounting location. When necessary cut the headliner and pull  
wires through.  
3. Use a 30cm x 30cm x 2cm or 1.2cm think piece of plywood to mount the OHM733/OHM833.  
4. Silicone the piece of plywood to the top of the roof or screw the plywood to the dome light  
mounting assembly and or the roof support rail.  
5. If you don’ t need full Heights of the universal Trim Ring you can cut these Ring and use than  
including Rubber gasket to close cutting.  
6. Once the plywood has been mounted, connect the IR, power and DIN cables to the designated  
sources.  
7. Make sure all wires and DIN cables are way from screws when drilling.  
8. Screw the monitor and universal pod assembly (factory pre-assembled) into the plywood using  
4 wood screws (not supplied). Use the shortest screws possible to prevent roof penetration.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
OHM733,OHM833  
10.DOME LIGHT WIRING  
Negative Trigger Door Switch  
Positive Trigger Door Switch  
Brown : +12V  
Brown : Ground  
Gray : +12V  
Gray : Ground  
White : Door Switch  
White : Door Switch  
11.DOME LIGHT ON/OFF SWITCH DESCRIPTION  
A three-position slide switch controls the lights integrated into the OHM733/OHM833 sliding the  
switch to the ON position will turn the lights on. The OFF position will prevent the lights from  
turning on at all times and the auto position will allow the lights to turn on and off with the  
vehicle interior lighting. Do not leave the vehicle unattended with the dome light switch in the  
ON position, as this could result in a discharged battery.  
12.DIN CABLE PIN LAYOUT  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
OWNER’ S MANUAL  
13.PICTURE ADJUSTMENT  
To adjust the picture use the mode button to select the mode feature you would like to  
Adjust. Adjustment selections are as follow:  
Contrast  
Brightness  
Color  
Wide screen ON/OFF (OHM733 only)  
Tint  
Press the up button to increase and the down button to decrease.  
14.FM MODULATOR (FM201) SYSTEM DIAGRAM  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
OHM733,OHM833  
15.COMPLETE A/V SYSTEM DIAGRAM  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
OWNERS MANUAL  
16.CARE AND MAINTENANCE  
Cleaning the cabinet  
Use a soft, dry cloth to gently wipe off any dirt.  
Do not use benzene, thinner, car cleaner, etc., as these substances may damage  
the cabinet or cause the paint to peel.  
Cleaning the LCD panel  
Use a soft, dry cloth to gently wipe off any dust.  
The surface is easily scratched; do not rub it with hard objects.  
17.SPECIFICATIONS  
GENERAL SPECIFICATIONS:  
Power Source:  
Car Battery (DC 9-16V)  
Power Consumption:  
DC 12V 15W (without Dome lights)  
Less than 1.5A (without Dome lights)  
8-1/2” x 11-3/4” x 1-3/16” (W x H x D)  
216 x 300 x 31.5 mm (W x H x D)  
9-1/8” x 13-3/16” x 1-3/16” (W x H x D)  
232 x 336 x 31.5 mm (W x H x D)  
3 lb (1.4 kg)  
Max Current Consumption:  
OHM733 Dimensions:  
OHM833 Dimensions:  
OHM733 Weight:  
OHM833 Weight:  
3.5 lb (1.6 kg)  
Operation Temperature  
-10°C~+60°C (14°F ~ 140°F)  
MONITOR SPECIFICATIONS:  
Display Type:  
Color TFT Active Matrix LCD  
OHM733 Display Screen Size: 7.0”  
OHM833 Display Screen Size: 8.0”  
Format  
1440 x 234  
Screen Resolution:  
Video Signal  
Video System  
336,960 dots  
1Vp-p with 75-ohm load  
Auto NTSC/PAL  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cobra Electronics Drill CM 200 1 User Manual
Compaq CD Player NX7000 User Manual
Cuisinart Blender MP 14N Series User Manual
Cuisinart Cooktop PG 26757 User Manual
Delta Electronics Power Supply DRP024V060W1BA User Manual
Dimension One Spas Hot Tub Dynamic Massage Sequencer User Manual
Edelbrock Automobile Parts R08463S User Manual
Excalibur electronic Tool Storage EI PT1013 User Manual
FUNAI TV VCR Combo F9TRF1 User Manual
Furman Sound Stereo Amplifier SP 20AB User Manual