Chromalox Electric Heater PG407 3 User Manual

®
Chromalox  
SERVICE REFERENCE  
Installation, Operation  
and  
DIVISION  
SALES  
4
SECTION RAD  
(Supersedes PG407-2)  
PG407-3  
161-048766-001  
REFERENCE  
RENEWAL PARTS IDENTIFICATION  
DATE  
FEBRUARY, 1987  
Chromalox Type RAD Radiant Heaters  
Converting Styles 0, 1, 3 and 3A to 3B  
GENERAL  
The current Chromalox Style 3B RAD has superseded earlier  
Styles 0, 1, 3 and 3A RAD heaters. These instructions are for con-  
verting these earlier models to the current Style 3B. This conversion  
is necessary because replacement parts for the old models are no  
longer available.  
The changes involved are primarily in the terminal area as  
shown in Figures I, 2 and 3. Match-up one of the Figures with your  
heater's terminal arrangement and order the corresponding parts bag  
(Figures 4 and 5). If an element or other part listed in Table A (page  
3) is necessary, order according to heater housing length and the  
voltage and wattage stamped on the element and the heater name-  
plate.  
For complete installation information for type RAD - Style  
3B, request Chromalox Service Reference sheet PG404.  
CONVERSION  
CAUTION: Hazard of electric shock. Disconnect  
power before servicing heater.  
A. CONVERTING STYLES 0 AND 1 TO  
STYLE 3B RADIANT HEATER  
1. Completely disassemble heater. Re-use the heating element (if  
desired) and the extruded aluminum housing (Fig. 7). Scrap all  
the other parts.  
2. Drill #24 (.152" dia.) hole in the back of the extruded housing  
, 3" from each end. (See Fig. 7)  
A
3. NOTE: If replacing old element with a new one, omit this step.  
B
Remove wire retaining loops (Fig. 6) from the elements and  
replace with wire loops fashioned from #15 gage (.072" dia.) or  
larger stainless steel wire located 2-1/4” from each end of the  
sheath. Other high temperature materials such as nichrome may  
be substituted. Braze or tack weld the loops in position.  
4. Besides the Parts Bag 168-016585-002 (Fig. 4), you will need  
6
7
2
insulation bushings , element support clips  
, reflector
and element (if required) as listed in Table A, page 2.  
NOTE: Quantities of these parts, as well as size of element and  
reflector will be determined by the heater housing length of the old  
unit.  
Figure 1 – Style 0 and 1 Terminal Area Assembly  
5. Assemble heater as shown in Figure 7.  
© 2010 Chromalox, Inc.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
RENEWAL PARTS IDENTIFICATION  
MISCELLANEOUS HARDWARE  
13  
Screws  
8
Terminal Screw .....................................................................248-046044-002(2)  
#8 x 1” Lg..............................................................................248-075519-095(6)  
#8 x 3/8” Lg...........................................................................248-075519-080(4)  
#8-32 x 3/8” Lg.....................................................................248-075512-053(4)  
12  
12  
13  
14  
11  
4
3
MISCELLANEOUS HARDWARE  
8
8
Terminal Screw .....................................................................303-016367-001(2)  
Speed Nuts ............................................................................272-048153·005(4)  
Terminal Block.......................................................................303-014326-001(2)  
Saddle Clamp ........................................................................238-026539-001(2)  
15  
10  
11  
15  
1
12  
9
HEATER MOUNTING CLAMP ASSEMBLY  
14  
For mounting heater with catalog numbers up to Cat. No. RAD 7000  
use mounting clamp assembly part no. 168-013071-001. For mount-  
ing heaters above Cat. No. RAD 7000 use mounting clamp assem-  
bly part no. 168-013071-002.  
10  
5
Aluminum  
Housing  
A
7
6
Figure 7 – Style 3B RAD Heater Terminal Area Assembly  
6
1
2
7
Heater  
Housing Length  
Element  
Catalog Number  
Reflector  
Sheet  
Insulation  
Bushing  
Element  
Support Clip  
Volts  
Watts  
120  
208  
240  
275  
RTU-2083A-120V  
RTU-2083AV  
24-3/8”  
30-5/8”  
800  
234-013411-001  
234-013411-012  
________  
________  
________  
________  
RTU-2083A-240V  
RTU-2083AV-275V  
120  
208  
240  
275  
RTU-3113A-120V  
RTU-3113AV  
RTU-3113A-240V  
RTU-3113AV  
1100  
1800  
2500  
208  
240  
275  
480  
RTU-4183AV  
RTU-4183A-240V  
RTU-4183AV  
46-5/8”  
61-3/8”  
234-013411-014  
234-013411-016  
032-013454-001 (2)  
032-013454-001 (6)  
059-013424-001  
RTU-4183A-480  
208  
240  
275  
480  
RTU-5253AV  
RTU-5253A-240V  
RTU-5253AV  
059-013424-001 (3)  
RTU-5253A-480V  
208  
240  
275  
480  
RTU-6303AV  
RTU-6303A-240V  
RTU-6303AV  
73-3/4”  
85-3/4”  
3000  
3600  
234-013411-018  
032-013454-001 (8)  
059-013424-001 (4)  
RTU-6303A-480V  
208  
240  
275  
480  
RTU-7363AV  
234-013411-004*  
and  
234-013411-012*  
RTU-7363A-240  
RTU-7363AV  
032-013454-001 (10) 059-013424-001 (5)  
RTU-7363A-480V  
*For ease of installation. these reflectors shipped in two pieces (one each of part numbers listed).  
NOTE: Part numbers suffixed by a number in ( ) Indicates the quantity of the same part number used.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Limited Warranty:  
Please refer to the Chromalox limited warranty applicable to this product at  
2150 N. RULON WHITE BLVD., OGDEN, UT 84404  
Phone: 1-800-368-2493  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Beko Washer WBM 751441 LA User Manual
Beko Washer WMB 60831 M User Manual
Bionaire Humidifier BCM658 User Manual
Bowers Wilkins Speaker DM602 S2 User Manual
Cannon Camcorder XL H1 a User Manual
Canon Film Camera 8089a002 User Manual
Canon Scanner DR 6030C User Manual
Casio Watch 1910 2 User Manual
Chicago Electric Work Light 66439 User Manual
Cisco Systems IP Phone 691 User Manual