I N S T A L L A T I O N I N S T R U C T I O N S
Pole Clamp Accessory
Model: FSA-1017
The FSA-1017 Pole Clamp Accessory is used to provide
a means for attaching a desktop or wall mount to a
1 1/2" to 2" pole.
BEFORE YOU BEGIN
CAUTION!
To prevent damage to the Kit, which could affect or void the Factory warranty, and to the equipment that will be
attached to it, thoroughly study all instructions and illustrations before you begin the installation.
•
If you have any questions about this installation, contact Chief Manufacturing at 1-800-582-6480.
8807-000042
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378 USA
©2005 Chief Manufacturing
12/05
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation Instructions
Model: FSA-1017
NOTE: The following steps reuse hardware set aside
10. Secure pole mount rear (20) to pole mount front (10)
and pole by tightening three BHCS (20) using 5/32"
hex key.
during existing mount preparation.
2. Place large Nylon washer into seat in pole mount
front. (see Figure 4)
3. Slide pivot pin through large nylon washer and down
into pole mount front. (see Figure 4)
Pole
(30)
Pole Mount front (10)
with Swing Arm
4. Slide swing arm assembly down onto top of pivot pin.
5. Assemble two flat waskhers and one nylon washer
onto button head cap screw. (see Figure 4)
6. While holding Nylock nut, previously installed into
pole mount front, slide button head cap screw with
washers through swing arm and down into pole mount
front until contact with Nylock nut is made.
7. Secure swing arm to pole mount front by screwing
button head cap screw into nylock nut.
(20)
NOTE: It may be necessary to move Nylock nut slighty
in order to allow button head cap screw to
properly seat in nut and allow tightening.
Figure 5: Mount FSA-1017 with Swing Arm on Pole
Phillips BHCS
Flat Washer
ADJUSTMENTS
The FSA-1017 allows for both vertical and horizontal
position adjustment on pole.
To adjust FSA-1017 position:
Swing Arm
Nylon Washer
Flat Washer
1. Loosen single (right) rear BHCS (30). (see Figure 6)
2. Move FSA-1017 to desired position. (see Figure 6)
3. Tighten BHCS (30).
CAUTION!
ALWAYS use two people when adjusting FSA-1017
position.
Pivot Pin
Adjustment Screw
Large Nylon Washer
Recessed Seat
Pole Mount
(Front)
View From Rear
Figure 4: Install Swing Arm to Front Pole Mount
8. Place pole mount front with swing arm against pole in
approximate mounting location.
9. Place three BHCS (30) into pole mount rear (20) and
place against pole aligning with mount front (10).
Figure 6: Pole Mount Adjustment
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Model: FSA-1017
Installation Instructions
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|