Century Stroller PM 0624AB User Manual

CAR SEAT/  
STROLLER  
INSTRUCTION  
MANUAL  
Do not use this 4-in-1  
System until you read and  
understand these  
instructions!  
English  
PM-0624AB  
3/98  
Download from Www.Somanuals.com. All Manuals Search And Download.  
WARNINGS  
Never leave child unattended.  
Always keep child in view,  
even when sleeping.  
DO NOT allow children to play,  
hang or pull down on car seat  
or stroller handle.  
• Children may become  
entangeled in harness straps  
and suffocate, even when  
sleeping.  
• Stroller may tip over.  
• Stroller may roll away, crash  
and seriously injure child,  
even with brakes engaged.  
Avoid serious injury from falling  
or sliding out. Always use seat belt.  
• Car seat handle may break.  
Push stroller at normal walking  
speed only. Fast walking,  
jogging or running can cause  
loss of control and injure child.  
Avoid serious injury or strangulation, DO NOT place  
child in stroller seat when car seat adapter is  
attached. Remove adapter assembly BEFORE using  
stroller seat.  
DO NOT overload basket.  
Maximum basket weight is  
10 lbs. (4.5 kg.). Stroller may  
become unstable and fall over  
injuring child.  
DO NOT pull or carry stroller on  
stairs or escalators with child in  
it because child could fall out  
and be injured.  
DO NOT hang anything on  
handlebar or canopy as stroller  
could fall over and injure child.  
DO NOT lift car seat/stroller unit  
by car seat handle. Handle may  
break.  
DO NOT allow child to climb unassisted into stroller  
as stroller may fall over injuring child.  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
CAR SEAT/STROLLER ASSEMBLY  
Lock Footrest:  
1 Push footrest down so that frame  
tube is centered between three  
(3) tabs on bottom of footrest  
and snaps into place.  
Tabs  
Stroller Right  
Stroller Left  
Side  
Side  
RearWheel Assembly:  
1 Remove axle protectors from ends of axle and discard.  
Brake Lever  
2 Rotate brake lever to the unlocked  
position and slide wheel onto each  
end of axle rod with brake ribs  
facing in.  
Brake Ribs  
Opening Stroller:  
3 Attach wheel to axle:  
Snap wheel retainer onto grooved end of axle. Make sure  
large end of wheel retainer is towards wheel.  
1 Stand stroller upright and pull tab  
up to release latch.  
Snap wheel retainer cap over wheel retainer.  
2 Spread handle and rear legs until  
both fold locks “click” into position.  
Hub  
Cap  
Retainer  
Cap  
Wheel  
Retainer  
Wheel  
CAUTION:  
- Failure to install retainer cap may cause wheels to  
come off of stroller.  
- After wheel assembly is complete, pull on wheels  
to check that they are locked into place.  
Front Wheel Assembly:  
Line up hub cap tabs with slots in wheel and snap hub  
cap into place.  
1 Hold swivel wheel assembly upright  
(tab pointing down).  
WARNING  
Prevent possible choking hazard: discard axle  
protectors and polybag which contained rear wheel  
parts.  
Tab  
2 Tilt stroller slightly back and push  
wheel assembly up onto leg until it  
locks in place.  
Repeat steps 1 & 2 for opposite leg.  
.
CAUTION: After wheel  
assembly is complete, pull on  
wheels to check that they are  
locked into place.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
CAR SEAT/STROLLER USAGE  
To Attach Car Seat Adapter:  
To Attach Car Seat continued  
3 Push in red button on each handle  
hub and rotate handle back until  
it “clicks” and locks just behind  
car seat.  
1 Step down on brake lever to lock  
brakes.  
Red Button  
4 Pull up on both handle hubs to be  
sure car seat is locked in car seat  
adapters.  
2 Release both levers on sides of  
seat back.  
NOTE: Stroller seat back MUST  
be in reclined position to use  
car seat adapter.  
NOTE: Car seat comes with a level indicator which is used  
for vehicle installation only.  
3 With release handle of car seat  
adapter facing away from stroller,  
align both sides of adapter bracket  
with top of stroller handle grip  
buttons.  
WARNING  
Avoid serious injuries from falls. Be sure:  
Harness straps are used to restrain child.  
• Car seat handle is in locked carrying position when  
lifting or carrying child.  
• Car seat is locked into adapter before each use.  
• Stroller is fully set up and locked before using.  
4 Rotate adapter bracket into  
handle grip opening and snap  
into place.  
• Brakes are locked when attaching and removing car  
seat from stroller frame.  
Repeat for opposite side.  
To Remove Car Seat From Stroller:  
Pull on adapter to be sure  
adapter is locked.  
1 Step down on brake lever  
to lock brakes.  
2 Push red buttons on car seat  
handle and rotate handle up  
until it “clicks” into the locked  
carrying position (upright).  
Do not lift car seat from car seat  
adapter until you have checked  
that handle is locked.  
To Attach Car Seat:  
1 Step down on brake lever to lock  
brakes.  
2 With car seat facing stroller handle and  
stroller canopy in closed position,  
place round car seat handle hubs  
into curved slots of car seat  
adapter. Both sides must  
3 Pull release lever and lift car seat out  
of car seat adapter.  
“click” into position.  
Release Lever  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
STROLLER USAGE  
To Attach Napper Bar:  
To Remove Car Seat Adapter:  
(Stroller can be used with or without Napper Bar.)  
1 Align napper bar (flat side down)  
with slots in lower part of handle  
bracket.  
WARNING  
STRANGULATION HAZARD! Remove car seat adapter  
BEFORE using as a stroller seat.  
1 Squeeze tab in adapter bracket  
2 Push napper bar into slots. Pull  
to unlock bracket.  
napper bar to be sure it is locked.  
3 To remove: push buttons on fold lock  
and pull napper bar out  
2 Pull adapter bracket out of handle  
grip opening.  
Seat Back Positions:  
Repeat for opposite side.  
Seat back has two (2) positions:  
- Upright  
- Semi-reclined  
1 For upright position: Lift seat back  
forward until seat back pins hook  
into seat back latches.  
3 Lift car seat adapter away from stroller frame.  
Store car seat adapter for future use.  
CAUTION: Be sure seat back is  
latched onto seat back pins by  
pushing down on seat back.  
2 For Semi-reclined position: Squeeze  
both levers on sides of seat back and  
pull seat back down.  
Canopy Positions:  
1 Canopy has three (3) positions:  
To Secure Child:  
WARNING  
Avoid serious injury from falling or sliding out:  
• Always use seat belt to restrain child, even when  
sleeping.  
Halfway Opened  
(for use with  
car seat)  
Closed  
Fully Opened  
(for use as  
stroller only)  
• To prevent child from standing or sliding out of  
stroller, be sure waist strap is always SNUG and on  
child.  
• Periodically check waist strap to be sure it is snug  
around child’s waist.  
WARNING  
Prevent serious injuries:  
1 Secure child with harness system.  
• Make sure child is clear of any  
moving parts when adjusting  
stroller.  
• Pull waist straps around child’s waist  
and place crotch strap between  
child’s legs.  
• Snap both buckle tongues into  
buckle on crotch strap.  
• Pull on waist straps to be sure they  
are buckled and snug.  
DO NOT place parcels on top of  
canopy.  
2 Adjust length of waist straps by loosening  
or tightening as shown. Double check to  
make sure strap does not slip out of buckle  
tongues.  
5
Buckle Tongue  
Download from Www.Somanuals.com. All Manuals Search And Download.  
SPECIAL INFORMATION  
Folding and Storing continued:  
Folding and Storing:  
1 Step down on brake lever to lock  
IMPORTANT:  
brakes.  
When folding stroller, turn stroller  
front wheels to straddle frame.  
DO NOT allow front wheels to rest  
on frame. Doing so will cause wheels  
to warp and they will not roll correctly.  
2 Remove car seat from stroller  
frame (see page 4).  
NOTE: Car seat adapter may  
remain on stroller when  
folding.  
6 Engage latch on side of stroller to  
retain stroller in folded position.  
3 Place seat back in its most  
reclined position.  
MAINTENANCE  
Cleaning:  
Wipe fabric and frame with damp cloth and mild  
soap. DO NOT USE abrasives, solvents, strong  
detergents, or household cleaners; they can  
weaken plastic.  
4 Release fold locks on each side  
by grasping handle grips and  
pressing on both buttons.  
DO NOT machine wash or dry seat pads that  
NOTE: This can be done with the  
napper bar attached.  
have boards in them.  
Comfort pad is removable and machine washable.  
Machine wash in cold water, machine dry on cool  
setting to prevent shrinkage. DO NOT wash with  
other clothes.  
When replacing comfort pad, make sure harness straps  
are threaded correctly through slots in comfort pad.  
Loop front of comfort pad over leg rest and fasten tabs.  
WARNING  
To avoid serious injury to child, periodically check  
anchoring straps beneath seat pad to ensure they are  
secured to frame.  
5 Continue pushing buttons  
and lift handle to fold stroller.  
Dented Wheels:  
Sometimes wheels become “dented” from shipment or  
normal use. You may try the following procedure for  
repairing the dented wheel before calling our Consumer  
Relations Department.  
Blow warm air from hair dryer over dented area for  
6
1 to 3 minutes.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
REPLACEMENT PARTS  
PARTS LIST  
PRICE  
PART  
A. Front Wheel Assembly  
$ 7.50  
A
2-Preassembled Wheels (11-65X)  
B. Rear Wheel Kit  
4.95  
2.75  
B
1-Wheel, Wheel Retainer Clip & Retainer  
Cap (11-65X)  
C. Hub Cap Set (2) (11-65X)  
C
D. Seat Pad (11-65X)  
13.00  
9.50  
D
F
H
J
E. Comfort Pad (11-65X)  
E
F. Canopy Pad (11-65X)  
6.50  
2.65  
G. Canopy Frame (11-65X)  
G
H. Car Seat Adapter with Brackets (11-65X)  
I. Mesh Basket (11-65X)  
6.95  
7.50  
I
J. Napper Bar (11-652 ONLY)  
4.50  
K. Instructions & Parts Order Form  
NOTE: Prices Subject To Change  
FREE  
K
Add-On Chart  
$5.00 = Canada  
Shipping & Handling Chart  
$ .01 to $5.00  
= $4.00  
7
$ 5.01 to $50.00 = $5.00  
$50.01 to $200.00 = 10% of Order Total  
$200.01 and over = 5% of Order Total  
Download from Www.Somanuals.com. All Manuals Search And Download.  
REPLACEMENT PARTS ORDER FORM  
Please fill out and return this form to address shown on back of page.  
A. Front Wheel Assembly  
$
**IMPORTANT**  
We must have this information to process your  
order. See label on right rear leg of stroller.  
B. Rear Wheel Kit  
C. Hub Cap Set  
$
$
$
$
$
$
$
$
$
Model Number:  
D. Seat Pad  
Manufacturer Date:  
E. Comfort Pad  
F. Canopy Pad  
Charge to credit card  
Card Number:  
Visa  
MasterCard  
G. Canopy Frame  
H. Car Seat Adapter with Brackets  
I. Mesh Basket  
Expiration Date:  
Cardholder’s Name:  
Check Enclosed  
Please make checks payable in U.S. currency to:  
Century Products Company  
J. Napper Bar  
K. Instructions & Parts Form  
F R E E  
SHIP TO:  
Subtotal Amount $  
Shipping & Handling (see chart page 7) $  
Outside USA (see add-on chart page 7) $  
Total Amount of Order $  
Customer Name:  
Street Address:  
City, State, Zip:  
Area Code:  
Telephone Number:  
PM-0624AB 3/98  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
Send order with check, money order, or charge card number,  
in an envelope to:  
Century Products Company  
9600 Valley View Road  
Macedonia, OH 44056-2096  
Attention: Consumer Relations Department  
You put more than your trust in us.™  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Beko Washer Dryer WMP652W User Manual
Bernard Welder N 11 User Manual
Black Box Computer Hardware 1 Port CAT5 USB 20 Extender User Manua User Manual
Blue Sea Systems Marine GPS System PN9112 User Manual
Bontrager Bicycle 283415 User Manual
Braun Electric Shaver EE1055 User Manual
Bravetti Frozen Dessert Maker KP300H User Manual
Bryan Boilers Boiler CLM User Manual
Bryant Heating System 379H User Manual
Canon Camera Lens 0345B002 User Manual