HOW TO USE
HL-EL340RC
RECHARGEABLE HEADLIGHT
1
Lighting (lighting pattern selection)
ENG
The ON/OFF and lighting pattern are selected using a switch.
Pat. and Design Pat. Pending
Switch
Standard continuous lighting time
Copyright© 2011 CATEYE Co., Ltd. EL34RC-110221 066640702
1
↔
↔
Flash
ON
OFF : Long press
Hi
: About 9 hours
Hi
Low : Single press
Low : About 20 hours
Flash : About 80 hours
INTRODUCTION
: Quick double press
* When returning from Flash to ON (Hi or Low), it returns to the ON
mode used previously.
Before using the light, please read this manual and the attached
“NiMh Batteries” thoroughly, and keep them for future reference.
FOR SAFE OPERATION
• Do not place it within children’s reach.
• In preparation for unexpected battery shutoff, we recommend you carry a spare
battery.
• If the light unit or parts become dirty with mud, etc., clean with a soft cloth which
is moistened with mild soap. Never apply paint thinner, benzine or alcohol;
damage will result.
• Mount the light unit more than 10 cm away from the wireless meter. When it is
mounted too close, the transmission may be affected adversely.
• This product has waterproof features that allow you to use it in light rain (ANSI/
NEMA FL1). Do not use it in heavy rain.
1 sec.
(
)
OFF
ON Hi
1 sec.
Double press
Switch
Hi
• Operate the switch after you stop your bicycle.
Flash
Double press
Before Initial Use
The rechargeable battery supplied is charged enough to check the light. Be sure to
install it to the light and charge it before use, according to the instructions “How to
charge.”
Low
Remaining battery capacity
When the switch (indicator) lights up red, the battery is almost shutoff. Charge or
replace the battery as soon as possible.
COMPONENTS
2
How to charge
DANGER!!:
Charge jack cover
• Do not to charge when dry batteries
are installed.
• Be sure to use CatEye rechargeable
battery and battery charger. The battery
charger is indoor use only.
Light unit
H-34N Bracket
Rechargeable
battery x 2
Battery charger (Various forms ac-
cording to the specifications)
• Commercially available rechargeable
batteries should be charged with a
compatible battery charger.
1Open the charge jack cover at the back
of the light unit to connect the battery
charger plug.
HOW TO INSTALL BATTERY
To AC power outlet
In place of rechargeable batteries, AA bat-
teries can be used for this light.
1Slide the cover backward, while
pressing down the dot section on
the top of the unit.
1
2
How to remove batteries
2Plug the battery charger to an AC outlet.
When the switch (indicator) lights up
red, charging starts.
2Replace batteries according to the
marks on the unit, and replace the
cover.
Dot section
* When the switch flashes red, it
CAUTION!:
Battery charger
indicates a charge error. Disconnect
• Do not use a dry battery (primary battery) together with a rechargeable battery.
Do not use a new battery in combination with an old battery.
• Be sure to install batteries in the correct direction.
• Remove and store batteries when you will not use the light for a long period of time.
Otherwise, batteries may leak liquid, which may result in failure.
the plug, and charge again.
3When the switch red light turns off, charging is completed.
Remove the plug, and close the charge jack cover.
Switch (indicator) state
ON : Charging OFF : Charging is completed
Flash : Charge error
Standard charging time
Approx. 8 hours
HOW TO MOUNT
* Charging and lighting times are approximate values, and will vary
by environmental and user conditions.
1Wind the bracket strap around the handlebar, and put
Bracket
the strap through the opening.
Rubber pad
1
2Screw the dial into the bracket to secure it temporarily.
* Insert the light unit to the bracket until it clicks, and
adjust the beam angle. (Refer to “HOW TO MOUNT
THE LIGHT”)
SPARE PARTS
5338827N
H-34N Bracket
5341890
UL : 5341880
UK : 5341881
EC : 5341882
AS : 5341884
CHA-2.2AH-2.4V
Special nickel-hydride
rechargeable battery x 2
(Ni-MH 2.2Ah GP220AAH)
3Securely tighten the dial, and cut off any excess
bracket strap.
* To remove the light unit, pull out it forward while pressing
the button.
* To re-adjust the beam angle, loosen the dial enough
to move the bracket, and securely tighten it after
adjustment.
Strap
SPECIFICATIONS
Light source..........................................Phi-5 white LED x 1
Battery ..................................................AA Ni-MH 2.2Ah (GP220AAH) rechargeable battery x 2, or AA alkaline battery x 2
Battery charger .....................................CHA-2.2AH-2.4V (Only the rechargeable batteries supplied can be used.)
Operating time (Alkaline battery)...........Hi : Approx. 9 hours (Approx. 7 hours), Low : Approx. 20 hours (Approx. 20
hours), Flash : Approx. 80 hours (Approx. 100 hours)
Dial
2
CAUTION!:
Standard charging time.........................Approx. 9 hours
Temperature range................................Charging : 41˚F – 104˚F (5˚C – 40˚C)
Operating : 14˚F – 104˚F (-10˚C – 40˚C)
• Be sure to tighten the dial by hand. When you tighten
it too hard with a tool, the screw thread may be
stripped.
• Check the dial and screw (*1) on the bracket periodi-
cally, and use them without any loosening.
• Round off the cut edge of the bracket strap to prevent
injury.
Recharge/discharge number of times ...About 300 times (until the rated capacity drops to 50%)
Dimensions/weight ...............................4-7/32” x 2-7/64” x 1-59/64” (107 x 53.5 x 49 mm) / 4.87 oz (138 g) (Including
rechargeable batteries supplied)
3
*The specifications and design are subject to change without notice.
LIMITED WARRANTY
2-year Warranty: Light unit / Battery charger (Deterioration of the battery is excluded.)
CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original purchase. If the product fails to
work during normal use, CatEye will repair or replace the defect at no charge. Service must be performed by CatEye or an authorized retailer. To return
the product, pack it carefully and enclose the warranty certificate (proof of purchase) with instruction for repair. Please write or type your name and ad-
dress clearly on the warranty certificate. Insurance, handling and transportation charges to CatEye shall be borne by person desiring service. For UK and
REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.
HOW TO MOUNT THE LIGHT
CO., LTD.
*1
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan
Attn: CATEYE Customer Service Section
Phone : (06)6719-6863
Service & Research Address for USA
CATEYE Service and Research Center
1705 14th St. 115 Boulder, CO 80302
Phone : 303.443.4595
Release button
Fax
: (06)6719-6033
Screw
Toll Free : 800.5CATEYE
Fax
: 303.473.0006
Download from Www.Somanuals.com. All Manuals Search And Download.
|